Candy FCP616X, FCP435NXE User Manual

USER INSTRUCTIONS

OVENS

NOTICE D'EMPLOI ET D'INSTALLATION

DES FOURS ENCASTRABLES

CANDY HOOVER GROUP S.R.L. • Via Comolli 16, 20861 Brugherio (MB) Italy

EN

FR

02

14

Safety Indications

• During cooking, moisture may condense inside the oven cavity or on the
glass of the door. This is a normal condition. To reduce this effect, wait 10-15
minutes after turning on the power before putting food inside the oven. In
any case, the condensation disappears when the oven reaches the cooking
temperature.

• Cookthe vegetables in acontainer with a lidinsteadof an opentray.

• Avoid leaving food inside the oven after cooking for more than 15/20
minutes.

• WARNING: the appliance and accessible parts become hot during use. Be
carefulnot to touchanyhot parts.

•WARNING: the accessible parts can become hot when the oven is in use.
Childrenmustbekeptatasafedistance.

•WARNING: ensure that the appliance is switched off before replacing the
bulb, to avoid the possibility ofelectric shocks.

•WARNING:before initiating the automatic cleaning cycle:

- Cleanthe oven door;

- Remove large or coarse food residues from the inside of the oven using a
damp sponge.Do not usedetergents;

- Remove allaccessories and thesliding rack kit (wherepresent);

- Donot place teatowels

• In ovens withmeat probe itis necessary, before making the cleaning cycle,
close the hole with the nut provided. Always close the hole with the nut
when themeat probe is notused.

•Children under 8 must be kept at a safe distance from the appliance if not
continuously supervised.

•Children must not play with the appliance. The appliance can be used by
those aged 8 or over and by those with limited physical, sensorial or mental
capacities, without experience or knowledge of the product, only if
supervised orprovidedwith instruction asto the operation ofthe appliance,
in asafewaywith awareness of thepossible risks.

•Cleaning and maintenance should not be carried out by unsupervised
children.

•Do notuse rough or abrasive materials or sharp metal scrapers to clean the
oven door glasses, as they can scratch the surface and cause the glass to
shatter.

•The oven must be switched off before removing the removable parts and,
after cleaning, reassemble them according the instructions.

•Only usethe meat probe recommended for thisoven.

EN 02

•Do notuse a steam cleanerforcleaning operations.

• Connect a plug to the supply cable that is able to bear the voltage, current
and load indicated on the tag and having the earth contact. The socket must
be suitable for the load indicated on the tag and must be having the earth
contact connected and in operation. The earth conductor is yellow-green in
colour. This operation should be carried out by a suitably qualified
professional. In case of incompatibility between the socket and the
appliance plug, ask a qualified electrician to substitute the socket with
another suitable type. The plug and the socket must be conformed to the
current norms of the installation country. Connection to the power source
can also be made by placing an omnipolar breaker between the appliance
and the power source that can bear the maximum connected load and that
is in line with current legislation. The yellow-green earth cable shouldnot be
interrupted by the breaker. The socket or omnipolar breaker used for the
connection should be easily accessiblewhen the applianceis installed.

•The disconnection may be achieved by having the plug accessible or by
incorporating a switch in the fixed wiring in accordance with the wiring
rules.

•If the power cable is damaged, it must be substituted with a cable or
special bundle available from the manufacturer or by contacting the
customer service department.

•The typeof power cable mustbe H05V2V2-F.

•Failure to comply with the above can compromise the safety of the
appliance andinvalidate theguarantee.

•Any excess of spilledmaterialshould be removed before cleaning.

•During the pyrolytic cleaning process, surfaces can heat up more than
usual, children musttherefore bekept ata safe distance.

•The appliance must not be installed behind a decorative door in order to
avoid overheating.

•When you place the shelf inside, make sure that the stop is directed
upwards and inthe back ofthe cavity.
The shelfmust be inserted completely intothe cavity

• WARNING: Do not line the oven walls with aluminum foil or single-use
protection available from stores. Aluminum foil or any other protection, in
direct contact with the hot enamel, risk melting and deteriorating the
enamel ofthe insides.

• WARNING: Never remove theovendoor seal.

