CH1360 CH1390
Cooker Hood
INSTRUCTION MANUAL
:
Made in China
WWW.CAMPOMATIC.COM
Infor mation and advice
Specifi cations: 220- 240V 50Hz 320W
~
In certain circumstances electrical appliance may be a danger
hazard.
A) There shall be adequate ventilation of the room when the
cooker hood is used at the same time as appliances
burning gas or other fuels.
B)Do not check the status of the filters while the cooker hood
is operating.
C)Do not touch the light bulb within half an hour after appliance
use.
D)Do not flambe under the cooker hood.
E)Avoid opening gasometer when there is no pan on the stove ,
as it is damaging for the filters and a fire hazard
F)Constantly check food frying to avoid that the overheated
oil may become a fire hazard.
G) Disconnect the electrical plug prior to any maintenance.
) H If the supply cord is damaged, it must be replaced by the
manufacturer,its service agent or similarly qualified
persons in order to avoid a hazard.
Know your cooker hood
Please read these instructions before using your cooker hood
1.Air duct assembly 2.Main body
3.Filter assembly
Also included:
*Damper flap
*User instructions
Information
Congratulations on the
purchase of our Cooker hood,
which is designed to include
many superior features that
permit you the fullest expression
of your living.
Before installing and/or using
the cooker hood carefully read
all the instructions.
Sel ection of Ve n ting Direct ion
Fully convertible for vertical, horizontal or ductless operation.
s
Duc
tle s
Information
The air must no t
C
V
e
d
r i
is h
al
c
t
a g
c r e
be discharg ed into
a flue that is us ed
for exhaust ing
fumes from
appliance s
A
burning gas or
other fuels .
Regulatio ns
B
concernin g the
discharge o f air
have to be
Hori zo ntal
disc ha rge
fulfilled .
1
A
A
B
B
2
3
Vertical dis charge
Vertical is the most common.
If you select this venting direction, you only need
to open the ducting knockout A.Remove the
ducting knockout by inserting a Flat head
screwdriver under one end and prying it up. Then
snip or break the attanchment points by tin snips.
You must make sure that the ducting knockout B is
not removed.
Horizontal discharge
Assuming that the range hood is located against an
outside wall, horizontal discharge is preferred
provided that there are no obstructions such as, wall
joists, or where openings are difficult to make.
If you select this venting direction, you only need to
open the ducting knockout B.
Same with removing the ducting knockout A, you must
make sure that the ducting knockout A is not removed.
We recommend that after
installat ion the bottom of
the hood shou ld be no less
than 650mm an d no more
than 750mm ab ove the
stove's hea ting elements
and burners .
We recommend that after
installat ion the bottom of
the hood shou ld be no less
than 650mm an d no more
than 750mm ab ove the
stove's hea ting elements
and burners .
Information
Sufficien t air
is needed for
proper
combustio n
and
exhaustin g
of gases
through the
flue
(chimney) o f
fuel burnin g
equipment to
prevent bac k
drafting.
C
Du
ctl e
s
s
Ductless
In a ductless i nstallation the air is re-circulated
back into the k itchen. If you do n ot anticipate
heavy cooki ng this method will be preferred.
4
Kno b
It will not be ne cessary to remo ve any duct
knockouts , you only need chose knockout C. You
should use fi lters to help remove cooking odors.
These filte r must be washed an d replaced at
regular int ervals.
After selec ting venting di rection and completing
installat ion, you can turn the knob to achieve
ductless or d uct.Open the fi lter, then you can see
the knob.
Information
Ductless
fans must
always be
vented to
the
outdoors.
5
The knob arro whead as per FIG. 7 , then it is duct.
The knob arro whead as per FIG. 6 , then it is
ductless.
6 7
Installation
Ensure th e power has be en turn ed off be fore begin ning th is install ation.
To install this h ood you will require two
assistant s.
≥650m m
8
You will need the fo llowing tools a nd
material to c omplete this in stallation:
*Drill*Flat h ead screwdriv er*Phillips
head screwd river or cordless drill and
Phillips he ad bit* Tin snips*3/8″nut driver
or ratchet wi th extension* measuring
tape*hand saw or jig saw*electrical
tape*duct tape
1. Remove the r ange hood from th e carton.
2. Lay the hood u pside down on a table
covered wit h cardboard or paper to prevent
scratchin g of the table or hoo d.
3. Hood insta llation should be within 0.8m
radius rang e.
4. We recommend that after installation the
bottom of the h ood should be no less than
650mm and no mo re than 750mm above
the stove's h eating elements and burners.
