Canyon CNP-WF514N1 Quick Install Guide

150N Wireless AP Router

Article: CNP-WF514N1 Quick Guide v1.0

Package Contents

1. CNP-WF514N1 Main Unit

2. Power Adapter

3. Documentation CD

Hardware Overview

Power Status

WAN Activity

Status

Wireless LAN

Activity Status

Antenna

LAN Port Status

4. Standing Base

5. Quick Guide

6. Warranty Card

Front View

Rear View

Radio ON/OFF

Reset/WPS

Function

LAN Ports

Power Jack

WAN Port

ENG - 1

Getting Started

Connecting to Device

1. Begin by searching for an appropriate location to setup device. Please

keep in mind to keep device in th e center of working area as the signal
strength and data transfer rate diminishes with distance.

2. It is also recommended to place device at a higher position to ensure
minimum obstacle interference.

3. Make sure that all network devices are powered off, including the
device itself, PCs, switches, cable or DSL modem, and others.

Internet Configuration Wizard

The default network address of the device is set as 192.168.2.1. Please
configure IP address of host PC at 192.168. 2.XXX where XXX is a numb er
between 002 and 254. The subnet mask should b e 255.255.255.0. Please
follow below steps to enter web browser management mode.

1. Start Internet QuickSetup Configuration

4. Connect the modem to WAN

port of the device by one CAT
5 Ethernet cable.

5. Connect PC(s) or other
network enabled device(s)
with LAN ports (1/2/3/4) of
the device by CAT 5 Eth ernet
cables.

6. Connect power adapter to
wall socket and device to
power on the cable or DSL
modem.

7. POWER and WAN indicator
should light up steadily if
connected properly.

ENG - 2

2. Time Zone Setup

3. WAN Type Setup

1. Open a browser (Internet

Explorer browser only)

and type in “192.168.2.1” at
the address bar and press
Enter.

2. Type in “admin” at the User

Name text box and “1234” at
the Password text box.

3. The web management home

page will be displayed.

4. Click on QuickSetup Button

to start Internet connection
setup.

5. Click on Home option on top

of the page to return to this
page at any time during
setup operation.

1. Upon entering QuickSetup

option, please select an
appropriate time zone.

2. Type in Time Server IP

Address if available.

3. Enable Daylight Savings

function if necessary and
input required date
parameters.

4. Click on ? mark next to Time

Zone to display more
information.

5. Click on Next button to

continue Internet
configuration setup.

ENG - 3