• No additional operation/setting is required in order to operate the
appliance at the ratedfrequencies

EN 03

Summary

General Instructions

5

Product Description

7

Use of the Oven

8

Oven Cleaning and Maintenance

11

1.1 Safety indications

1.2 Electrical safety

1.3 Recommendations

1.4 Installation

1.5 Waste management

1.6 Conformity declaration

2.1 Overview

2.2 Accessories

2.3 First use

3.1 Display description

3.2 Setting the correct time

3.3 Cooking modes

4.1 General notes on cleaning

4.2 Maintenance

• Removal of the oven window

• Removal and cleaning of the glass
door

• Changing the bulb

Troubleshooting

13

5.1 F.A.Q.

EN 04

1. General Instructions

We thank you for choosing one of our products. For the
best results with your oven, you should read this
manual carefully and retain it for future reference.
Before installing the oven, take note of the serial
number so that you can give it to customerservice staff
if any repairs are required. Having removed the oven
from itspackaging, check thatit has notbeen damaged
during transportation. If you have doubts, do not use
the oven and refer to a qualified technician for advice.
Keep all of the packaging material (plastic bags,
polystyrene, nails) out of the reach of children. When
the oven is switched on for the first time, strong
smelling smoke candevelop, whichis caused by the glueon the insulation panels surrounding theoven
heating for the first time. This is absolutely normal and, if it occurs, you should wait for the smoke to
dissipate before putting food in the oven. The manufacturer accepts no responsibility in cases where
the instructions contained in thisdocument are notobserved.

NOTE: the oven functions, properties and accessories cited in this manual will vary, depending on the
model you have purchased.

1.1 Safety Indications

Only use the oven for its intended purpose, that is only for the cooking of foods; any other use, for
example as a heat source, is considered improper and therefore dangerous. The manufacturer cannot
be held responsibleforany damage resulting from improper, incorrector unreasonableusage.

The use ofany electrical applianceimplies theobservance ofsome fundamentalrules:

- do notpull onthe powercable to disconnectthe plug fromthe socket;

- do nottouch the appliancewith wetor damphands orfeet;

- in generalthe use ofadaptors,multiple sockets andextension cablesis not recommended;

- in caseof malfunction and/orpoor operation, switch offthe applianceand donot tamper withit.

1.2 Electrical Safety

ENSURE THAT ANELECTRICIAN OR QUALIFIED TECHNICIANMAKES THE ELECTRICAL CONNECTIONS.

The powersupply to which the ovenis connected must conform with the lawsin forcein the country of
installation.The manufacturer accepts noresponsibility for anydamage causedby the failureto observe
these instructions. The oven must be connected toan electrical supply with an earthed wall outlet ora
disconnector with multiple poles, depending on the laws in force in the country of installation. The
electrical supply should be protected with suitable fuses and the cables used must have a transverse
section that canensurecorrect supplyto theoven.

CONNECTION

The ovenis supplied with a powercable thatshould only be connected toan electricalsupply with 220­240 Vac 50 Hz power between the phases or between the phase and neutral. Before the oven is
connectedto theelectrical supply, it isimportantto check:

- power voltage indicated on thegauge;

- the settingof the disconnector.
The groundingwire connectedto the oven's earth terminal must be connected to the earthterminal of

the power supply.

WARNING

Beforeconnecting the ovento thepowersupply,ask aqualified electrician tocheck thecontinuity of the
power supply's earth terminal. The manufacturer accepts no responsibility for any accidents or other
problems caused byfailure to connectthe oven tothe earthterminal orby anearth connection thathas
defectivecontinuity.

EN 05

NOTE: as the oven couldrequire maintenance work,it isadvisable tokeep another wall socket available
so that the oven can be connected to this if it is removed from the space in which it is installed. The
power cable must only be substituted by technical service staff or by technicians with equivalent
qualifications.

1.3 Recommendations

Aftereach useof the oven,a minimumof cleaningwill helpkeepthe oven perfectlyclean.
Do not line the ovenwalls withaluminium foil orsingle-use protection available from stores.Aluminium

foil or any other protection, in direct contact with the hot enamel, risks melting and deteriorating the
enamel of the insides. In order to prevent excessive dirtying of your oven and the resulting strong
smokey smells, we recommend not using the oven at very high temperature. It is better to extend the
cooking time and lower the temperature a little. In addition to the accessories supplied with the oven,
weadvise youonly use dishesand bakingmoulds resistant tovery high temperatures.

1.4 Installation

The manufacturers have noobligationto carrythis out.If theassistance of the manufacturer isrequired
to rectify faults arising from incorrect installation, this assistance is not covered by the guarantee. The
installation instructions for professionally qualified personnel must be followed. Incorrect installation
may cause harm or injury to people, animals or belongings. The manufacturer cannot be held
responsiblefor such harmor injury.