Information
Installat ion
work and
electrica l
wiring must
be done by
qualified
person(s) i n
accordanc e
with all
applicable
codes and
standards ,
including f irerated
construct ion.
Secu ri ty
hole
Key ho le
9
2. Hang the hoo d and let it's 4
key holes aim a t screws, the 4
screws shou ld be in the narrow
parts of key ho les. Screws
should be fas ten firmly, make
sure that the i nstallation
between the h ood and cabinet is
enough fast en.
1. According to the figure, make sure
the position of hood in the cabinet.
The wood strips should be line up with
the 4 keyholes slots on the top of the
range hood. On the cabinet, install 4
screws (supplied) according to the
relative position of 4 key holes on the
bottom of hood. The extent of
screwing should be convenience to
the next installation.
3. Install sc rews in the secur ity
holes, in cas e of front and back
moving of hoo d, so that the usin g is
safer.
Information
When
cutting or
drilling
into wall
or ceiling,
do not
damage
electrica l
wiring or
other
hidden
utilities .
Secu ri ty
hole
If the installation surface in cabinet don't adapt to install the cooker hood,
then as per FIG. 5, fix the position of cooker hood on the wall. On the wall,
install 2 screws (supplied) according to the relative position of 2 key holes
on the back of hood. The extent of screwing should be convenience to the
next installation. Also install screws in the security holes, in case of front
and back moving of hood, so that the using is safer.
10
Information
The cooker ho od
must not be
installed a nd
connected t o
flues where o ther
appliances are
installed a nd
which run off
other energ y
supplied
different t o
electrici ty (water
heaters boi ler
cookers
(range/ag as)
etc.).
Mode l 1:
0
Mode l 2:
Hood Using Method
Turn the hood ON when cooking at high heat or when cooking flaming foods.
1. Adjust the kn ob to be right posi tion.
2. Insert the po wer plug firmly.
11
1
2
3
12
Press the the switch of light to be on, the bulbs
light on. Otherwise the bulbs don't work. When
press the push button “1”or “ ”: on, the motor
runs at low speed. When press the push button
“2” or “ ” on, the motor runs at middle speed.
When press the push button “3” or “ ” on, the
motor runs at high speed. When press the push
button “0” or “ ” on, the motor stops running.
Information
Clean
ventila ting
fans
frequen tly.
Grease
should no t
be allowe d
to
accumul ate
on fan or
filter.
E14 4 0W x 2max
13
Replacing B ulb: Removing the bulb that need
to be replace d, then reinstall the new bulb. The
power of bulb m ust not be more than 40W.
Cleaning Instructions
Disconnec t range hood from power supply before cleaning or servicing.
1. Cleaning th e surface of hood frequently. Use mild soap or
detergent t o clean the hood.
2. Do not use hars h alkalis or abrasives.
3. Avoid the use of scouring powers or dishwasher
compounds.
4. Grease filt er may be washed us ing mild soap or detergent.
(heavy grea se build-up may not be cleaned easily and the
filter may re quire replacement)
5. Charcoal fi lters cannot be cleaned and must be replaced
regularly.
Information
When
cleaning,
water must
not inter
into motor,
control
switch etc.
electrica l
parts.
·It is recom mendable to cle a n t he metallic fi l ter every three
mon ths by c arrying out the fo l lowing inst ructions:
- Re m ov e the m e t al l i c filter f ro m the c o o ke r hood a nd wash i t
in a soluti o n of w a t er and n e u tr a l liqui d deter g e n t, leavin g to
soak
- Ri n se thorou g h l y with w a r m water a n d leav e to d r y.
- Th e meta l l i c filter m ay also b e wash e d in t h e dish w a s he r.
The m e t al l i c filter m ay alter i n col o r after several washes .
This i s not c au s e for c us t o me r compl a i n t nor re p l ac e m e nt of
metal l i c filt e r.
14
Information
There is a
fire risk if
cleaning is
not carried
out in
accordance
with the
instructions.
Corr ect Disposal of this product
This markin g indicates tha t this product sh ould not be disposed with
other house hold wastes throughout the EU. To prevent pos sible harm to
the environ ment or human health from uncontrolled waste disposal,
recycle it re sponsibly to pr omote the sustainable reuse of material
resources . To return your used device, please use the return and
collectio n systems or cont act the retailer where the product was
purchased . They can take this product for environmental safe recycling.
The manufacturer shall decline all responsibility if the foregoing
recommendations and instruction regarding installation, maintenance and use are
not observed and respected when using the cooker hood.
Loading...