Canon MULTIPASS F60 User Manual

Unpack the machine and its components.

Check that you have the following:

NOTE

• A printer cable is not included.You must purchase a USB cable (less than 16.4 ft./5 m) to
connect your machine to a computer.

l

Machine

l

Multi-purpose tray

l

Tray cover

l

Printhead

l

Ink tanks

(Black, cyan, magenta, yellow)

l

Paper output tray

l

PCMCIA card adapter

l

Power cord

l

Documentation

(Set-Up Sheet, Basic Guide, Extended
Service Plan, Registration Card)

l

MultiPASS Suite software CD-ROM

Thank you for purchasing the Canon MultiPASS F60.
To get your machine ready for use, please follow the instructions in this Set-Up Sheet
before referring to any other documentation.

READ THIS SHEET FIRSTREAD THIS SHEET FIRST

Set-Up Sheet

Set-Up Sheet

Remove the shipping material from the machine.

1 Place the machine on a flat surface.
2 Remove all shipping tapes from the exterior of the machine.

NOTE

• DO NOT remove the USB label A at this stage.

Assemble the machine.

Top rear view of
attachment slots

2 Hook the center tab on the

paper output tray to the center
opening, then lower the tray.

1 Attach the multi-purpose tray.

USB label A

Load paper.

Place a stack of paper (print side up) in the multi-purpose tray q and adjust the

paper guide A to the width of the stack w.Make sure the stack does not exceed
the paper limit mark B.Then place the tray cover C over the multi-purpose tray.

Connect the power cord.

ON/OFF(1sec.)

PLEASE WAIT

PUT IN CARTRIDGE

Approx. 30 seconds

1 Plug the power cord into

a socket.

2 When you connect

the machine, the
Alarm light blinks,
and the messages
below should
appear in the LCD.

3 If nothing appears in

the LCD, press [ON/OFF
(1 sec.)] to turn on the
machine.

•If you need to turn off the
machine, press [ON/OFF
(1 sec.)] for one second.

BA

q

w

B

BC

A