Casio 1808, 1807, 1809, 1667, 1678 User Manual

...

1623 1667 1668 1678 1807 1808 1809

G’MIX(C)-1

GENERAL GUIDE

• The configuration of this watch may differ somewhat from that shown in the illustration.

• Press C to change from mode to mode.

• In any mode, press D to illuminate the display for about two seconds.

• The animated figures perform a variety of different actions, depending on the mode the watch is in.

Timekeeping Mode

Alarm Mode Stopwatch Mode

TIMEKEEPING MODE

Date

PM indicator

Hour

Day of the week

Minutes

• Use E to switch the display between month/date and date/day of the week.

• Press B to play a melody for about 10 seconds.

Pressing any key while a melody is play stops the melody. The melody that plays depends on

when you press B.

Seconds

To set the time and date

1.Hold down A while in the Timekeeping Mode. The seconds digits flash on the display because they are selected.

2.Press C to change the selection in the following sequence.

Seconds Hour Minutes Year

12/24-Hour Day of

Format the week

Date Month

3.While the seconds digits are selected (flashing), press E to reset the seconds to “00”. If you press E while the seconds count is in the range of 30 to 59, it is reset to “00” and 1 is added to the minutes. If the seconds count is in the range of 00 to 29, the minutes count is unchanged.

4.While any other digits (besides seconds), are selected (flashing), press E to increase the number or B to decrease it. Holding down either button changes the current selection at high speed.

• While the day of the week is selected, pressing E advances to the next

day, while pressing B returns to the previous day.

• While the 12/24-hour setting is selected, press E to switch between the

two formats.

5.After you set the time and date, press A to return to the Timekeeping

Mode.

• The date can be set within the range of January 1, 1995 to December 31,

2039.

• If you do not operate any button for a few minutes while a selection is flash-

ing, the flashing stops and the watch goes back to the Timekeeping Mode automatically.

ABOUT THE BACKLIGHT

• Pressing D at any time illuminates the display for about two seconds and

causes an animated figure to appear. The type of animation that appears depends upon when you press D.

• The backlight of this watch employs an electro-luminescent (EL) light, which

loses its illuminating power after very long term use.

• The watch will emit an audible sound whenever the display is illuminated.

This is caused by a transistor that vibrates when the EL panel lights up. It does not indicate malfunction of the watch.

Hourly time signal on indicator

Hour

Current time

Minutes

Alarm on indicator

• See the Melody List at the back of this manual for the names of melodies.

• When the Daily Alarm is switched on, the alarm sounds for about 20 sec-

onds at the preset time each day. Press any button to stop the alarm after it starts to sound. When the Hourly Time Signal is switched on, the watch beeps every hour on the hour.

ALARM MODE

This watch include three built-in melodies, which you can use in any of the following five settings to

Mode indicator

sound when an alarm time is reached.

Setting Alarm Sound

0. Random play of melodies 1, 2, and 3

1. Melody 1

2. Melody 2

3. Melody 3

4. Beeper

To set the alarm time

1.Hold down A while in the Alarm Mode. The hour digits flash on the display because they are selected.

• At this time the Daily Alarm is switched on automatically.

2.Press C to change the selection in the following sequence.

Hour Minutes

3.Press E to increase the selected digits and B to decrease them. Holding down either button changes the selection at high speed.

Alarm Sound

• The format (12-hour and 24-hour) of the alarm time matches the format you

select for normal timekeeping.

• When setting the alarm time using the 12-hour format, take care to set the

time correctly as morning or afternoon.

4.After you set the alarm time, press A to return to the Alarm Mode.

• If you do not operate any button for a few minutes while a selection is flash-

ing, the flashing stops and the watch goes back to the Alarm Mode automatically.

• If you do not operate any button for a few minutes in the Alarm Mode, the

watch goes back to the Timekeeping Mode automatically.

To switch the Daily Alarm and Hourly Time Signal on and off

Press E while in the Alarm Mode to change the status of the Daily Alarm and Hourly Time Signal in the following sequence.

Both OFF

Daily Alarm Hourly Time Only Signal only

Both ON

ALM: Daily Alarm SIG: Hourly Time Signal

To test the Alarm

Pressing B sounds the currently selected alarm sound. It takes about 10 seconds for the alarm sound to finish. Y ou can stop it manually by pressing any key.

• Note that if 0 is set as the alarm sound, pressing B randomly selects one of

the melodies. The sound that is randomly selected when the next alarm time is reached will probably be different from the one that sounds when you press B.

STOPWATCH MODE

The Stopwatch Mode lets you measure elapsed

Hours

Minutes

Seconds

1/100 seocnds

Mode indicator

time, split times, and two finishes. The range of the stopwatch is 23 hours, 59 minutes, 59.99 seconds.

• Animated figures appear on the display while the

stopwatch is measuring an elapsed time.

• If you do not perform any key operation while in the Stopwatch Mode, the watch automatically returns to the Timekeeping Mode (except when an elapsed time measurement is in progress).

To measure elapsed time

1.Press E to start the stopwatch.

2.Press E to stop the stopwatch.

• Y ou can resume the measurement operation by pressing E again.

3.Press B to clear the stopwatch to all zeros

(0H00’00”00).

To record split times

1.Press E to start the stopwatch.

2.Press B to display the timing up to that point. Stopwatch timing continues internally.

3.Press B to clear the split time and to continue time measurement on the display.

• You can repeat steps 2 and 3 as many times as you want.

4.Press E to stop the time measurement.

5.Press B to clear the stopwatch to all zeros.

To time first and second place finishes

1.Press E to start the stopwatch.

2.Press B when the first finisher crosses the line, and record the time.

3.Press E when the seconds finisher corsses the line.

4.Press B to display the finishing time of the second finisher.

5.Press B to clear the stopwatch to all zeros.

1623

1 TECHNO 2 HAPPY HOUSE 3 JUNGLE

All of these are CASIO original melodies.

1678

1 Best of my love 2 In the night 3 Take your time

1667

1 No woman no cry 2 Get up, stand up 3 I shot the sheriff

1668

1 I love rock’n roll 2 Never 3 The wild one

G’MIX(C)-2

T-9710138

T-9730266

T-9750085

1807

All of these are CASIO original melodies.

HIGHER AND HIGHER

music by GTS

ruling!!

music by BG-999

FAKE YOUR GAME

music by groove treasurers feat.d-secrets!

1808

1 Gimme!Gimme!Gimme! 2 Another moment follows 3 Day after day

1809

1 Move over 2 Somebody to love 3 If it makes you happy

T-9750086

T-9750087