Casablanca Fan Company KG1R, KG1HB, K104, K4K, K1 User Manual

READ AND SAVE THESE INSTRUCTIONS

INSTRUCTIONS FOR MOUNTING LIGHT FIXTURE KG1N

WARNING: To reduce the possibility of electrical shock, be sure that the power is turned off at its source (fuse or circuit breaker).All electrical components must be installed in accordance with national and local electrical codes. To reduce the risk of fire and electrical shock, use this light fixture only with UL Listed Casablanca ceiling fans indicated as adaptable on the chart included with these instructions.

BEFORE YOU START:

•THIS LIGHT FIXTURE NOT FOR USE ON 3 SPEED PULLCHAIN

FANS. (MODEL NUMBERS ENDING WITH A "D")

•Light fixture to fan compatibility chart located on last page of instructions.

INSTALLATION

SWITCH

HOUSING

CAP

8-32 SCREW

FIG. 1

8-32 SCREW

PORCELAIN WIRE NUT

KEY SLOT

LIGHT

FIXTURE

FIG. 2

GLASS SHADE

FIG. 3

LIGHT

BULB

FIG. 4

1.Remove the cap from fan by removing two brass 8-32 screws and save these screws for attaching light fixture. Removeplasticwirenutsfromswitchhousingwiresandstrip 1/2" insulation from both wires (black and white). This cap and plastic wire nuts will not be reused. See FIG. 1

2.Threadthetwo8-32screwshalfwayintothetwothreaded holes on the switch housing. See FIG. 2

3.While holding light fixture up to the fan, attach the wires from the fan switch housing and the wires from the light fixture together (black-to-black and white-to-white) by twisting the bare ends of the wires together. Then secure the splices by threading on the porcelain wire nuts provided. Test the secureness of each splice by pulling on the wire nut. Check that there is no bare wire showing from the wire nut then cover both connections with electrical tape.

4.Align the two 8-32 screws on the switch housing with the two key slots on the housing cover. Rotate light fixture counter-clockwise, make certain screw heads have rotated to the narrow end of the slot.

Caution: Make sure no wires are pinched between light fixture and switch housing. Tighten the screws to secure light fixture.

5.Insert the glass shade from the top opening.

See FIG. 3

6. Tilt the glass shade upward to the side to install light bulbs. Do not exceed the maximum wattage indicated on the light fixture. Place the glass shade back on the light fixture so that the glass shade will not rattle when the fan is in operation. See FIG. 4

CAUTION: Make sure no wires are pinched between light fixture and switch housing.

9943940 REV.E RD2/96KTL 8A099