GH3BL / CH3EYL / GH3ERD
GH3EBL / GH3EWH
Gas Room Heater
INSTRUCTION MANUAL
:
WWW.CAMPOMATIC.COM
Made in China
User’ Manual
Dear Customer:
Thank you for purchasing gas room he ater from us. We believe it is the best heating
system in similar types.
This instruction manual has been c arefully prepared to ensure you will be able to
easily operate, learn more about i t and fully reali ze all its inherent capabilities.
We invite you r comments as well as any issues you may have regarding t his manual
or our products. Once again, let us we lcome you to be the g rowing family of our
company. We look forward to working with you in the future.
Any innovation or mini changes wit hout further notice.
Tec hnic al Data
Operation Instruction
There are 3 control need to be paid attention.
The first is the valve on the cylinder, which will be used t o turn O N and OFF the
gas supply.
The second is the gas control knob with a dial which has 3 po s itions marked on it.
This control knob is located on the top end of the heater (fig 4).
The third is the piezoelectric ign ition button ne xt to the gas control knob(fig 4).
Pressing this button will genera te a spark on the pilot burner thus igniting the gas
to the pilot burner.
Model No. GH3BL,GH3EBL,GH3EYL,GH3EWH,GH3ERD
Gas Heat Input 4.2kW
Power GH3EBL: 220V-240V/ 50Hz. 1320W
Gas Category I3B/P(30) I3+
Gas Type LPG
Butane at (28~30)mbar/ Propane
at 37mbar
Gas Pressure (28~30) mbar (28~30/ 37) mbar
Destination
Countries
LU, NL, DK, FI, SE, CY, CZ, EE, LT, LV,
MT, SK, SI, BG, IS, NO, TR, HR, HU,
RO, IT
BE, FR, IT, LU, LV, IE, GB, GR,
PT, ES, CY, CZ, LT, SK, CH, SI
Pin Code 598 CM292
1
2
Installation
1.Put the cylinder into the gas heater.
2.Install the protection baffle to make sure the cylinder ca nnot move.
3.Connect the pipe to the gas valve with cap (make sure no leakage)
4.Connect another side of the pipe to the regulator with cap (make sure no leakage)
5. Open the gas tap before using the heater and close the gas tap after using.
Lighting heater:
Before connecting the regulator to the gas cylinder. Check whether there is a
rubber washer on the regulator and the washer must be in good condition.
Connect the regulator to the gas cylinder by turning the hand wheel anticlockwise.
Open the gas cylinder by turning the gas cylinder valve anticlockwise. Turn the
gas control knob on the heater to setting (Fig 4).
Press the control knob down and hold in the pressed position push the piezoelectric
ignition(Fig 4) button 2 or 3 times. Each time you strike this piezoelectric ignition
you will hear a clicking sound as well as see a spark on the pilot burner.
Once the pilot has lit, continue holding the gas control knob in the pressed
position for a further 10 to 15 seconds thus activating the flame failure safety device.
1 . Gas Valve
2.Gas Tap
3.Pipe
4.Gas Rcgulator
5.Protection Bafflc
6.Cylinder
3
The pilot and center burner should remain alight.
You may no w adjust the heater setting to Low/Med/High as required.
Turning off the heater:
To turn off the heater, turn the control knob to position I and close the g as
cylinder valve by turning the knob on the cylinder clockwise. Ensure that the
pilot flame the center burner are extinguished.
Testing gas leaks:
When you suspect that the heater is leaking, turn off the gas supp ly and have
the unit inspected by a qualified technician. Do not attempt to locate the source
of leak with a naked flame. Locate it by sound, smell or by applying soapy
water. Any bubbles forming wil l indicate the wh ereabouts of a le ak.
Safety tips:
Do not move the heater while it is in use.
Always face the heater towards the center of the room.
Use it only in a well-ventilated room. Ventilated is vital for the efficient
performance of this heater and for safety of the occupants of the room in which
it is being used. Allow plenty of fresh air in, neve r seal up the doorw ays and
windows.
Prevent young children and elderly people from touching very hot surface.
The normal dress guard only protects against accidental clothing contact.
Do not place clothes or other material on the heater. Keep all flammable materials
at least one meter away from the heater.
Turn off the gas valve and gas supply after its application.
Never use or store solvents and pressure pack can sans near a gas heater-ven if the
heater is turned off.
Never dispose of rubbish such as cigarette butts in a gas fire-this can affect
combustion and produce dangerous pollutants.
Always operate the gas control and cylinder valve from the side or rear of the
heater. Standing in front of the heater exposes you to the risk of burns.
Change LPG cylinder in ample ventilated area and from any ignition source (candle ,
cigarettes and so on):
Recommend to use 50 cm hose for connection, which should be certificated according
to applicable EN-standard.
Regulator should be certificated according to EN 12864 (from rate: max. 1.5kg/h)
4
Loading...