Candy CTD 10662-07 User Manual

WASHING MACHINE CTD 10662-07

Code: 31002630

WASHING MACHINE CTD 10662

B1 D V I C4 A

G C1 C2 B2 B3 C3 H p

A PROGRAMME SELECTOR

Use this control to select the desired wash programme. Turn the selector (it can be turned in both directions) so that the programme is opposite the reference indicator (p). The temperature selected will depend on the programme. (See the Programme

B1 SPIN SPEED SELECTOR

DELAY START

WASH TEMPERATURE

C1 PRE-WASH C

AQUAPLUS (SENSITIVE KEY)

EASY IRON (minutes)

C4 DEGREE OF SOILING

G DOOR - PROGRAMME START LIGHT H START/STOP KEY

I KG. DETECTOR LIGHT

D DELAY START LIGHT

Table).

V “DIGITAL” Display

the machine

The display’s indicator system allows you to be constantly informed about the status of

p CONTROL POSITION INDICATOR

SYNTHETICS

Programme table mod CTD 10662

programme programme for

White

COTTONS

Fast coloureds

max.

aprox.

temp.

setting

time

ºC

min.

2h48’ 90º 1000

2h47’ 60º 1000

max.

espin

speed

rpm/min

washing powder load option keys C

max.

load

Kg.

• • • • • •

• •

• • • • •

•

MIXED

DELICATES

SPECIAL

Fast coloureds

Delicates 1h06’ 40º 600 1,5

Woollens

Hand wash

Gentle rinse

Gentle spin 9’ 1000

Empty

Mix&wash (M&W) 1h48’ 40º 800

Fast 14

1h35’ 60º 800

59’ 40º 800

59’ 30º 800

24’ 800

4’

14’ 30º 800

30’ 40º 800

44’ 40º 800

• •

3,5

• • • • •

•

••••

•

• •

•

• •

••••

* Programme also recommended for low-temperature washes (lower than the max. shown). Programme tested in accordance with CENELEC EN 60456 with the maximum Degree of Soiling selected.

Technical data mod. CTD 10662

Heating

Mains

voltage

230V./50Hz. 175 W. 340 W. 30 W. 1950 W. 2150 W. 10 A.

Wash power

rating

Spin power

rating

Pump motor power rating

element

power rating

Max. Power

input

Mains fuse

Amp. rating

IMPORTANT:

- We recommend not using bleach for programs with a prewash cycle.

- Do not use liquid detergent for programs with a prewash cycle and/or timed start.

PREPARING THE WASH CYCLE

1.- Once the washing is loaded, ensure that the drum doors are properly closed..

2.- Add detergent and additives, not exceeding the maximum level indicator.

- detergent for pre-wash I

- detergent for wash programme II

- bleach

- fabric conditioner

SELECTING THE DESIRED PROGRAMMES AND OPTIONS

3.- Turn the programme selector (A) to the desired programme.

4.- Alternatively, if you wish, you can use the key B3 to choose washing temperature.

Water

pressure

0,05-0,8

Mpa

Water

consumption

*prog.

EN60456

58 L. 1,02 Kw.

Energy

consumption

EN60456

•

*prog.

••••

B3 wash temperature When selecting a programme, the recommended wash temperature is automatically indicated, and the corresponding indicator lamp lights up.

It is possible to lower or raise this temperature, by pressing the (B3) button

Note: The temperature must be adjusted before selecting DEGREE OF SOILING.

5.- Press the key or keys for any options desired (C1, C2, C3, C4). .- It is advisable to select the required options before pressing the Programme Start key (H). .- Remember that if the programme has already passed the stage at which an option is activated, that option will not be implemented.

C1 pre-wash

This is useful for heavily soiled washing. This adds a short additional wash before the main wash. The key can be activated only in Cottons, Mixed and Synthetics programmes.

To activate this option, always press the key before pressing the start key (H).

C2 aquaplus (sensitive key)

Thanks to the new SENSOR ACTIVA SYSTEM, by pressing the key it is possible to run a special washing cycle applicable to all programs and types of fabric, caring for their fibres and the delicate skin of the users who use them. Taking on much more water, together with the new combined action of drum rotation cycles and taking on and discharging water allow you to obtain perfectly clean, rinsed clothes. More water is used in the wash to dissolve the detergent completely, ensuring an effective washing action. The water in the rinses has also been increased to eliminate all trace of detergent in the fibres. This function has been specifically studied for people with delicate, sensitive skin, who can suffer irritation or allergy from the slightest detergent residue. It is also advisable to use this function for children's clothes and delicate fabrics in general, especially for washing bathrobes, whose fibres tend to retain detergent. This option is not available for the wool program.

C3 easy iron key This function helps reduce creasing, depending on the programme selected and the type of fabric washed. This works as follows: Mixed,Synthetics

Delicates

a gentle spin. Hand wash, Woollens ,Cotton, and Mix&wash,

Rinses

To complete the wash cycle in the Delicates , Hand wash , Mix&wash, Cotton press the Easy Iron key again: the machine will empty and perform the required spin. To empty machine of water with no spin, cancel the ongoing programme and select the Empty programme

C4 degree of soiling

By selecting this button (active only on COTTON and MIXED FIBRES programmes) there is a choice of 3 levels of wash intensity, depending on how much the fabrics are soiled. Once the programme and wash temperature have been selected the degree of soiling indicator is automatically set to the minimum allowed; pressing the button increases the level and the settings for the cycle duration are also adjusted accordingly. When a programme is selected the relevant indicator will light up to show the minimum possible degree of soiling. Selecting a greater degree of soiling using the special button will cause the corresponding indicator to light up. Note: The degree of soiling can vary automatically, depending on the temperature selected.

