
Installation Instructions
TSTATCCPS701
TSTATBBPS701
P374-1100
Digital Thermostat
NOTE R_ _e e_ _ f,_ be_o_eS_" 1,19_e m_
© ©
HEAT
COOL
&
HEAT
PUMP
MULTI-STAGE• SEVENDAYPROGRAMMABLE
Form ¢M-TSTAT-I Z C_n_ets: Pnn_ m U S A C,atmlo_t_ 13T_TA38

PREPARATION 2
REMOVE OLD THERMOSTAT 3
WIRE CONNECTIONS 4
WIRING DIAGRAMS 5
CALIBRATION 8
TEST OPERATION 9
TROUBLESHOOTING 10
CAUTION Follow Installation Instructions carefutty.
DISCONNECT POWER TO THE HEATER -
Ak
AIR CONDITIONER BEFOREREMOVING n _, _,
THEOLD THERMOSTATAND INSTALLING
THENEWTHERMOSTAT, WARNING
Replacement Components Division _) Carrier Corporation 4/01
This device complies with Part 15 of the FCC rules.
Operation is subject to the following 2 conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
Page I

Proper installation of the thermostat will be
accomplished by following these step
by step instructions. If you are unsure
about any of these steps, call a qualified
technician for assistance.
Assemble tools
\
Flat Blade Wire cutter
Screwdriver & Stripper
Make sure your Heater/Air Conditioner
is working properly before beginning
installation of the thermostat.
Carefully unpack the thermostat.
Save the screws, bracket, and
instructions.
Turn off the power to the Heating/Air
Conditioning system at the main fuse
panel. Most residential systems have
a separate breaker for disconnecting
power to the furnace.
Page 2

Remove the cover of the old thermostat.
If it does not come off easily check for
screws.
Loosen the screws holding the thermostat
base or subbase to the wall, and lift away.
Disconnect the wires from the old
thermostat. Tape the ends of the wires
as you disconnect them, and mark them
with the letter of the terminal for easy
reconnection to the new thermostat.
Keep the old thermostat for reference
purposes, until your new thermostat is
functioning properly.
Page 3