Canon PRO-100 User Manual

PIXMA PRO-10

series

PIXMA PRO-100

Setup Guide

series

Setup Guide

This guide provides information for setting up a network connection for the printer.

Network Connection

Wireless Connection

Preparation for Connection Connection Using WPS

Wired Connection

Preparation for Connection Cable Connection Printer Setup

Troubleshooting

Network Connection

Wireless Connection

Preparation for Connection

Before Starting Wireless Connection Setup

1. Make sure that the printer is turned on. If the power is on, the POWER lamp (A) will be lit.

Notes on Wireless Connection

Make sure that the computer is connected to the access point (A) (or wireless network router) you want to connect your printer to.

The conﬁ guration, router functions, setup procedures and security settings of the network device vary depending on your

system environment. For details, refer to the manual of your network device or contact its manufacturer. Check if your device supports IEEE802.11n, 802.11g or 802.11b. If your device is set to the "IEEE802.11 n only" mode, WEP or TKIP cannot be used as a security protocol. Change the security protocol for your device to something other than WEP and TKIP or change the setting to something other than "IEEE802.11 n only."

For ofﬁ ce use, consult your network administrator.

Take added care when connecting to a network that is not protected with security measures, as there is a risk of disclosing data such as your personal information to a third party. This printer cannot be used over wireless and wired connections at the same time. An "Ad-hoc connection," which establishes a direct connection to the computer over a wireless connection without an access point, is not supported. Be sure to prepare an access point.

•

+ 4 hidden pages