The oven can be located high in a column or under a worktop. Before fixing, you must ensure good
ventilation in the oven space to allow proper circulation of the fresh air required for cooling and
protectingthe internal parts. Makethe openings specifiedon last page according to thetype offitting.

1.5 Waste management and environmental protection

This appliance is labelled in accordance with European Directive 2012/19/EU regarding
electric and electronic appliances (WEEE). The WEEE contain both polluting substances
(that can have a negative effect on the environment) and base elements (that can be
reused). It is importantthat theWEEE undergospecific treatments tocorrectly remove and
dispose of the pollutants and recover all the materials. Individuals can play an important
role in ensuring that the WEEE do not become an environmental problem; it is essential to
followa few basic rules:

- the WEEEshould notbe treatedas domestic waste;

- the WEEE should be taken to dedicated collection areasmanaged by the town council or a registered
company.

In many countries, domestic collections may be available for large WEEEs. When you buy a new
appliance, the old one can be returned tothe vendor whomust accept it free of charge as aone-off, as
long as theappliance isof anequivalent type andhas thesame functionsas thepurchasedappliance.

SAVINGAND RESPECTINGTHE ENVIRONMENT

Where possible,avoid pre-heating theoven and always try to fill it.Open the oven door asinfrequently
as possible, because heat from the cavity disperses every time it is opened. For a significant energy
saving, switch offthe oven between 5 and10 minutes before the planned end ofthe cooking time, and
use the residualheat that theoven continues togenerate.Keep the sealsclean andin order, toavoid any
heat dispersal outside of the cavity. If you have an electric contract with an hourly tariff, the "delayed
cooking" programme makes energy saving more simple, moving the cooking process to start at the
reducedtariff time slot.

1.6 Declaration of compliance

The parts ofthis appliancethat may comeintocontact with foodstuffs comply withthe provisionsof EEC
Directive89/109.

By placing the mark on thisproduct, we are confirming compliance toall relevantEuropeansafety,
health and environmental requirements whichare applicablein legislation forthis product.

EN 06

2. Product Description

2.1 Overview

1

s
e

l

e

c
t

3

2

5

4

6

2.2 Accessories

Drip pan

1

Collects the residues that drip during the cooking
of foods onthe grills.

Metal grill

2

1. Control panel

2. Shelf positions
(lateral wire grid if included)

3. Metal grill

4. Drip pan

5. Fan (behind the steel plate)

6. Oven door

3

Lateral wire grids

Lateralwire grid ifincluded.

Turnspit

4

Holds baking trays and plates.

No pre-heating is required for rotisserie cooking.
Cooking with the door closed. The energy
consumption is 90-95% less than traditional
system. When the oven is in use, any unused
accessories should beremoved from theoven.

•Unscrewthe hooks

•Putthe spitinto the meat

•Fix the meatwith the hooks

•Tightenthe screws

•Insert the spitinto the motorhole

•Demountthe handlebeforeto start cooking.

EN 07

2.3 First Use

PRELIMINARYCLEANING
Clean theoven before using for the firsttime. Wipe over externalsurfaces witha dampsoft cloth. Wash
all accessories and wipe inside the oven with a solution of hot water and washing up liquid. Set the
empty ovento the maximum temperature and leave on for about 1hour, this will removeany lingering
smells of newness.

3. Use of the Oven

3.1 Display description

select

select

1. Minute minder

2. Clock setting

3. Cooking time

4. End of cooking

5. Temperature or clock display

6. LCD display adjustment controls

7. Thermostat selector knob

8. Function selector knob

WARNING!

The first operation to carry out after installation, or after a
power cut,is to set the time of day (a power cut has occured
if the displayis flashing 12:00).
200°-> The temperature LED “°” flashes until the displayed
temperatureis reached.
HOT -> When a programme finishes, if the oven is still hot,
the display shows "HOT", alternating with the time, even if
the knobs arepositioned to OFF.

3.2 Setting the correct time

WARNING: the first operation to carry out after the oven has been
installed or following the interruption of power supply (this is

00:00

select

ATTENTION: Theovenwill onlyoperateproviding the clockis set.

recognizable the display pulsating and showing ) is setting12:00
the correct time.This is achievedas follows.

•Pushthe centralbutton 4 times

•Set time with"-" "+" buttons.

•Releaseall buttons.

8

8

EN 08