Canon CP910 User Manual

Installing Your Printer

to Your Network for the First Time

SELPHY CP910

Macintosh OS

1

Installing Your Printer

to Your Network for the First Time

SELPHY CP910

Macintosh OS

Preparing to Connect My Printer to My Network 3

Network Requirements 3
Notes on Wireless Connection 4

Connecting to the Network 5

Installing the Drivers 12

2

Preparing to Connect My Printer
To My Network

Network Requirements

Before connecting the printer to the network, make sure that the configuration of the computer and access point (or router) is

complete, and that the computer is connected to the network.

Supported Wi-Fi Standards

Standards IEEE 802.11b/g

Supported Channels 1 – 11

Transmission Methods DSSS (IEEE 802.11b) and OFDM (IEEE 802.11g)

Security No security, 64- and 128-bit WEP (open system authentication),

WPA-PSK (TKIP), WPA-PSK (AES), WPA2-PSK (TKIP), and
WPA2-PSK (AES)

3

Preparing to Connect My Printer
To My Network

An "Ad-hoc connection," which establishes a direct
connection to the computer over a wireless connection

without using an access point, is not supported.

Notes on Network Connection

• The configuration, router functions, setup procedures and security settings of

the network device vary depending on your system environment. For details,
refer to your device's instruction manual or contact its manufacturer.

• In an office setup, consult your network administrator

• If you connect to a network that is not protected with security measures, there

is a risk of disclosing data such as your personal information to a third party.

• Place the machine and computer on the same network segment.

4