Campomatic DW999ES User Manual

This manual contains sections of Safety Instructions,Operating Instructions, Installation Instructions and Troubleshooting Tips etc. Carefully reading it before using the dishwasher will help you to use and maintain the dishwasher properly.
..................1
ControlPanel........................2
DishwasherFeatures................. 2
WashCycleTable.................... 3
TurningOntheAppliance..............3
WaterSoftener...................... 4
Detergent...........................5
RinseAid......................... 5,6
Howtousethe3in1program..............6
Loading the Dishwasher Rack(14 sets) 7-9
FilteringSystem..................10-11
CaringfortheDishwasher............11
The manufacturer, following a policy of constant development and up-dating of the product, may make modifications without giving prior notice.
AboutElectricityconnection . .. . . .. . . . 12
WaterConnection................... 13
Dimensions........................ 13
Beforecallingforservice.......... 14,15
Faultcodes................. ........15
Under certain conditions, Hydrogen gas may be produced in a hot-water systemthat has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE. If thehot-water system has not been used for such a period, before using the dishwasher turn on all hot-water faucets and let the water flow from each for several minutes. Thiswillrelease any accumulated hydrogen gas. As the gas is flammable, do not smoke or use an open flame during this time.
This appliance must be grounded. In the event
of a malfunction or breakdown, groundingwill
reduce the risk of electric shock by providing a path of least resistance of electric current. This appliance is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances.
Do not abuse, sit on, or stand on the door or dish rack of the dishwasher.
Do not touch the heating element during or immediately after use.
Do not operate your dishwasher unless all
enclosure panels are properly inplace. Open thedoorverycarefullyifthedishwasheris operating, there is a risk of water squirting out.
Do not place any heavy objects of stand on the door when it is open. The appliance could tip forward.
Whenloading itemsto be washed:
1) Locate sharp items so that they are not likely to damage the door seal;
2) Load sharp knives with the handles up to reduce the risk of cut-type injuries.
3 Warning:Knives and other utensils with sharp points
)
must be loaded in the basket with their points down or placed ina horizontal position.
When using your dishwasher, you should prevent plastic item from contacting with heating element.
Check that the detergent receptable is empty after
completion of the wash cycle.
Do not wash plastic items unless they are marked dishwasher safe or the equivalent. For plastic
items n
ot so marked, check the manufacturer's
recommendations.
Use only detergent and rinse additives designed for an automatic dishwasher. Never use soap, laundry detergent, or hand washing detergent in your dishwasher. Keep these products out of the reach of children.
Other means for disconnection from the supply must be incorpratedin the fixed wiringwith at least 3mm contact separation in all poles.
Improper connection of the equipment-
grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative if you are in doubt whether the appliance is properly grounded. Do not modify the plug provided with the appliance; If it is not fit for the outlet. Have a proper outlet installed by a qualified electrician.
Keep children away from detergent and rinse aid, keep
child away from the open door of the dishwasher,
ren
there could still be some detergent left inside.
Young children should be supervised to ensure that
they do not play with the appliance.
The appliance is not intended for use byyoung children or infirm persons without supervision. Dishwasher detergents are strongly alkaline,they
can be extremely dangerous if swallowed.Avoid contact with skin and eyes and keep childrenaway from the dishwasher when the door isopen.
The door should not be left in the open position since this could present a tripping hazards.
If the supply cord is damaged, it must be replaced by the manufactureror its service agent or a similarly qualified person in order to avoid a hazard.
Remove the door to the wash ing compartment when
removing an old dishwasher from service or discarding it.
Please dispose of packing materials properly.
Use the dishwasher only for its intended function.
During installation, the power supply must not be excessively or dangerously bent or flattened.
Do not tamper with controls.
The appliance is to be connected to the water mains using new hose sets and that old hose-setsshould not be reused.
The maximum number of place settings to be washed is 14.
The maximum permissible inlet water pressure is 1Mpa.
The minimum permissible inlet water pressure is 0.04Mpa.
1
(IEC-EN 50242)
For normally soiled loads, such as , plates,glasses and lightly soiled pans. standard daily cycle.
For the heaviest soiled loads, such as pots,pans,casserole dishes and dishes that have been sitting with dried food on them for a while.
For normally soiled loads, such as , plates,glasses and lightly soiled pans. standard daily cycle.
