Canyon CNA-BTSP01 User Manual

Bluetooth Speaker

Article : CNA-BTSP01x Quick Guide V1.0

Package Contents

‧CNA-BTSP01x Bluetooth speaker
‧Quick guide ‧3.5mm audio cable
‧Rechargeable battery ‧Micro USB charging cable

Hardware Overview

1. Previous; 2. LED indicator; 3. Next; 4. Volume down; 5. Mic; 6. Play/Pause or
incoming call; 7. Volume up; 8. Battery charging LED indicator; 9. USB DC in

10. ON/OFF Switch; 11. Battery cover; 12. AUX input

LED indicator

1. There is an LED light on the top of Bluetooth speaker. The LED indicates the status
of speaker :
‧LED Off – Power Off ‧Blue – Power On
‧Flashing blue – Pairing mode ‧Green – AUX input

2. There is an LED light on the back of Bluetooth speaker. The LED indicates the
status of battery charging :
‧RED –Battery is recharging ‧Green –Battery is full charged

Controlling

‧ Increase volume
‧ Decrease volume
‧ Play / Pause / incoming call answer
‧ Next
‧ Previous

EN - 1

Quick Start

1. Insert battery into the bottom side of the Bluetooth speaker.

2. Turn the power switch to ‘ON’ position and you will hear a beep sound in 3
seconds.

3. After turning the speaker on, the LED indicator should flash every 0.5 seconds,

it’s in “pairing mode.”

4. The speaker is now ready to connect to your Bluetooth enabled device.
Please refer to your Bluetooth enabled device’s instruction manual for pairing

instructions if you are unsure how to do this.

Pairing with Bluetooth enabled devices

1. Make sure the Bluetooth speaker is power on .

2. Perform a device discovery scan for other Bluetooth devices from your device.

3. Select the ‘CNA-BTSP01’ in the list of discovered devices.

4. If the pairing is successful, you will hear a beep sound and the blue LED light

flashes about every 2 seconds.
Note:

In some devices you will need to enter the Bluetooth passcode “0000” when pairing ‧
, or connect to the speaker separately after pairing.

‧If the Bluetooth Speaker does not pair successfully with the Bluetooth device in
3 minutes, the blue led light will flash every 3 seconds
‧If Bluetooth device does not connect to the speaker in 30 minutes, the speaker will
be off automatically.

Others

1. Press for 3-4 seconds into pairing mode, to connect with new Bluetooth
device.

2. Press to answer or end a phone call.

3. Will be disabled when using AUX input

4. Recharge battery by using included USB charge cable.

EN - 2