Casio 1891, 1854, 1852, 1853, 1855 User Manual

1623 1667 1668 1678 1807 1808 1809 1852 1853 1854 1855 1891

GENERAL GUIDE

• The configuration of this watch may differ somewhat from that shown in the illustration.

• Press C to change from mode to mode.

• In any mode, press D to illuminate the display for about two seconds.

• The animated figures perform a variety of different actions, depending on the mode the watch is in.

Timekeeping Mode Alarm Mode

G’MIX(D)-1

Stopwatch Mode

TIMEKEEPING MODE

Date

PM indicator

To set the time and date

1.Hold down A while in the Timekeeping Mode. The seconds digits flash on the

2. Press C to change the selection in the following sequence.

3. While the seconds digits are selected (flashing), press E to reset the seconds to

4.While any other digits (besides seconds), are selected (flashing), press E to in-

• While the day of the week is selected, pressing E advances to the next day, while

• While the 12/24-hour setting is selected, press E to switch between the two for-

5. After you set the time and date, press A to return to the Timekeeping Mode.

• The date can be set within the range of January 1, 1995 to December 31, 2039.

• If you do not operate any button for a few minutes while a selection is flashing, the

Day of the week

Hour

Minutes

display because they are

Seconds Hour Minutes Year

12/24-Hour

Format

“00”. If you press E while the seconds count is in the range of 30 to 59, it is reset to “00” and 1 is added to the minutes. If the seconds count is in the range of 00 to 29, the minutes count is unchanged.

crease the number or B to decrease it. Holding down either button changes the

current selection at high speed. pressing B returns to the previous day. mats.

flashing stops and the watch goes back to the Timekeeping Mode automatically.

• Use E to switch the display between month/date and date/day of the week.

• Press B to play a melody for about 10 seconds.

Seconds

Pressing any key while a melody is play stops the melody. The melody that plays depends on when you press B.

selected

Day of

the week

Date Month

To set the alarm time

1.Hold down A while in the Alarm Mode. The hour digits flash on the display because they are

• At this time the Daily Alarm is switched on automatically.

2.Press C to change the selection in the following sequence.

3.Press E to increase the selected digits and B to decrease them. Holding down either button changes the selection at high speed.

• The format (12-hour and 24-hour) of the alarm time matches the format you select

for normal timekeeping.

• When setting the alarm time using the 12-hour format, take care to set the time

correctly as morning or afternoon.

4.After you set the alarm time, press A to return to the Alarm Mode.

• If you do not operate any button for a few minutes while a selection is flashing, the

flashing stops and the watch goes back to the Alarm Mode automatically.

• If you do not operate any button for a few minutes in the Alarm Mode, the watch

goes back to the Timekeeping Mode automatically.

To switch the Daily Alarm and Hourly Time Signal on and off

Press E while in the Alarm Mode to change the status of the Daily Alarm and Hourly Time Signal in the following sequence.

To test the Alarm

Pressing B sounds the currently selected alarm sound. It takes about 10 seconds for the alarm sound to finish. You can stop it manually by pressing any key.

• Note that if 0 is set as the alarm sound, pressing B randomly selects one of the

melodies. The sound that is randomly selected when the next alarm time is reached will probably be different from the one that sounds when you press B.

selected

Hour Minutes Alarm Sound

Both OFF

ALM : Daily Alarm SIG : Hourly Time Signal

Daily Alarm Hourly Time only Signal only

Both ON

• Pressing D at any time illuminates the display for about two seconds and causes an animated figure to appear. The type of animation that appears depends upon when you press D.

• The backlight of this watch employs an electro-luminescent (EL) light, which loses its illuminating power after very long term use.

• The watch will emit an audible sound whenever the display is illuminated. This is caused by a transistor that vibrates when the EL panel lights up. It does not indicate malfunction of the watch.

ALARM MODE

ABOUT THE BACKLIGHT

Hourly time signal on indicator

• See the MELODY LIST at the back of this manual for the names of melodies.

• When the Daily Alarm is switched on, the alarm sounds for about 20 seconds at the preset time each day. Press any button to stop the alarm after it starts to sound. When the Hourly Time Signal is switched on, the watch beeps every hour on the hour.

Alarm on

Cur-

indicator

rent time

Mode indicator

Hour

Minutes

This watch include three built-in melodies, which you can use in any of the following five settings to sound when an alarm time is reached.

Setting

0. Random play of melodies 1, 2, and 3

1. Melody 1

2. Melody 2

3. Melody 3

4. Beeper

Alarm Sound

STOPWATCH MODE

Hours

Mode indicator

Minutes

Seconds

1/100 seocnds

To record split times

1.Press E to start the stopwatch.

2.Press B to display the timing up to that point. Stopwatch timing continues internally.

3.Press B to clear the split time and to continue time measurement on the display.

• You can repeat steps 2 and 3 as many times as you want.

4.Press E to stop the time measurement.

5.Press B to clear the stopwatch to all zeros.

To time first and second place finishes

1.Press E to start the stopwatch.

2.Press B when the first finisher crosses the line, and record the time.

3.Press E when the seconds finisher corsses the line.

4.Press B to display the finishing time of the second finisher.

5.Press B to clear the stopwatch to all zeros.

The Stopwatch Mode lets you measure elapsed time, split times, and two finishes. The range of the stopwatch is 23 hours, 59 minutes, 59.99 seconds.

• Animated figures appear on the display while the stopwatch is measuring an elapsed time.

• If you do not perform any key operation while in the Stopwatch Mode, the watch automatically returns to the Timekeeping Mode (except when an elapsed time measurement is in progress.

To measure elapsed time

1.Press E to start the stopwatch.

2.Press E to stop the stopwatch.

• You can resume the measurement operation by pressing E again.

3.Press B to clear the stopwatch to all zeros

(0H00’00”00).

MELODY LIST

G’MIX(D)-2

1623

1 TECHNO 2 HAPPY HOUSE 3 JUNGLE

All of these are CASIO original melodies.

1678

1 Best of my love 2 In the night 3 Take your time

1667

1 No woman no cry 2 Get up, stand up 3 I shot the sheriff

1668

1 I love rock’n roll 2 Never 3 The wild one

T-9710138

T-9730266

T-9750085

1809

1 Move over 2 Somebody to love 3 If it makes you happy

T-9750087

1852

1 Beach baby 2 Runaway 3 Sék’ sé bon

T-9790187

1853

1 Young alien types 2 Popyura 3 Kandy pop

T-9790188

1854

1 Look into the past 2 Tombo in 7/4 3 Upa neguinho

T-97A0366

1807

All of these are CASIO original melodies.

HIGHER AND HIGHER

music by GTS

ruling!!

music by BG-999

F AKE YOUR GAME

music by groove treasurers feat.d-secrets!

1808

1 Gimme!Gimme!Gimme! 2 Another moment follows 3 Day after day

1855

1 SOUL Y OUR SMILE 2 PIECES 3 Duck

T -97A0367

1891

1 La isla bonita 2 Bamboleo 3 Tú me amas

T-9790189

T-9750086