Carrier TSTATCCPF701, TSTATBBPF701, P374-1100FM Installation Instructions Manual

Installation Instructions

TSTATCCPF701
TSTATBBPF701
P374-1100FM

NOTE: Read the entire instruciton manual before starting the installation.

Digital Thermostat

Am

I2:00

M

72

74

COOL

AUTO

HEAT

70

HEAT
COOL

&

HEAT

PUMP

MULTI-STAGE SEVEN DAY PROGRAMMABLE

Form: IM-TSTAT-08

Cancels: Printed in U.S.A.

Catalog No. 13TS-TA34

Table Of Contents

PREPARATION
REMOVE OLD THERMOSTAT
WIRE CONNECTIONS
WIRING DIAGRAMS
CALIBRATION
TEST OPERATION
TROUBLESHOOTING

CAUTION

Replacement Components Division Carrier Corporation 4/01

This device complies with Part 15 of the FCC rules.
Operation is subject to the following 2 conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.

Follow Installation Instructions carefully.

DISCONNECT POWER TO THE HEATER ­AIR CONDITIONER BEFORE REMOVING
THE OLD THERMOSTAT AND INSTALLING
THE NEW THERMOSTAT.

WARNING

2
3
4
5
8
9

10

Page 1

STEP #1

PREPARATION

Proper installation of the thermostat will be
accomplished by following these step
by step instructions. If you are unsure
about any of these steps, call a qualified
technician for assistance.

Assemble tools & recommended
Junction Box or Wall Bracket.

FLATSTAT

‘Mud rings’ or Remodel boxes will
not fit.

EXTENDS

LESS THAN

3/8” FROM

THE WALL.

Flat Blade
Screwdriver

Wire cutter
& Stripper

Make sure your Heater/Air Conditioner
is working properly before beginning
installation of the thermostat.

Carefully unpack the thermostat.
Save the screws, wall anchors, and
instructions.

Turn off the power to the Heating/Air
Conditioning system at the main fuse
panel. Most residential systems have
a separate breaker for disconnecting
power to the furnace.

.366”

WALL

FlatStat
in Standard
J-Box or
supplied
Wall
Bracket

WALL

Page 2

STEP #2

REMOVE & REPLACE OLD THERMOSTAT

Remove the cover of the old thermostat.
If it does not come off easily check for
screws.

Loosen the screws holding the thermostat
base or subbase to the wall, and lift away.

Disconnect the wires from the old
thermostat. Tape the ends of the wires
as you disconnect them, and mark them
with the letter of the terminal for easy
reconnection to the new thermostat.

Keep the old thermostat for reference
purposes, until your new thermostat is
functioning properly.

Remove the white plastic wire connector from the
rear of the thermostat. Install wires as directed.
Press the wired connector on the back of the
thermostat.

Lift Connector straight up
to remove.

For best operation, install
the thermostat in a junction
box that is free from drafts
that originate inside the wall.

Page 3