Cambridge Soundworks S200, S300 User Manual
S300 and S200 MultiPole Surround Speakers
User Manual
®
™
™
2
3
INTRODUCTION
Thanks for choosing a Newton Series surround
loudspeaker. The S200 and S300 both feature the
finest drivers, precision internal crossover circuitry
and an elegant enclosure design.
The Product Development Team at Cambridge
SoundWorks believes there is no better combination of
audiophile-level attention to detail and reasonable cost.
AFTER UNPACKING
Store the shipping carton and packing material for
future use and transport.
CONTENTS
S300 and S200
1. Two loudspeakers
2. Two No. 10 screws and plastic wall anchors
3. Eight rubber feet
INSPECTING FOR DAMAGE
Examine the speaker system carefully for shipping
damage. If there is any, do not install or use the sys-
tem. Return the speaker to the store where you made
the purchase or call Cambridge SoundWorks at 1-800
FOR-HIFI (1-800-367-4434) for assistance.
4
POSITIONING YOUR SPEAKERS
The following suggestions assume you have some
flexibility regarding where you place your speakers.
Don’t be too concerned if your situation and listening
environment dictate the speakers’ position. As long
as each surround speaker is on the left or right half
of the listening space, the speakers are will provide
convincing, lifelike sound.
Mounting: The typical way to position surround speak-
ers is to wall-mount them on a protruding screwhead.
Other methods are to place them on short shelves, to
mount them on short swivel brackets, or to install them
on floor stands.
Notice: The speakers are marked LEFT and RIGHT.
Most often, the speakers will be wall-mounted with the
MultiPole switch panel facing down. In this case,
mount the LEFT speaker on the listener’s left side and
the RIGHT speaker on the listener’s right side (see
diagram A).
You may need to invert the speakers to provide
access to the MultiPole switch (such as when placing
them on small support shelves or floor stands). In this
case, reverse the speakers’ left/right positions (see
diagram B).
Front to Back placement: Place each surround speak-
er to the left or right of the listening area. Try to
position the speakers within two feet of a line centered
on your listening postion (see diagram C).
Height: Place each speaker at least four feet above
the floor, up to seven feet above the floor (see
diagram D).
Note: It is not critical that the left and right speakers
be the same distance from the front speakers or
equal heights.
If you don’t have walls on both sides of your listening
area, try to avoid placing both surround speakers on
a wall behind the listening postion. Sonically, it’s still
better to place one speaker on a side wall and one
speaker on a rear wall. This provides better separation
than two speakers on a wall behind the listeners.
00000000
RIGHT
Newton, Massachusetts
USA
+
—
8 Ohms
S200
Multipole“
Surround
Loudspeaker
SPEAKERS ARE LABELED "LEFT" OR "RIGHT"
2 FEET
2 FEET
CENTER LINE OF LISTENING POSITION
WALL MOUNTED - SWITCH FACING DOWNWARD
RIGHT SPEAKER LEFT SPEAKER
7 Ft.
4 Ft.
Back of Speaker
Front to Back Placement
of Surround Speakers
Stand Mounted
Switch Facing Upward
Wall Mounted Height Placement
A.
B.
C.
D.
Loading...