CD907I
Tumble Dryer
220- 230V~ 50Hz, 2500 W
INSTRUCTION MANUAL
Cauon: Read and follow all safety and operang instrucon before rst use of this product.
Campomac S.R.L. Via Congliachi 5/B . 35031, Abano Terme (Padova), ITALIA
WWW.CAMPOMATIC.COM
CD907I
Read and understand thoroughly this safety instructions
before use.The items indicated here are very important safety
precautions,which must be followed.Any failure and losses
caused by ignoring the above mentioned items and cautions
mentioned in the operation and installation instruction are not
covered by our warranty and any liability .
The appliance can be used by children aged from 8 years and above and persons
with reduced physical,sensory or mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved.Children shall not paly with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
2
CD907I
3
CD907I
4
CD907I
The lint trap has to be cleaned frequently.
Adequate ventilation has to be provided to avoid the back flow of gases into the room from
appliances burning other fuels, including open fires.
Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol,
kerosene, spot removers, turpentine, waxes and wax removers should be washed in hot water
with an extra amount of detergent before being dried in the tumble dryer.
Remove all objects from pockets such as lighters and matches.
Oil-affected items can ignite spontaneously, especially when exposed to heat sources such
as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil.
Oxidation creates heat. If the heat cannot escape, the items can become hot enough to catch
fire. Piling, tacking or storing oil affected items can prevent heat from escaping and so create
a fire hazard.
If it is unavoidable that fabrics that contain vegetable or cooking oil or have been contaminated
by hair care products be placed in a tumble dryer they should first be washed in hot water with
extra detergent - this will reduce, but not eliminate, the hazard.
5
CD907I
6
CD907I
1.Power 3.Child Lock
2.Start/Pause 4.Buzzer
5.Indicator Lights 6.Indicator Lights
Drying Filter
Cooling Overflow
End Child Lock
7.Programme selector dial
123457 6
7
CD907I
Ensure that the electrical connections comply with the installation instructions.
Remove the polystryrene block and any material from the drum.
Before using your tumble dryer for the first time,we recommend that you place a few damp cloths
inside the appliance and dry for 30 minutes.There may be dust inside a brand new tumble dryer.
Turn the programme selector dial to the required
programme.The Start/Pause light starts to flash.
The programme will be switched off if you have
not pressed any button for 10 minutes.
Note:
The “Standard cotton programme” is suitable to dry normal wet cotton laundry and it is the most
efficient programme in terms of energy consumption for drying wet cotton laundry.
8
CD907I
.
compete
d
n
You can choose different programme base on your different clothes materials. The
device has the function with sensor the moisture in order to automatically adjust the
drying time for optimal drying. This drying system is fit for cottons, synthetics sections and
Anti-Bacterial, silk programme.
Select the 90 or 60 minute programme for cottons or the 30 minute programme for synthetics
To stop a programme, press the switch button. Please take out the clothes after the
drying process and then press the button to turn off the machine.Power
Depending on the programme,different functions can be combined.These must be selecte
after choosing the desired programme and before depressing the Start/Pause button.Whe
these buttons are pressed,the corresponding pilot lights come on.When they are pressed
again,the pilot lights go out.
After turning on the appliance,the buzzer is off if you do none operation.The buzzer
can be turned on or be turned off during the process.By pressing “Buzzer” button,the
buzzer goes off and the corresponding pilot light comes on.When the buzzer is on,
the signal will sound in the following cases:
When depressing any button.
Open the door during operation.
Take out the condenser during operation.
When the water container is full.
At the end of program after cooling phase.
Select the Start/Pause
Press this button to start the dryer after having selected the programme and
the options. If the door of the appliance is opened while the programme is
runing,this button must be pressed again after closing the door in order to
restart the programme from the point at which it was interrupted.In this cases
the light of the Start/Pause button flashes to remind you that the start button
needs to be pressed again.
9
CD907I
After each use
Clean the filter.
Important
If the drying programme has to be stopped before it reaches the end,we recommend that you
turn the programme selector dial to position “Air Dry” and wait until the end of this cooling phase
before removing the laundry. This will avoid a build-up of heat inside the appliance. To do this first turn
the on-off switch and then turn to “Air Dry” and press the “Start” button.
Modifying the programm
Turn off the machine to restart a programme.
A t th e e n d o f t he p rogra mm e
All drying programs end with 10 minutes cooling phase.If the laundry is not removed at the end
of the cycle, the dryer performs an anti-creasing phase(duration:30 minutes maximum).If you do
not remove the laundry ,the machine will remain in the standby status,after the anti-creasing phase
The display shows " End" and the buzzer sounds for 15 seconds if you have selected the buzzer.Press the
Select the Power
Press the Power button to turn on the machine.
Indicator Lights
This light indicated the appliance is in the drying phase.
“Drying Light”
“Cooling Light”
This light indicates that the appliance is in the cooling phase. At the end of drying, there is a
10 minutes cooling phase to cool the laundry.
“End Light”
This light is on during the anti-creasing phase after the cooling phase.
“Overflow Light”
It comes on when the water container is full, which remind you to empty the water container.
