Candy CIV 60 User Manual

CIV60 Reverse Action
User Instructions
GB
05651180 22/6/01 11:46 am Page 1
2
Safety reminders
Installation. This machine should not be installed in a bathroom or shower room. Never install the dryer against curtains and be sure to prevent items from falling or collecting behind the dryer.
Ventilation. Check regularly that the air flowing through the dryer is not restricted:
Check the fluff filter after use, and clean, if necessary.
The venting hose or duct should be checked periodically and any accumulation of fluff removed.
The inlet and outlets should be kept free from obstructions.
If the dryer is used frequently the period between checks should be reduced accordingly.
Dryness. Clothes should be spin dried or thoroughly wrung before they are put into the tumble dryer. Clothes that are dripping wet should NOT be put into the dryer.
Lighters and matches must not be left in pockets and NEVER use flammable liquids near the machine.
Foam plastic, foam rubber and rubber­like material are not suitable for tumble drying. Articles made from these materials MUST NOT be placed in the dryer.
Glass fibre curtains should never be put in this machine. Skin irritation may occur if other garments are contaminated with the glass fibres.
Garments treated with flammable cleaning sprays or liquids such as petrol,
must not be put in this machine.
Lint or fluff must not be allowed to collect on the floor around the outside of the machine.
Cool down period. The drum inside may be very hot. Always allow the dryer to complete the cool down period before removing the laundry.
Faults. Do not continue to use this machine if it appears to be faulty.
After use. Remove the plug from the electricity supply. Always remove the plug before cleaning the appliance.
Supply cord. If the supply cord on this appliance is damaged, it must be replaced by a special cord which is only available from GIAS Service or an authorised Dealer.
GIAS Service. To ensure the continued safe and efficient operation of this appliance we recommend that any servicing or repairs are only carried out by an authorised GIAS service engineer.
05651180 22/6/01 11:46 am Page 2
Installation
3
Before using the tumble dryer for the first time:
please read this instruction book
thoroughly.
remove all items packed inside drum.
wipe the inside of the drum and door
with a damp cloth to remove any dust which may have settled in transit.
IMPORTANT: This dryer must only be used for drying household textiles and garments where a water solution has been used for the cleaning process.
DO NOT tumble dry fabrics treated with dry cleaning fluids.
Electrical requirements
This appliance is fitted with a moulded-on non-rewireable plug (in the UK fitted with a 13 Amp fuse).
The plug should be accessible for disconnection after the appliance has been installed.
WARNING!
ELECTRICITY CAN BE EXTREMELY DANGEROUS. THIS APPLIANCE MUST BE
EARTHED.
IMPORTANT: The wires in the mains lead are coloured in accordance with the following code:
Blue - NEUTRAL Brown - LIVE Green-and-yellow - EARTH
If the supply cord on this appliance is damaged, it must be replaced by a special cord which is only available from GIAS Service or an authorised Dealer.
Contents
Safety reminder 2 Electrical requirements 3 Ventilation requirements 4 Preparing the load 5 Clothes preparation 5 Maximum drying weight 5 Sorting the load 5 Do not tumble dry 5 Energy saving 5
Opening the door 6 Filter 6 Drying guide 7 Controls & indicators 8 Operation 9 Cleaning the dryer 10 Technical specifications 10 Troubleshooting 11
05651180 22/6/01 11:46 am Page 3
Installation
4
Installation and V entilation requirements
IMPORTANT: This dryer must be installed such that the air inlets and outlet are not restricted (fig. 1).
There should be a gap of at least 12mm (0.5 inches) between the sides and rear of the machine and the surrounding walls and cabinets.
To ensure adequate ventilation the space between the bottom of the machine and the floor must not be obstructed.
NEVER install the dryer up against curtains.
Prevent items from falling or collecting behind the dryer as these may obstruct the air inlet and outlet.
A venting hose is supplied with this tumble dryer.
The use of the venting hose to exhaust hot air to the external atmosphere is strongly recommended to ensure maximum drying efficiency. Protect the external outlet from prevailing winds to ensure back-draughts do not reduce the drying performance.
If the dryer is installed under a worktop or built-in, it is essential to use the venting hose to carry the hot moist air away from the dryer otherwise re-circulation of the moist air will prevent the dryer from working efficiently.
The hose may be fitted through a wall or through an open door or window (fig.2). The hose is 95mm (3.75 inches) in diameter and will extend up to 1.8 metres (6 feet).
Venting hoses longer than 1.8 metres (6 feet) are not recommended as the dryer performance will be reduced.
Ensure that the venting hose is not kinked as this will prevent the dryer from working efficiently.
Where it is not practical to fit a venting hose, condensation can be reduced by operating the dryer close to an open window or an extractor fan.
2
1
05651180 22/6/01 11:46 am Page 4
SUPPLY CORD
AIR INLET VENTS
HOT AIR OUTLET
Loading...
+ 8 hidden pages