CAD Audio E70 User Manual
Professional Microphones
3 Position High Pass Filter and 3 Position Pad
Description
Packaged in a small, rugged metal housing, the equitek e70 condenser
microphone provides transparent, accurate acoustic capture. The low
mass 1/2” gold sputtered diaphragm makes the e70 the preferred choice
for high frequency sources rich in transients such as cymbal, hi-hat,
strings, acoustic guitar, woodwinds and piano. The transformerless design reduces low frequency distortion at high sound pressure levels.
The 3 position hi-pass filter and 3 position pad provide the versatility
required in demanding live sound and studio applications. The interchangeable capsules provide both cardioid and omnidirectional pickup
patterns for greater flexibility. The e70’s accuracy, high SPL capability
and size make it a valuable tool in the professional audio environment.
CAD Quality
The e70 microphones are audio tested and inspected under the direction
of CAD Professional Microphones, offering an exceptional level of value.
Specifications*
T ype:
End address condenser with interchangeable capsules
Frequency Response:
20Hz - 20KHz
Impedance:
85 ohms
Using Cardioid Capsule:
Sensitivity: -40dBV (10mV) @ 1 Pa
Self Noise: 23dB, A-weighted
Maximum SPL: 155dB, 20dB pad engaged
Using Omnidirectional Capsule:
Sensitivity: -36dBV (16mV) @1 Pa
Self Noise: 19dB, A-weighted
Maximum SPL: 154dB, 20dB pad engaged
Power Requirements:
Phantom P48, 2mA
Connector:
Three pin XLR type
Polarity:
Inward pressure on the diaphragm produces positive voltage on pin 2
Dimensions:
7/8" (22 mm) x 6 1/8" (156 mm)
Net Weight:
7.6 oz. (216 grams).
Included Accessories:
Shockmount, mic clip and windscreen
*In our constant efforts to maintain excellence, CAD Professional Microphones reserves
the right to change these specifications at any time and without prior notice.
e70
Modular Dual-Capsule Condenser With
7/8"
(22 mm)
.37"
(9.5 mm)
1KHz
1KHz
6 1/8"
(156 mm)
CAD Professional Microphones hereby warrants that this product will be free of defects in material and workmanship for a period
of one year from the date of purchase. In the unlikely event a defect occurs CAD will, at its option, either repair or replace with a
new unit of equal or greater value. You should retain proof of purchase to validate the purchase date and return it with any warranty
claim. Return warranty claims carefully packed, insured and prepaid to the Service Department.
This warranty excludes exterior finish or appearance, damage from abuse, misuse of the product, use contrary to CAD’s instructions
or unauthorized repair. All implied warranties or merchantability or fitness for a particular purpose are hereby disclaimed and CAD
hereby disclaims liability for incidental, special or consequential damages resulting from the use or unavailability of this product.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Some states do not
allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so
the above exclusions and limitations may not apply to you.
Note: No other warranty, written or oral is authorized by Omnitronics, LLC
TWO-YEAR LIMITED WARRANTY
.79"
(20 mm)
46873-31-00 / Rev. 5 / 5-1-06
Loading...