Cannon WESTMINSTER 4466200024-01 User Manual

WESTMINSTER
Use and Installation Instructions
The cooker must be installed in accordance with the regulations in force and only used in a well ventilated space.
Read these instructions prior to using the cooker and retain them for future reference.
Part no.4466200024-01
CONTENTS
CONTENTS PAGE
FOR YOUR SAFETY 4
TIMER OPERATION 6 HOTPLATE 12 GRILL 14 OVEN 15 OVEN COOKING CHART 18 CARE AND CLEANING 20 SOMETHING WRONG WITH YOUR COOKER? 22
INSTALLATION INSTRUCTIONS 25
SERVICE INFORMATION BACK COVER
2
INTRODUCTION
To help you make the best use of your cooker,PLEASE READ THIS BOOKLET CAREFULLY.
Your new cooker is guaranteed and will give lasting service.The guarantee is only applicable if the cooker has been installed in accordance with the Installation Instructions.
The cooker is designed specifically for domestic use and responsibility will not be accepted for use in any other installation.
When first using the cooker ensure that the room is well ventilated (e.g. open a window or use an extractor fan) and that persons who may be sensitive to the odour avoid any fumes.It is suggested that any pets be removed from the room until the smell has ceased. This odour is due to any temporary finish and also any moisture absorbed by the insulation.
Our policy is one of continual improvement in design and development, therefore strict accuracy of illustrations and descriptions cannot be guaranteed.
This appliance conforms to the following EEC Directives:
Gas Appliances 90/396/EEC
Low Voltage Equipment 73/23/EEC 93/68/EEC
Electromagnetic Compatibility 89/336/EEC 92/31/EEC 93/68/EEC
3
FOR YOUR SAFETY
Please read the precautions below before using your cooker.
ALWAYS make sure you understand the controls before using the cooker.
ALWAYS check that all controls on the cooker are turned off after use.
ALWAYS stand back when opening oven door to allow heat to disperse.
ALWAYS use dry,good quality oven gloves when removing items from the
oven.
ALWAYS keep the oven door closed when the cooker is not in use.
ALWAYS place pans centrally over the hotplate burners and position them so
that the handles cannot accidentally be caught or knocked or become heated by other burners.
ALWAYS keep the cooker clean, as a build up of grease or fat from cooking can
cause a fire.
ALWAYS allow the cooker to cool before cleaning.
ALWAYS follow the basic principles of food handling and hygiene to prevent the
possibility of bacterial growth.
ALWAYS turn off the electricity supply before cleaning or replacing the oven
lamp.
ALWAYS refer servicing to CORGI registered appliance service engineers.
4
FOR YOUR SAFETY
NEVER leave children unsupervised where the cooker is installed as all surfaces
will get hot during and after use.
NEVER allow anyone to sit or stand on any part of the cooker.
NEVER store items that children may attempt to reach above the cooker.
NEVER heat up unopened food containers as pressure can build up causing
the container to burst.
NEVER
NEVER fill a deep fat frying pan more than 1/3 full of oil, or use a lid. DO NOT
NEVER place flammable or plastic items on or near the hotplate.
NEVER use proprietary spillage collectors on the hotplate.
NEVER use the cooker as a room heater.
NEVER dry clothes or place other items over or near to the hotplate or grill .
NEVER wear garments with long flowing sleeves whilst cooking.
NOTE: The use of a gas cooking appliance results in the production of heat and moisture in the room in which it is installed.Always ensure that the kitchen is well ventilated; keep natural ventilation holes open or install a mechanical ventilation device (mechanical extractor hood).
In particular when using the grill or more than one hotplate burner,open a window if a mechanical ventilation device is not operating.
store chemicals, food stuffs, pressurised containers in or on the cooker, or in cabinet immediately above or next to the cooker.
LEAVE UNATTENDED WHILE COOKING.
5
TIMER OPERATION
The timer offers you the following features:
1. Time of Day
2. Automatic Cooking
3. Minute Minder
AUTOMATIC COOKING
The oven can be controlled automatically.
GUIDANCE ON AUTOMATIC COOKING
1. Select foods which will take the same time to cook.
2. Set the oven timer so that the food has just finished or is just about to finish cooking on your return to the oven.This will ensure the food has not cooled down and does not require reheating before serving.