Note! Empty the water container after each load to avoid the alarm when use in next time.
“Filter Light”
It comes on after each load to remind you to clean the filter. If not clean the filter, the machine
perform well for the next use, but the drying efficiency will be influenced if not clean the filter for
many times.
“Child Lock Light”
This light indicated the appliance is locked.
“Child Lock”Functions
When the machine is on,press meantime “Start/Pause”and“Buzzer” button for several seconds,
the system will lock all the buttons.Then,all buttons are invalid.If you want to make the
appliance to return to the normal state,then press“Start/Pause”and “Buzzer” button and button
for several seconds meantime again.
The function will be released in the following cases:
Open the door during operation
Take out condenser during operation
Water tank full
You can set again the “Child Lock” function when you restart the machine.
10
CD907I
.
A t th e e n d o f t he p rogr am m e
All drying programs end with 10 minutes cooling phase.If the laundry is not removed at the end
of the cycle, the dryer performs an anti-creasing phase(duration:30 minutes maximum).If you do
not remove the laundry ,the machine will remain in the standby status,after the anti-creasing phase
The display shows " End" and the buzzer sounds for 15 seconds if you have selected the buzzer.Press the
, all the signal light will close.Power
After each use
Clean the filter.
Important
If the drying programme has to be stopped before it reaches the end,we recommend that you
turn the programme selector dial to position “Air Dry” and wait until the end of this cooling phase
before removing the laundry. This will avoid a build-up of heat inside the appliance. To do this first turn
the on-off switch and then turn to “Air Dry” and press the “Start” button.
Modifying the programm
Turn off the machine to restart a programme.
11
CD907I
12
CD907I
recommended loads are not too tightly packed;
13
CD907I
Heavy
Strong
Standard
cotton
Damp
Iron
Extra
Cupboard
Iron
30’,60’,90’
9
9
9
9
9
9
Jeans,work clothes and so on.
Jeans,work clothes and so on.
Drying thick or multi-layered textiles,
e.g.terry towelling items.For drying individual
items of laundry or for small volumes.
Anti-Bacterial
Silk
Freshen-up
Delicate
Air Dry
Kind Notice:for drying bathrobe and toweling towel,the max load don’t exceed 6kg.
9
Pressing this button allows drying to be
performed at a lower temperature.
14
CD907I
15
CD907I
Condenser is one of the very important assembly to realize effective drying,therefore need
special attenton.Suggest you clean the condenser three or four times every year.
(Notice:when the condenser is not assembled in proper position,the alarm will ring).
1.Open condenser cover 2.Move two pieces of lock rod,pull out the condenser
3.Put the condenser under the tap to make water through completely by clean condenser.
4.Install the condenser with the reverse direction.
16
Humidity sensor
In the movement process,this device is used for induction clothing humidity,it means
that it must be carried on cleaning.Major cause of clean is must scour out the calcium
oxide boiler which on the sensor surface up.Clean the sensor in the tumble(See picture).
CD907I
Lamp replace (option)
1.Open the door,put your hand into the drum of the dryer,use screw driver unscrew
two pieces of screw,and take out the lamp cover.
2.Remove the lamp by turning counter clockwise.Be carefully,do not let the lamp fall off.
Then install the new lamp and lamp cover with the reverse direction.
17
CD907I
Use Process
Drum light does
not work( option)
18
CD907I
9.0
220-230/50
2500
40.5
CD907I
Power(left-on mode)(W)
Power(off mode)(W)
Energy consuption at full load(kWh)
Programme time at full load(min)
0.68
0
4.79
157.7
595X630X850
drainpipe
manual
19
CD907I
The hot air emitted by the tumble dryer can reach temperature of up to 60°C.The appliance
must therefore not be installed on floors which are not resistant to high temperatures.
It’s not necessary to discharge the condensed water to the tank,it can be drained out directly.
Change drainpipe
Pull out the water pipe by means of the arrow direction ,Then install the drainpipe.
Such as the pilers can be used if it is difficult to do.
R emoving trans port s afety pac kaging foam
Caution !
Before use the machine,the packaging foam must be removed from the drum.
1.Open the loading door.
2.Remove the two packaging foam from the drum.
two packaging foam
ppliance will not
shake.
20
CD907I
The hot air emitted by the tumble dryer can reach temperature of up to 60°C.The appliance
must therefore not be installed on floors which are not resistant to high temperatures.
21
CD907I
Environment concerns
Appendix
To save energy and to help protect the environment,we recommend that you follow these hints:
Try to load the maximum capacity of the machine as small loads are uneconomical.
Do not over-dry laundry,this avoids creasing and saves energy.
Select the drying programme according to the type of laundry and the required degree of dryness.
Clean the filters regularly to avoid excessive drying times and high electricity consumption.
Ventilate the room well.
22
CD907I
Electric diagram
Heater
Temperature
sensor
Thermal
cut-out
Pump
optional
lamp
Door switch
M
~
Capacitance
CN3
CN1
RY3
RY2
CN6
CN5
Appendix
Earth
Guide sensor
Temperature
sensor
Condenser
switch
Float switch
CN2
E
L
N
CN4
P2
Operation
panel
23
Loading...