Canyon CNR-WT3 User Manual

ENG 1

CANYON Two-Way Radios

Article: CNR-WT3 USER MANUAL v1.0

1. LCD Screen

2. Fitting the batteries

Your Walkie-talkie includes a rechargeable battery pack for each handset.

Step 1 To remove the belt clip

1. It’s easier to fit the battery pack without the belt clip in place.

2. Pull the tab forward (away from the handset) to release the belt clip.
Then lift the belt clip off.

Channel Number

Speaker volume

level

Transmitting a signal

Receiving a signal

Power Low indicator

Red LED Indicator

MENU/Power button

Talk (Push to Talk)

Mic (Microphone)

Call Button

Antenna

LCD Screen

Up/Down buttons

Scan Button

Speaker

ENG 2

Step 2 To fit the batteries

1. Open the locking latch and slide off the battery compartment cover.

2. Insert the rechargeable battery pack as shown.

＊

Make sure the ‘UP’ arrow is showing, and pointing towards the top of the

handset.

3. Replace the cover and close the latch.

Step 3 To replace the belt clip

Slide the belt clip down into the slot until it clicks into place.

＊ IMPORTANT

Read these safety warnings before you charge the batteries.

1. When placing the handset in the charger, use only the rechargeable battery
pack supplied with the walkie-talkie.

2. Don’t try to fit or recharge non-rechargeable batteries.

3. Make sure the battery compartment cover is securely locked in place
when you’re charging the batteries.

4. Dispose of used batteries safely and in a way that will not harm the
environment － never try to burn them or put them anywhere they could get

burnt or punctured.

5. When you’re not going to use your walkie-talkie for a few weeks, take the
battery pack out so it doesn’t leak corrosive substances.

6. When the battery charge level gets low, an alert tone will be heard and the RED
LED indicator will flash once every 15 seconds. When this happens, recharge the
batteries.

7. Don’t leave dead batteries in your handset － they might leak if you do.

2.1 Charging the batteries

If you prefer to wall mount the charger, use the template supplied.

Step 1 Connect the mains power lead to the charger.
Step 2 Plug the mains adapter into a 230 V AC, 50 Hz mains socket, with the

switch on the socket set to OFF.

Step 3 Then switch on at the mains socket.

＊The walkie-talkie must be used with the mains adapter supplied.

Step 4 Place the handsets in the charging cradles.

Lift the belt clip off

Insert your
fingernail
behind the tab

Latch