14' Express

By selecting this programme, and pressing the C4 button, it is possible to change the duration of the washing time and choose one of the 3 existing rapid programmes (14’- 30’- 44’)

6.- Select spin speed if required (B1) B1 spin speed Once the programme has been selected, the maximum spin speed allowed for that programme appears on the

. Intermediate spins during rinses are eliminated, the final spin is a gentle spin.

. Intermediate spins during rinses are eliminated and the machine stops before the final spin, which is

.The machine stops before the final spin.

. Intermediate spins during rinses are eliminated, the final spin is a gentle spin.

, and Woollens programmes,

display. Pressing the spin button will reduce the speed by 100 rpm each time the button is pressed. The minimum speed allowed is 400 rpm, or it is possible to omit the spin by pressing the spin button repeatedly.

7.- To start the programme, once options have been chosen, press the key H. The washing machine will begin to operate. If you wish to cancel the option you have selected, press the key again. (The pilot light will go off.)

B2 delay start button

This button allows you to pre-programme the wash cycle to delay the start of the cycle for up to 24 hours. To delay the start use the following procedure: Set the required programme. Press the button once to activate it (h00 appears on the display) and then press it again to set a 1 hour delay (h01 appears on the display); the pre-set delay increases by 1 hour each time the button is pressed, until h24 appears on the display, at which point pressing the button again will reset the delay start to zero. Confirm by pressing the “START/PAUSE” button (the light on the display starts to flash). The countdown will begin and when it has finished the programme will start automatically. It is possible to cancel the delay start by taking the following action: Press and hold the button for 5 seconds until the display will show the settings for the programme selected. At this stage it is possible to start the programme previously selected by pressing the “START/PAUSE” button

or to cancel the process by setting the selector to the OFF position and then selecting another programme.

Calculation of programme time – duration of the cycle (V)

When selecting a programme, the duration of the cycle will be automatically displayed, this can vary according to the options selected. In the first 4 minutes of the washing cycle, with the cottons and mixed synthetics programmes, the washing machine calculates the programme times taking in account the amount of clothing placed in the drum (pilot lamp I "kg.detector" lit) During this period the display pilot lamps will spin, displaying every 5 seconds the max. time of the programme times. After the first 4 minutes the duration of the cycle will be displayed, and which will be constantly updated until the end of the programme.

Door Lock Lamp - the light indicating the start of the programme (G)

It lights up after pressing the START key. After having pressed the START/PAUSE key, the lamp will initially flash, then, remaining fixed until the end of the washing. Two (2) minutes having lapsed after the end of the wash, the light will go out to indicate that it is now possible to open the door.

Cancel-change programs

Once you have started a program, and wish to change or cancel it, you should proceed in the following manner,

- Put the program selector in the OFF position. At that instant, you have cancelled the program and can if you wish to do so, select a new one.

- Select the new program.

- Click the key (H) again.

The washing machine will perform the new selected program.

Programme pause

It is possible to momentarily stop the wash programme so that more washing can be added, and to do so, proceed as follows:

- Hold down the (H) key until the option key pilot lamps begin to flash and the time remaining indicator display V lights up.

- When the Door Lock lamp goes out (after approx. 2 minutes), open the door and add the desired washing.

- Correctly close the doors of the drum and the outer cover.

- Press the key H, and the washing machine will continue with the programme.

When the programme has been completed, the message "END" will appear in the indicator display, Wait until the Door Lock lamp (G) goes out (after approx. 2 minutes)

“To remove the washing, set the programme selector to the OFF position”, before opening the

washing-machine lid and the drum doors.

30.04.08/ H-46004680 EN

Introductión

Table of contents

Safety measures 3 Setting up - Installation 5 Guarantee 6 Preparing the wash. Opening/ closing the drum 7 Detergent load 8 Electronically-controlled Variable Load – Kg detector/mode 8 Specific programmes 9 General recommendations 10 Troubleshooting 12 Washing hints 13

Safety measures

2004/108/EC, 2006/95/EC which have been substituted respectively by 89/336/EEC, 73/23/EEC and subsequent modifications thereof.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

ATTENTION: FOR ALL CLEANING AND MAINTENANCE WORK

• Remove the plug.

• Turn off the water inlet tap after each wash.

Read this manual carefully as it offers practical advice to help you get the most from your washing machine.

This «Instruction and Installation Manual» contains everything you need to know about the everyday running of your machine.

Please refer to this manual for installation and maintenance instructions. The manual also contains information about possible working problems, advice about sorting clothes for washing, an explanation of label symbols and hints about how to remove stubborn stains.

1.- CONTROL PANEL 2.- LID 3.- DRUM

4.- DETERGENT DISPENSER

5.- FILTER 6.- WHEEL TROLLEY

page

This appliance meets the European Directives

+ 12 hidden pages