Page 1
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 1/13
9516/ 303X User manual
Page 2
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 2/13
MAIN
Push the crown to change Mode.
NEUTRAL
TIME 2
ALARM
CHRONO
DATE
Page 3
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 3/13
SYNCHRONIZING THE HANDS
From each mode, push the crown at least 3 seconds. Movement is going into synch mode for adjust and synchronize the hands position.
Push A Turn up or down the crown Push the crown to get out
Small second hand runs Minute hand runs
TIME SETTING
From each mode, pull the crown. Movement is going into time setting mode. The small second hand stops.
Turn up or down the crown Push A
to set hour, changes between 12h/24h mode
the display will follow hands
Page 4
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 4/13
NEUTRAL FUNCTION
Actions:
A: not used
B: not used
B 1 second: not used
Crown push: Change mode
Page 5
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 5/13
ALARM FUNCTION
ON
OFF
Actions:
A: Change alarm status
B: not used
B 1 second: Alarm setting
Crown up or down: EL on for 5 seconds
Crown push: Change mode
Page 6
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 6/13
To adjust Alarm push B at least 1 second.
To go out of setting mode quickly, push the crown, else wait for 5 seconds.
Out of setting
mode
Page 7
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 7/13
TIME 2 FUNCTION
Actions:
A: not used
B: not used
B 1 second: Time 2 setting
Crown up or down: EL on for 5 seconds
Crown push: Change mode
Page 8
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 8/13
To adjust Time 2 push B at least 1 second.
To go out of setting mode quickly, push the crown, else wait for 5 seconds.
Out of s
etting
mode
Page 9
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 9/13
CHRONO FUNCTION
Actions:
Read description down
Page 10
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 10/13
1. Measure of elapsed time
Push on A to start the chrono. Push on A to stop the chrono, display sows the elapsed time.
Push on B to reset the chrono.
2. Measure of cumulated time
Same operations as 1. but replace “push on B” by push on A to restart the chrono
3. Reading of a partial time when chrono display is frozen
Push on A to start the chrono.
Push on B to freeze the display.
Push on B to defreeze the display that gives again the time really elapsed.
4. Measure of a second time
This operation is a combination of the preceding points:
Push on A to start the chrono
Push on B to freeze the display (The chrono still count)
Push on A to stop the chrono (pictograms don’t blink because chrono is stop)
Push on B to defreeze the display: display gives the time elapsed at the moment of chrono stop.
Push on B to reset the chrono
Page 11
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 11/13
DATE FUNCTION
Actions:
A: not used
B: not used
B 1 second: Date setting
Crown up or down: EL on for 5 seconds
Crown push: Change mode
Page 12
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 12/13
To adjust Date push B at least 1 second.
To go out of setting mode quickly, push the crown, else wait for 5 seconds.
Page 13
Caliber 9516/3030 USER MANUAL
17/01/2014 Page 13/13
LOW BATTERY
When Low battery is detected all functions are disabled, small second is stopped.
If Alarm was ON it will not be disabled until ring.
Loading...