Bush BT26 User Manual
Instruction manual
Fabric Speaker BT26
Contents
You’ll soon be enjoying your new Fabric Speaker.
It all begins here, with your instructions. Don’t worry, there’s
nothing too technical coming up. Just simple, step-by-step
guidance to get you up and running quickly. Sound good? Then
let’s get started.
Safety information
1
General safety information 6
Power source 6
Moisture and water 7
Ventilation 7
Heat sources and flames 7
Getting to know your Fabric Speaker
2
Your Fabric speaker 10
Positioning the Fabric Speaker 12
Power connection 12
Using your Fabric Speaker
3
Power on 16
Status LEDs 16
Connect to a Bluetooth device 16
Adjusting the volume 17
Listening to Music/Audio using Bluetooth 18
Aux in mode 18
Help and Guidance
We’re here to help you get the most from your Fabric Speaker. Should you require any
guidance, a simple solution can often be found online at:
www.bush-support.com
If you still require further assistance, call one of our experts on 0345 600 3021.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Other information
4
Technical specification 22
Product support
5
Troubleshooting 26
Help and assistance 27
Disposal 28
Your Bush Guarantee 29
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
3
This page is left intentionally blank
1Safety information
Safety information
Safety information
Important - Please read these instructions fully before
installing or operating
General safety information
Keep the product and all its parts out of reach of small children.
This product is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning the use of the appliance by a person
responsible for their safety.
• Do not attempt to open the product. This product does not contain any user
serviceable parts. Unauthorised handling of the device may damage it and will void
your warranty.
• Do not use your Fabric Speaker emergency/intensive care medical equipment; or
during an electrical storm.
To avoid possible hearing damage, do not listen to this Fabric Speaker at
high volume levels for long periods of time. Always keep the volume within
reasonable limits.
Power source
Only use the power supply that came with the product. Using an unauthorised power
supply will invalidate your guarantee and may irrecoverably damage the product.
Important - Please read these instructions fully before
installing or operating
Moisture and water
• Do not leave it in low temperatures as moisture can form inside the product, which
may damage the circuit board.
Ventilation
• Do not block or cover slots, holes or openings on the product by placing on soft
furnishings such as carpets, rugs or beds as these are provided for functionality and/or
ventilation to ensure safe operation of the product.
Heat sources and flames
Do not leave it in high temperatures as electronic devices and plastic parts may warp in
heat.
Keep it away from bright sunlight or heat sources, such as a radiator.
No naked flame sources, such as lighted candles, should be placed on or near the
product.
Disconnect your Fabric Speaker from the mains power supply during thunderstorms.
Always check that you have completely switched off your Fabric Speaker, before you
change or disconnect the power supply.
Where the mains power plug or an appliance coupler is used as the disconnect device,
the disconnect device shall remain readily operable.
If the Fabric Speaker will not be used for a long period of time, make sure that the mains
power is unplugged.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
6
Safety information
Troubleshooting
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
Safety information
7
Getting to know your Fabric
This page is left intentionally blank
Speaker
2
Getting to know your Fabric Speaker
Getting to know your Fabric Speaker
You’ll be up and running in no time
Ready? Let’s begin...
Please read these instructions carefully. They contain important information which will
help you get the best from your product and ensure safe and correct installation and
operation.
If you require any further assistance, our technical experts are happy to help. For full
details, refer to the product support section at the end of these instructions.
Fig 1.
You’ll be up and running in no time
Fig 2.
1
1. Power on/Standby
2. Status LED
• Blue flashing quickly: Searching for
BT devices
• Blue flashing slowly: BT standby
mode
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
10
Getting to know your Fabric Speaker
• Blue steady on: BT connected
• Red steady on: Aux in mode
• Red flashing slowly: Aux in standby
mode
3. Volume -
4. Volume +
432 5 6
Troubleshooting
5. Power socket 6. Aux in socket
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
Getting to know your Fabric Speaker
11
Loading...