3. Food should be as cold as possible when it goes into the oven, ideally straight from the refrigerator. Frozen meat and poultry should be thawed thoroughly before it is put in the oven.
4. We advise that warm food should never be placed in the oven if there is to be a delay period.Stews prepared by frying the meat and vegetables should be cooked as soon as possible.
5. We advise dishes containing left-over cooked poultry or meat,for example Shepherds Pie,should not be cooked automatically if there is to be a delay period.
6. Stews and joints should be cooked by the long slow method,so that the delay period is kept to a minimum.
7. On warm days,to prevent harmful bacterial growth in certain foods (ie poultry, joints,etc) the delayed start should be kept to a minimum.
8. Wine or beer may ferment and cream may curdle during the delay period, so it is best to add these ingredients just before serving.
9. Foods which discolour should be protected by coating in fat or tossing in water to which lemon juice has been added,prior to placing food in the oven.
10. Dishes containing liquid should not be filled too full to prevent boiling over.
11. Food should be well sealed (but not airtight) in a container to prevent the loss of liquid during cooking. Aluminium foil gives a good seal.
12. Ensure food is cooked thoroughly before serving.
6
KNOW YOUR TIMER
CLOCKFACE
The timer incorporates a 24 hour clock.
Ensure the correct time of day is always set,before using your cooker.
SYMBOLS
A ‘bell’symbol will light up when you select a Minute Minder Period and will remain lit for the period set. At the end of the Minute Minder Period,the timer will emit an audible tone and the ‘bell’symbol will disappear.
The ‘cookpot’ symbol will light up either:– – When the timer is in manual mode, or – During the actual Cook Period.
‘AUTO’ will light up:– – When the timer is first turned on it will flash. It will go out when a time of day
is set or when the timer is set to manual. The ‘AUTO’symbol will flash at the end of an Auto Cooking programme to indicate that the programme has finished.
(When the ‘AUTO’symbol is flashing,to return the oven to Manual operation, turn the oven controls off,ensure that the correct time of day is set,and press the “Manual”button – The ‘AUTO’symbol will go out).
TIMER FUNCTION BUTTONS
Minute Minder Button
Here you can set a time period of up to 23 hours 59 minutes,that will count down. When it reaches zero,the timer will emit an audible tone.
For Example: If you set 20 minutes, the audible tone will occur 20 minutes later.
AUTO COOKING PROGRAMME
Cook Period Button
End Time Button
Manual Button
“+” and “–” Buttons
Cook Period is the actual length of time for which,the timer will switch the oven(s) on as part of an “Auto Cooking”programme. (e.g.If you set 2 hours,the food will be cooked for 2 hours).
The time of day at which you want an “Auto Cooking” programme to end For Example: If you set a “Cook Period” for 2 hours, and “End Time” of 11:00.The timer
will switch the oven(s) on at 9:00 and turn the oven(s) off at 11:00.You will hear a audible tone at 11:00, to indicate that the Auto Cooking Programme has finished.
Notes:
- When setting an Auto Cooking programme you will need to set the oven control(s) to the required temperature(s) when you set the timer.
- If an Auto Cooking programme has been set the oven(s) will only operate during the pre-programmed time.
Needs to be pressed to cancel an Auto Cooking programme and return the oven(s) to Manual operation.
Used to adjust the various timer function settings.
.
7
OVEN TIMER OPERATION
SETTING THE TIME OF DAY
Step 1 Make sure all oven controls are turned Off.
Step 2 Check the electricity supply to the cooker is turned on.
Step 3 When switched on the display will show 0.00 and the Auto symbol,
flashing intermittently.
Step 4 Press & hold in both the Cook Period & End Time buttons together.
Step 5 With the Cook Period & End Time buttons still held in,press either the “+”
or “–” buttons to set the correct time of day.
Step 6 Release all the buttons simultaneously.
THE TIME OF DAY IS NOW SET.
To change the time of day repeat Steps 4,5 & 6 above.
Note: You cannot adjust the time of day if the timer has been set for an
Auto Cooking Programme.
SETTING THE MINUTE MINDER
Step 1 Ensure the time of day is set correctly.
Step 2 Press and hold the Minute Minder button.
