V-2020-01
QUICK ACCESS SAFE
with Biometric Lock
55B30BP
Photo of outside of safe
12
Photo of inside of safe
6
3
1. Backlit Scanner
2. Key Hole
3. Battery Compartment
5 4
4. Reset Button
5. Led Light
6. Back-Up Keys
104
OPENING THE SAFE FOR THE FIRST TIME
Insert the backup key into the keyhole and turn clockwise until the door
automatically opens.
WARNING: Do not store your back up keys inside the safe.
NOTE: You must turn the key back to the locked position before you are able
to close and lock the cover.
BATTERY INSTALLATION AND REPLACEMENT
RECORDING YOUR FINGERPRINTS
follows:
.
(
the same position until there is 1 audible beep (if the sound is turned on) and
.
1. Open the battery compartment cover, carefully insert 4 AA batteries
(included) into the battery compartment. Follow the positive (+) and
negative (-) guides in the compartment.
2. Snap the battery cover back into place.
(
same position until there are 2 audible beeps (if the sound is turned on) and the
now recorded.
106
OPENING THE SAFE USING YOUR FINGERPRINTS
lighted in white and the scan will begin.
audible
the scan has been accepted and the safe will open with inside LED light turned
on for 60 seconds.
but rejected it.
NOTE: If there are 3 rejected scans and the red light fashes 5 times with 5 audible
beeps (if the sound is turned on), the alarm lasts 10 seconds, you will have an
If there is 1 more rejected scan and the red light fashes 5 times with 5 audible
beeps (if the sound is turned on), the alarm lasts 30 seconds, you will have an
automatic lockout for 5 minutes before you can try a scan again
beeps (if the sound is turned on),
CLEARING THE MEMORY
audible
beeps (if the sound is turned on). All recorded scans will be erased.
TURNING THE KEYPAD SOUND OFF/ON
Your safe comes with the audible sound turned on.
I
over.
LOCKING THE SAFE
To lock your safe, simply push the cover closed until locked.
NOTE: Alarm cannot be disabled.
WARRANTY
LOCK AND PAINTED SURFACE WARRANTY
Locks and painted surfaces are warranted to be free from defects in workmanship and materials for a period of one year from the date of purchase.
Heritage Security Products takes seriously its obligation to stand behind its
product with this warranty as long as the safe is properly installed and cared for
as instructed in the Owner’s Instruction Manual. The warranty does not apply to
safes or parts that have been misused, neglected or subjected to unusual or
extreme conditions and/or environments, or to unreasonable wear and tear.
Changing or modifying the safe in ways that affect its intended use will void this
warranty. The safe must be registered within 60 days of the purchase and must
Limitation of Remedies: In no case shall Heritage Security Products be liable for
any special, incidental, or consequential damages based upon breach of warranty, breach of contract, negligence, strict tort, or any other legal theory. Such
revenue, loss of the contents of the safe or vault door, loss of use of the safe or
vault door, or any associated equipment, cost of capital, cost of any substitute
equipment, facilities or services, downtime, the claims of third parties including
customers, and injury to property.
This warranty is only applicable to the Safe itself and does not extend
to the contents of the Safe. For optimal security and protection, safes should
be bolted down. Please refer to your Instruction Sheet for details on anchoring
your safe.
Heritage Security Products provides this warranty in place of all other warranties
and assurances whether expressed or implied. Heritage Security Products
accepts no liability for incidental or consequential damage or loss by anyone as
a result of using this safe.
Upon Veri cation of ownership, replacement keys are available for purchase through
customer service.
Contact Customer Service for more information.
Loading...