For lightly soiled loads,such as plates,glasses,bowls and lightly soiled pans.
For dishes that needto rinsed and dried only
pots
pots
Pre-wash pre-wash
42℃)
wash( rinse/
(68
rinse drying
Pre-wash pre-wash 50 wash 60 rinse rinse 70 drying
Pre-wash pre-wash wash 47 rinse rinse 67 drying
Pre-wash wash 45 rinse rinse 60 drying
Wash 45 rinse rinse 70 drying
( ℃)
℃)
(℃)
(℃)
℃)
℃)
℃)
℃)
3in1
℃)
5/22g.
5/25 g.
22g.
15 g.
Forlightly soiledloads, such as glasses, crystal and fine china.
Pre-wash of dishes pots and pans whilewaiting for the load to be completedafter the subsequent meal.
Draw out the lower and upper basket, load the dishes and
1
push them back. It is commended that loading the lower basket first, then the upper one.
With a little force to ensure the door is properly closed.
2
NOTE:
perfectly.
Insert the plug into the socket.
3
The power supply is 220-240VAC 50HZ, the specification of the socket is 2 250VAC.1A
Pressthe ON/OFF button
4
According to the soil level to choose the desired program
5
by pressing the program selection button.
Close the door to start the washing.
6
7
When the washing is over, you can shut off the swtich by pressing on/off button..
A click could beheardwhen the door is closed
Pre-wash wash 40
(℃) rinse rinse 70
(℃) drying
Pre-wash
Premise
has only been running for a short time. Otherwise, the detergent may have already been released, and the appliance may have already drainedthe wash water. I this case, the detergent dispenser must be refilled (see the paragraph entitled " Loading the Detergent " ).
When thedishwasher is running, you want to change the using programme, you should do according thefollowing step.
1 2
3
At the end of a wash cycle, the time display will flash for 8 seconds while the buzzer sound. However, when the delay start funtion is activated, the time display will flash for 8 seconds, but the buzzer will notsound.
: A cycle that is underway can only be modified if it
Shut off the power, then turn on the power.
Press the programme button to select the desired programme.
Close the door to start washing.
15 g.
n
3
NOTE:
will delay start for several seconds, which will make the dishwasherwork muchbetter.
If you open thedoor when washing, the machine
There are two ways to reduce the hardness: one way is using water softener, the other is using
water
detergent.
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliances is equippedwith a specialsoftener that uses a salt specifically designed to eliminate lime and minerals from the water.
Always use salt intended for use with dishwashers. The salt container is located beneath the lower rack and should be filled as follows:
Remove the lower basket and then unscrew and removethe cap from the salt
1
container.
Ifyou are filling the containerfor the first time ,fill 2/3 of its volumewith water
2
(around 500ml).
3
Place the end of the funnel(supplied) into the hole and introduce about 1.2kg of salt .Itis normal for asmall amount of water to come out of the salt container
4
Carefully screw the cap back on.
5
Usually, the salt warning light will be off in 2-6 days after the salt container be filled with salt.
1.
The salt container must be refilled when the salt warninglight comes on. Though the salt container is filled
enough, the indicator light may not black out before the salt fully dissolve.
2.
If there are spills of the salt, a soak program could be run to wipe them out.
The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimize and customize the levelof saltconsumption sothat the salt consumption could be set proceedas follows:
Unscrew the cap from the salt container.
1
There is a ring on the container with an arrow on it (see Figure to the side), if
2
necessary, rotate the ring in the anticlockwise direction from the "-" Setting toward the "+" sign, based on the hardness of the waterbeing used.It is recommended that adjustments should be made in accordance with the following schema:
dH
WATERHARDNESS
fH
0~140~8 0~1.4
14~398~22 1.4~3.9
39~8022~45 3.9~8 Mid 40 30
>80>45 >8
Clark
0~10
10~28
28~56
>56
mmol/l
Selector Position
/
-
+
Salt consumption
(gram/cycle)
0/
20 60
60 20
Auto nomy
(cyc les/1.2kgs )
Note:1°dH=1.25°Clark=1.78°fH=0.178mmol/l
°
°
°
°
°
°
°° °
dH : German degree
fH : French degree
Clark: British degree
4
Loading...
+ 11 hidden pages