Cambridge Soundworks PlayDock XM User Manual

Battery Service Life

Recharge the PlayDock overnight whenever possible--even if the battery

has only been used for a few hours.

storage is necessary:

* Be su

re the PlayDock battery has charged for at least 8 hours. * Put the POWER * Recharge The

PlayDockXM automatically shuts down to protect a battery with low-charge. If operation, do activation cycles. Recharge the PlayDockXM battery as soon as possible, preferably within 24 hours. Attempting to operate the PlayDockXM after low-battery shutdown may

switch in the “out” position

the battery at a minimum of six month intervals.

the PlayDockXM does not turn on in portable

not defeat this protection feature with repeated

permanently reduce the life of the battery.

Remove screws on side for battery access.

Signal Plug

PlayDockXM

for Delphi Roady® and Roady2® XM satellite radio receivers

Power Plug

™

Introduction

Thank you for purchasing the Cambridge SoundWorks PlayDockXM. The PlayDockXM is designed for use with Delphi Roady

The PlayDockXM can be used as a player for any portable audio device with a headphone minijack output. A minijack to miniplug extension (not supplied) may be required to in order to reach the device’s signal minijack.

or Delphi Roady®2 satellite radio receivers.

Battery Replacement

Assuming it is kept charged, the battery inside the PlayDockXM should last

for many years. When the battery fails to operate the PlayDockXM for

re than two to three hours after a 12 hour charge cycle, replacement is

indicated.

1) T

2) Note

3) Install a new battery inside the PlayDockXM.

4) Attach the red wire’s connector to the red battery terminal.

5) Repeat for the other connector.

6) Replace the endcap and charge the battery for at least 12 hours prior to

Warranty

To the original purchaser, Cambridge SoundWorks, Inc. warrants material from date of purchase. With respect to defects, Cambridge Sound the pu to equipment it was speaker was warranty implied, otherwise. liable liability set incumbent retailer where the PlayDockXM was purchased and inform them acceptable of pu

Contact Cambridge SoundWorks for a replacement.

o replace the battery, remove the three screws on the left hand

endcap

(the endcap without the POWER switch.)

the red wire’s connector is attached to the battery’s red (positive) terminal. Detach both connectors from the battery terminals and slide out the battery.

portable operation.

For Service and Support Inside U.S.A., if

the speaker system to be free of defects in

and worksmanship for a period of one (1) year

Works will, at its option, replace the product or repair

defect in the product with no charge to the original

rchaser for parts or labor. This warranty does not extend

abuse, accident, faulty hookup, defective associated

or use of the speaker with equipment for which

not intended. This warranty is valid only when the

is returned to the retailer where the PlayDockXM

purchased. This is the sole and expressed warranty. This

is in lieu of all other warranties, expressed or

of merchantability, fitness for purpose or

In no event shall Cambridge SoundWorks be

for incidental or consequential damages or have any

with respect to defects other than the obligations

forth above. To ensure warranty coverage, it is

upon the original purchaser to contact the

of the defect within the warranty period. The only

method of establishing warranty status is a copy

the original proof of purchase indicating customer name,

rchase date, retailer name and place of purchase.

purchased from a Cambridge SoundWorks retail outlet, Cambridge SoundWorks phone sales, CambridgeSoundWorks www.hifi.com

website:

If a speaker malfunctions due to a manufacturing defect within 1-800-FOR-HIFI th numbe charge days, pay

the warranty period, just call us toll-free at

rough Friday and ask for a return authorization

the shipping costs to return it to you.

other brands and products are trademarks or registered

between 9 a.m. and 8 p.m. ET Monday

r. We will repair or replace your speaker at no

to you. Proof of purchase is required. After 45

you must pay for shipping back to us, we will then

SoundWorks is a registered trademark of

to change without prior notice. Actual content

differ from the illustrations.

Works, Inc., Andover, Massachusetts USA.

Left

endcap

Bar

Stage

Top of Glove Bottom of Glove

Claw

Bottom lip

POWER Switch: Put this switch in the Off position (out) to save the

battery’s charge during storage. In day-to-day operation with the Power Adapter connected, use the PLAY/ MUTE button to turn on the PlayDockXM.

12-14 VDC

POWER

Contents

A) PlayDockXM player (with battery inside) B) Power Supply Adapter C) Glove holder for Roady/Roady II D) Hi-gain XM satellite antenna inside pouch

At First Use, Charge The Battery:

PlayDock’s internal battery charges whenever the Adapter is connected. To charge the battery--

Inse

rt Adapter AC plug into AC outlet (see ).

Inse

rt Adapter output into the PlayDock 12-14 VDC

input

(see ). The battery can not be overcharged. W charge

the PlayDock for 3 to 4 hours before using it

without

the AC adapter (portable operation).

e recommend you

100 Brickstone Square, Andover MA 01810

A Company

P81-2150 rv Bpm

Attach the Glove And Install the Roady/Roady 2

4) Locate the Stage and Bar at the top of the PlayDockXM.

See illustrations

A and C on the previous page.

5) Slip the Glove lip under the Stage.

6) Push the Power Plug and Signal Plug through the hole

in the Glove.

Slip the Glove lip under the PlayDock Stage.

Power Plug

Signal Plug

7) Press the Glove claw onto the Bar.

9) Connect the Power and Signal plugs.

Normal Operation (Power Adapter connected)

13) Press the PLAY/ MUTE button to select ON or STANDBY. The PLAY/ MUTE light will glow GREEN (On) or RED (Standby).

14) With the Roady connected and “On”, adjust VOLUME or VOLUME .

15) Use the WIDE mode for enhanced sound.

16) Use the PLAY/ MUTE button to switch between STANDBY and

ON whenever the AC power adapter is plugged in. Use the POWER switch on the side of the PlayDockXM to save the battery charge level if the PlayDockXM is stored without the Power Adapter connected.

Portable Operation (without Power Adapter)

18) Press the PLAY/ MUTE button to activate portable operation.

The light will glow green. The PlayDockXM automatically turns off (PLAY/ MUTE light off) after about five minutes of inactivity to preserve the battery. In this case, press the PLAY/ MUTE button to reactivate the PlayDockXM.

19) Connecting the Power Adapter without AC power available

prevents operation. Disconnect the Power adapter if AC power is not available.

After a 12-hour charge cycle, the PlayDockXM will operate from its internal battery for about 10-12 hours of continuous play at moderate volume. When the battery charge is too low, the sound distorts at higher volumelevels. Recharge the battery if this occurs.

PlayDockXM Controls

10) Connect the Antenna plug and route the wire.

(Activate portable operation)

PLAY/ MUTE

WIDE Mode

Volume Down

Volume Up

Press Claw

onto Bar

Connect the Roady/Roady 2

8) Push the Roady or Roady II into the Glove until it is firmly seated.

The Roady or Roady II

fits with or without the

bracket in place.

Route the antenna wire under the side of the glove for a finished look.

11) Position the antenna.

PLA

Charging

Make sure the Roady or Roady 2 is Off before inserting or removing the Power Adapter from

the PlayDockXM.

The PlayDockXM battery will charge anytime an active AC power adapter is connected. Keep the Power Supply Adapter connected to the PlayDockXM whenever portable operation is not needed and AC power is available. This will keep the PlayDockXM battery at optimum charge level. The PlayDockXM sealed battery (lead-acid type) cannot be overcharged.

+ 1 hidden pages

Cambridge Soundworks PlayDock XM User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual