C2G Multi-Modular Cable Tester-Pro User Manual

Multi-Modular

Cable Tester

User Manual

Model: 250451

Hobbes Computer Network Accessories

www.hobbes-usa.com

MULTI-MODULAR CABLE TESTER

Test for USOC 4/USOC 6/USOC 8 Modular Cable

1. 1 Plug one end to the master tester and the other end to the
remote terminator (you may plug both end to master unit
only, if you are not doing a re-mote test).

2. Push the power switch on, the power LED will flash to
show the power is working properly.

3. As soon as the tested cable is inserted the LEDs on the
remote terminator will start to scan one by one.

4. If the tested cable is OK, the corresponding pair of LEDs
will light up all GREEN.

5. If the corresponding pair of LEDs is lighted all RED, the
cable was wired reversely.

6. If the LEDs light up GREEN first and RED after (mix.) or
it is unlighted, the cable is bad.

Remarks: Please make sure a 9-volt alkaline battery has been installed in the

battery compartment.

Caution: Don’t connect cable tester to the live circuits as it

may be damaged by over voltage.