Carrier P474-1100REC, TSTATBBREC01 Installation Instructions Manual

Installation Instructions

TSTATCCREC01
TSTATBBREC01
P474-1100REC

NOTE: Read the entire instruction manual befure startir_ the installation

MULTI-STAGE• WIRELESSRECIEVER

Wireless Reciever

Form: ]M TSTAT 10 Canals: Printed in U SA Catalog No 13TS TA36

PREPARATION 2
REMOVE OLD THERMOSTAT 3
MOUNT WALL PLATE & WIRE 4

CONNECTIONS & SWITCHES 5

WiRiNG DIAGRAMS 7
CALABRATION 10

TROUBLESHOOTING 11

CAUTION Follow Installation Instructions carefully,

DISCONNECT POWERTO THEHEATER- _'_
AIRCONDITIONER BEFOREREMOVING

THEOLD THERMOSTATAND INSTALLING
THENEWTHERMOSTAT

WARNING

This receiver is designed to operate @

This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.

0-70 ° C

FCC ID MUH-T10016

Page 1

Proper installation of the receiver wilt be
accomplished by following these step
by step instructions. If you are unsure
about any of these steps, call a qualified

technician for assistance.

Assemble tools as shown below.

x'

L_

Flat Blade Wire cutter 3/16 inch
Screwdriver & Stripper Drill Bit

Make sure your Heater/Air Conditioner
is working properly before beginning

installation of the receiver.

Carefully unpack the receiver.
Save the screws, wall anchors, and

instructions.

Page 2

Turn off the power to the Heating/Air
Conditioning system at the main fuse
panel. Most residential systems have
a separate breaker for disconnecting
power to the furnace.

Remove the cover of the old thermostat.
If it does not come off easily check for

screws.

Loosen the screws holding the thermostat
base or subbase to the wall, and lift away.

Disconnect the wires from the old

thermostat. Tape the ends of the wires
as you disconnect them, and mark them
with the letter of the terminal for easy

reconnecting to the receiver.

Keep the old thermostat for reference
purposes, until your new thermostat is

functioning properly.

Page 3