Cambium Networks PTP820C, PTP820S, RFU-C Installation Instructions Manual

1

PTP820 C/S and RFU-C to Dragonwave Antenna Interface

– Installation Instructions

This guide explains how to mount PTP820 mediation devices on Dragonwave
antennas.

List of Kits

Item

Description

Quantity

Remarks

1

PTP820 C/S and RFU-C to Dragonwave Antenna adaptor

1

2

RFU-C or PTP820C OMT

1

Mediation devices:

PTP820C OMT RFU-C OMT

Required tools

 Metric offset hexagon key wrench #6

 Metric wrench 13 mm

Procedure

1 Carefully clean and grease the O-ring mounted on the Dragonwave

antenna using the grease tube supplied in the PTP820C/S and
RFU-C Dragonwave antenna adaptor kit box.

2

2 Gently slide the PTP820C/S and RFU-C Dragonwave antenna adaptor onto

the Dragonwave antenna. Make sure that the hook is facing up and close

the latches firmly.
3 If the O-ring is already mounted to the PTP820C/S and RFU-C side of
the

Dragonwave antenna adaptor, just remove gently the adhesive tape. If the

O-ring is not mounted, place the O-Ring supplied in the RFU-C

Dragonwave Interface kit onto the PTP820C/S and RFU-C Dragonwave

interface. Make sure the mounting direction is correct, as shown in the

section view.

Hook Facing Up

Clean and grease

O-ring