Cambridge Soundworks Playdock PD200 User Manual

PlayDock™ PD200
for Creative NOMAD/Digital Audio Player Jukebox
Introduction
Thank you for purchasing the Cambridge SoundWorks®PlayDock PD200.
NOMAD Jukebox and we provide a flexible holder for this product.
Even though the product is not designed to hold them, the Line Input
plug of the PlayDock PD200 will fit the headphone jack of most portable
audio devices. PlayDock PD200 can play the output of these devices if
they are connected.
Contents
A) PlayDock PD200 player (with battery inside) B) Jukebox Glove C) Power Supply Adapter
First Use
1) Insert Adapter output into the PlayDock 12-14 VDC input on the
right endcap, next to the Power button.
2) Insert Adapter AC plug into AC outlet. Charging starts. Charge for
12 hours before using PlayDock PD200 without the Adapter
(portable operation).
Preparing the Jukebox
3) Insert the Jukebox into the Glove
4) Note the PlayDock PD200 Stage and Bar.
5) Slip the Glove’s bottom lip under the Stage.
6) Press the rear of the Glove onto the Bar.
7) Route wires through restraint.
8) Insert the DC Connector into Jukebox’s DC IN jack.
9) Insert the Signal Connector into Jukebox’s LINE OUT 1 jack.
LIB
EAX
MUTE
WIDE
VOLUME
LIB
EAX
MUTE
WIDE
VOLUME
LIB
EAX
2
1
LINE OUT
LINE
IN
USB
DC IN 12V
1
MUTE
WIDE
VOLUME
12-14 VDC
IN
POWER
A
B
C
1
2
3
4
5
6
7
8
Bar
Jukebox
LINE IN 1 jack
PlayDock PD200
Signal Miniplug
Jukebox
12VDC IN jack
PlayDock PD200
DC Power plug
Bottom lip
Right endcap
Stage
9
Route wires
through restraint
Operation
9) Press in the POWER button on the right side endcap.
The MUTE light will glow green.
10) With the Jukebox playing, adjust VOLUME or VOLUME ▼.
11) Use the WIDE operation mode for enhanced sound.
12) Pressing MUTE will silence the speaker (the light glows amber)
and enter a standby mode. The PlayDock PD200 will enter MUTE
mode after about five minutes of inactivity. It will restart when
music resumes, or when you press the MUTE button.
Charging
Keep the AC power adapter connected to the PlayDock PD200
whenever portable operation is not needed and AC power is available.
The sealed battery (lead-acid type) cannot be overcharged.
Portable Operation
After a 12-hour charge, the PlayDock PD200 will operate from its inter-
nal battery for about 8 hours at moderate volume. When the battery is
reaching the end of its charge, the sound distorts at higher volumes.
The PlayDock PD200 automatically shuts itself off when the battery
charge has been exhausted. If this happens, recharge the PlayDock
PD200 within a day or so to maintain the service life of the battery.
311 Needham Street, Newton MA 02464
P81-1710
Battery Replacement
The battery inside the PlayDock PD200 has a service lifetime typically
exceeding two years. For maximum service life, do not attempt to
operate the PlayDock once it has automatically shut-off due to low bat-
tery charge. When the battery eventually fails to power the PlayDock
for more than two hours, replacement is required. Contact Cambridge
SoundWorks for a replacement.
1) To replace the battery, remove the three screws on the left hand
endcap (the endcap without connector jacks).
2) Note which connecter is attached to the battery’s positive
terminal. Detach both connectors from the battery terminals
and slide the battery out.
3) Install a fresh battery inside the PlayDock PD200 player.
4) Attach the positive connector and then the negative connector.
5) Replace the endcap and charge the battery for at least 12 hours
prior to portable operation.
Warranty
To the original purchaser, Cambridge SoundWorks, Inc. will warrant the speaker system to be free of defects in material and workmanship for a period of one (1) year from date of pur­chase. With respect to defects, Cambridge SoundWorks will, at its option, replace the product or repair the defect in the prod­uct with no charge to the original purchaser for parts or labor. This warranty does not extend to any defect, malfunction or fail­ure caused by misuse, abuse, accident, faulty hookup, defec­tive associated equipment or use of the speaker with equip­ment for which it is not intended. This warranty is valid only when the speaker is returned to the retailer where the Playdock PD200 was purchased. This is the sole and expressed warran­ty. This warranty is in lieu of all other warranties, expressed or implied, of merchantability, fitness for purpose or otherwise. In no event shall Cambridge SoundWorks be liable for incidental or consequential damages or have any liability with respect to defects other than the obligations set forth above. To ensure warranty coverage, it is incumbent upon the original purchaser to contact the retailer where the PlayDock PD200 was pur­chased and inform them of the defect within the warranty peri­od. The only acceptable method of establishing warranty status is a copy of the original proof of purchase indicating customer’s name and purchase date.
For Service and Support, Contact:
Inside U.S.A., Canada and Latin America
Creative Labs Inc. Technical Support 1523 Cimarron Plaza Stillwater, OK 74075 Tel: 1-405-742-6622 Fax: 1-405-742-6633 Operating hours (Central Time): Daily 8:00 A.M.-12 Midnight To reach Technical Support via the Internet, visit our web site at http://www.creativehelp.com. You can reach Customer Service by phone at 1-800-998-1000, Mon-Fri 8:00 A.M.-7:00 P.M. (Central Time). You can also use our Faxback service at 1-405-372-5227.
Inside Asia
Creative Technology Ltd. Technical Support 31 International Business Park Creative Resource Singapore 609921 Tel: 65-895-4100 Fax: 65-569-6640 Operating hours (Singapore Time): Mon-Fri 9:00 A.M.-6:00 P.M. Sat-Sun & Public Holidays closed To reach Technical Support via the Internet, visit our web site at http://www.creative-asia.com/support
©2001 Cambridge SoundWorks, Inc. All rights reserved. Cambridge SoundWorks is a registered trademark of Cambridge SoundWorks, Inc., Newton, Massachusetts USA. All other brands and products are trademarks or registered trademarks of their respective holders. All specifications are subject to change without prior notice. Actual contents may differ from those pictured.
Remove screws on
side for battery access.
Left
endcap
VOLUME
WIDE
MUTE
Mute
Volume Up
Volume Down
Wide Mode
Loading...
+ 1 hidden pages