Cambium Networks XIAC3470 Notices to User

Wireless Access Point

Appendix D: Notices (XR-1000 to XR-6000 Indoor Models)



This appendix contains the following information:

 “Notices” on page 559

 “EU Directive 1999/5/EC Compliance Information” on page 564

 “Compliance Information (Non-EU)” on page 571

 “Safety Warnings” on page 573

 “Translated Safety Warnings” on page 574

 “Software License and Product Warranty Agreement” on page 576

 “Hardware Warranty Agreement” on page 576

This Appendix contains Notices, Warnings, and Compliance information for
these indoor model series: XR-1000, XR-2000, XR-4000, and XR-6000.
This includes the models just listed whether or not they have been upgraded
to have IEEE 802.11ac Wave2 wireless capability by replacing existing
radios with XI-AC3470 modules.

For the XR-500/600/XD Series, please see “Notices (XD and XR500/600
Series Only)” on page 541.

For models including the letter H (such as the XR-520H and XH2-

120), please see the Quick Installation Guide for that model.

Notices

Wi-Fi Alliance Certification

www.wi-fi.org

FCC Notice

This device complies with Part 15 of the FCC Rules, with operation subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause unwanted operation.

559

Wireless Access Point

This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate RF energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following safety measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and the receiver.
 Consult the dealer or an experienced wireless technician for help.

Use of a shielded twisted pair (STP) cable must be used for all Ethernet
connections in order to comply with EMC requirements.

High Power Radars

High power radars are allocated as primary users (meaning they have priority) in
the 5250MHz to 5350MHz and 5650MHz to 5850MHz bands. These radars could
cause interference and/or damage to LE-LAN devices.

Non-Modification Statement

Unauthorized changes or modifications to the device are not permitted. Use only
the supplied internal antenna, or external antennas supplied by the manufacturer.
Modifications to the device will void the warranty, void the user’s authority to
operate the equipment, and may violate FCC regulations (Reference: FCC Part 15,
section 15.21). Please see the Xirrus Web site for a list of all approved antennas.

Cable Runs for Power over Gigabit Ethernet (PoGE)

If using PoGE, the Array must be connected to PoGE networks without routing
cabling to the outside plant — this ensures that cabling is not exposed to lightning
strikes or possible cross over from high voltage.

560

Wireless Access Point

UL Statement

Use only with listed ITE product.

Battery Warning

Caution! The AP contains a battery which is not to be replaced by the

!

customer. Danger of Explosion exists if the battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer's
instructions.

RF Radiation Hazard Warning (FCC and Industry Canada)

For APs with IEEE 802.11ac Wave2 radios, install the unit being careful to keep
the separation distances indicated in the table below between radiating elements
of access point and users. This is consistent with the security warning exposure
limits specified by the RSS-102 to relative radio frequencies.

Pour les appareils IEEE 802.11ac Wave2, installez l'appareil en veillant à conserver les
distances de séparation indiquées dans la table ci-dessus entre les éléments rayonnants et
les personnes. Cet avertissement de sécurité est conforme aux limites d'exposition définies
par la norme CNR-102 relative aux fréquences radio.

802.11ac Wave2

Modules (Radios) in AP

1 module 20.0 21.2

XR6000 - 12 modules 51.3 51.6

XR4000 - 8 modules 44.0 50.8

XR2000 - 4 modules 31.1 39.9

For other APs, to ensure compliance with FCC and Industry Canada (IC) RF
exposure requirements, this device must be installed in a location where the
antennas of the device will have a minimum distance of at least 30 cm (12 inches)
from all persons.

FCC Separation

Distance (cm)

IC Separation
Distance (cm)

561

Wireless Access Point

Pour les autres appareils, installez l'appareil en veillant à conserver une distance d'au
moins 30 cm entre les éléments rayonnants et les personnes. Cet avertissement de sécurité
est conforme aux limites d'exposition définies par la norme CNR-102 at relative aux
fréquences radio.

Industry Canada Notice and Marking

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

The term “IC:” before the radio certification number only signifies that Industry
Canada technical specifications were met.

Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for
successful communication.

Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé
pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son
gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas
l'intensité nécessaire à l'établissement d'une communication satisfaisante.

This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.

562

Wireless Access Point

This equipment should be installed and operated with a minimum distance of
30cm between the radiator and your body.

Cet équipement doit être installé et utilisé à une distance minimale de 30cm entre le
radiateur et votre corps.

High Power Radars

High power radars are allocated as primary users (meaning they have priority) in
the 5250MHz to 5350MHz and 5650MHz to 5850MHz bands. These radars could
cause interference and/or damage to LELAN devices used in Canada.

Les utilisateurs de radars de haute puissance sont désignés utilisateurs principaux (c.-à­d., qu’ils ont la priorité) pour les bandes 5 250 - 5 350 MHz et 5 650 - 5 850 MHz. Ces
radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL.

563

Wireless Access Point

EU Directive 1999/5/EC Compliance Information



This section contains compliance information for the Xirrus Wireless Array family
of products. The compliance information contained in this section is relevant to
the European Union and other countries that have implemented the EU Directive
1999/5/EC.

This Appendix contains Notices, Warnings, and Compliance information for
these indoor model series: XR-1000, XR-2000, XR-4000, and XR-6000.
This includes the models just listed whether or not they have been upgraded
to have IEEE 802.11ac Wave2 wireless capability by replacing existing
radios with XI-AC3470 modules.

For Notices, Warnings, and Compliance information for other models, see
the notes at the beginning of this chapter.

Declaration of Conformity

Cesky [Czech] Toto zahzeni je v souladu se základnimi požadavky a

ostatnimi odpovidajcimi ustano veni mi Sm
1999/5/EC.

Dansk [Danish] Dette udstyr er i overensstemmelse med de

væsentlige krav og andre relevante bestemmelser i
Direktiv 1999/5/EF.

Deutsch [German] Dieses Gerat entspricht den grundlegenden

Anforderungen und den weiteren entsprechenden
Vorgaben der Richtinie 1999/5/EU.

ěrnice

564

Eesti [Estonian] See seande vastab direktiivi 1999/5/EU olulistele

nöuetele ja teistele as jakohastele sätetele.

English This equipment is in compliance with the essential

requirements and other relevant provisions of
Directive 1999/5/EC.

Español [Spain] Este equipo cump le con los requisitos esenciales asi

como con otras disposiciones de la Directiva 1999/5/
CE.