Bush BTCH60B, BTCH60X Instruction manual
Range hood
Range Hood User Manual
BTCH60B-BTCH60X
Compliant to EEE Directive.
Please read this user manual carefully before installing or using your equipment.
Please keep this user manual in a safe place for future use.
Scope of the Range Hood User Manual
Dear customer, the following sections contain information on safe and efficient use of
the equipment. Please read carefully before attempting to install the equipment.
Points to consider before use……………………………………2
Section 1
Technical specifications .......................................................... 3
Section 2
Technical dimensions ............................................................ 4
Section 3
Section 4
Section 5
Section 6
Wiring diagrams .................................................................... 5
M
ounting instructions ............................................................ 6
Operating instructions .......................................................... 9
Maintenance instructions ................................................... 10
Section 7
Section 8
Fault Descriptions ............................................................ 12
1
Points to consider before use
Section 1
1....Electrical connections and installation of the product must be done by qualified service personnel.
In contrary, the product's efficiency may be reduced and serious risks such as noise,
vibration and electricity leakage may occur. In addition, the warranty becomes null.
2....Operating voltage is 200-230 Volt. Do not use under lower or higher voltages.
In contrary, it leads to burnout with the motor windings, failure with the light bulbs and
damages other electrical connection members.
3....The exhaust connection of the product must be made to heating stove, natural gas, heater, ventilation duct.
In contrary
4....The product must be connected to grounding plug.
In contrary, there is a risk of equipment damage and electrical shock.
5....Flammable food should not be cooked under the range hood.
In contrary, the equipment may take fire, electrical components and metal housing may be damaged.
6....Do not use replace the aluminium filter of the range hood with other materials.
In contrary, other materials may take fire, the suction power may be reduced in addition to the
reduction of service life.
7....Do not connect the range hood to power before completing the installation works.
In contrary, there is a risk of electrical, mechanical problems for the equipment, in addition,
electrical or mechanical accidents may take place.
8....Range hood is designed for use above the stoves in the kitchen of the houses. The product should
not be used out of its intended purpose.
In contrary, the manufacturer shall not assume any responsibility in connection with possible
problems and accidents. In addition, the warranty of the equipment becomes null.
9....Make sure that the wall where the range hood will be mounted is capable of bearing its load.
, toxic gas leakage occurs or the high air pressure affects other environments.
In contrary, negative consequences may occur.
10....Keep children away from the equipment and do not allow them to use it.
In contrary, negative consequences may occur.
11.... Do not touch the halogen lamp as it heats on the surface.
In contrary, various accidents may take place.
12....Ventilation in the room must be at sufficient levels when the electrical range hood is used at the same time with the
equipment fuelled with gas or other fuels. (air-filtering equipment may be excluded)
In contrary, various accidents may take place.
13....Electrical range hood must be cleaned periodically, surfaces of the product must be clean.
In contrary, oil accumulates on the range hood surface and it may cause range hood to take fire.
14....The product must be mounted on the wall in accordance with the dimensions specified in the mounting diagrams.
In contrary, the range hood may take fire, toxic gasses are not extracted and performance loss occurs.
2
Section 2
Technical specifications
8
1
2
3
4
1- Flue top
2- Lower flue panel
3- 220V cable
4- Range
5- Removable centre glass
6- Control glass panel
7- Control icons
8- Connection plate
Range hood technical specifications
Length
Width
Height
Control Panel
Suction Power
Light Power
598/898
425
Min 805 Max 1085
Touch Control
550 M³
2X20 W
Figure A1
Motor Power 115W
Total Power
Air Outlet Pipe Diameter
Supply Voltage
5
6
7
155W
120
mm/150 mm
220-230V 50Hz
3
Section 3
Technical dimensions
260
20
260
108
120
172
425
598-898
500
525
Min 805 - Max 1085
610
Figure A2
4
Loading...