Step 3 With the Minute Minder button held in, set the required Minute Minder
period using the “+” and “–”buttons. A ‘bell’ symbol will light up.
Release all buttons and the timer display will revert back to the time of day. The ‘bell’ symbol will remain lit to signify that a Minute Minder period has been set.
At the end of the set time an audible tone will be heard,and the ‘bell’ symbol will disappear.
Step 4 To cancel the audible tone press the Minute Minder button.
Note 1 When the Minute Minder has been set, the time remaining can be checked at any
time by simply pressing the Minute Minder button.
Note 2 If necessary the Minute Minder can be cancelled before the tone sounds by
pressing and holding the Minute Minder button and then at the same time pressing the “–” button until 0.00 appears in the display window.
8
OVEN TIMER OPERATION
AUTO COOKING PROGRAMMES
There are two Auto Cooking programmes that can be selected using your timer:– (a) To set the timer to switch the oven(s) On and Off Automatically
(b) To set timer to switch on immediately and OFF automatically after a set cook period.
a) TO SET THE TIMER TO SWITCH THE OVEN(S) ON AND OFF AUTOMATICALLY
This allows you to cook at a specified time for a chosen period before the oven switches off Automatically.
Step 1 Check that the correct time of day is set, if not follow instructions for setting the time of day. Step 2 Place food onto the correct shelf position in the oven and close the oven door(s).
Step 3 Press and hold in the Cook Period button.
The display will read 0.00 with the ‘cookpot’symbol lit.
Step 4 With the Cook Period button still held in,set the required Cook Period
using the “+” and “–” buttons.
Release the buttons and the timer display will revert to the time of day with the ‘Auto’ symbol and ‘cookpot’ symbol lit.
Step 5 Press and hold in the End Time button.
The display will read the earliest possible end time for the Cook Period that you have set above. The ‘Auto’symbol and ‘cookpot’symbol will be lit.
Step 6 With the End Time button still held in,use the “+”and “–”buttons to set
the ‘End Time’(i.e.The time you require the oven to switch off).
Release all the buttons and the timer will revert back to the time of day.
The ‘Auto’symbol will remain lit to signify that an Auto Cooking Programme has been set.The ‘cookpot’ symbol will go out.
Step 7 Turn the oven control(s) to the required temperature, and if necessary
select the appropriate oven function.
At the end of the Automatic Cook Period the Auto Symbol will flash and an intermittent bleeping sound will be heard. The audible tone will continue unless cancelled. The ‘Auto’symbol will continue to flash until the timer is returned to Manual operation (see below).
Step 8 Press the Manual button, the audible tone will be cancelled and the
oven(s) will be returned to Manual.
Step 9 Turn the oven control(s) to the OFF position.
9
OVEN TIMER OPERATION
Note 1 When cooking automatically the Cook Period can be checked at any time by simply
pressing the Cook Period button.
Note 2 When cooking automatically the End Time can be checked at any time by simply
pressing the End Time button.
b) TO SET TIMER TO SWITCH ON IMMEDIATELY AND OFF AUTOMATICALLY AFTER A SET COOK
PERIOD
Step 1 Check that the correct time of day is set, if not follow instructions for setting the time of day. Step 2 Place food onto the correct shelf position in the oven and close the oven door(s). Step 3 Turn the oven control(s) to the required temperature, and if necessary select the appropriate oven
NOTE:The Cookpot symbol disappears
function.
Step 4 Press & hold in the Cook Period button,the display will read 0.00 and the
‘cookpot’symbol will light up.
With the Cook Period button still held in set the required Cook Period using the “+”and “–”buttons.Example:1hr 30 minutes (as shown).
Note: Cook Period is the length of time the food requires to cook.
Step 5 Release all buttons.
The timer display will revert to the time of day with the ‘Auto’ symbol lit & ‘cookpot‘ symbol remaining lit.
At the end of the Cook Period the ‘Auto’ symbol will flash and an intermittent audible tone will be heard. The audible tone will continue until cancelled.The ‘Auto’ symbol will continue to flash until the timer is returned to Manual operation (see below).
10
Step 6 Press the Manual button.The audible tone will be cancelled and the
oven(s) will be returned to Manual.
Step 7 Turn the oven control(s) to the OFFposition.
Loading...
+ 22 hidden pages