Bunn PAF Parts Manual

POWDER
AUTO FILL
ILLUSTRATED PARTS CATALOG
are subject to change without notice.
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
29792.0001B 07/13 ©2012 Bunn-O-Matic Corporation
BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY
Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows:
1) Airpots, thermal carafes, decanters, GPR servers, iced tea/coffee dispensers, MCP/MCA pod brewers thermal servers and Thermofresh servers (mechanical and digital)- 1 year parts and 1 year labor.
2) All other equipment - 2 years parts and 1 year labor plus added warranties as specified below: a) Electronic circuit and/or control boards - parts and labor for 3 years. b) Compressors on refrigeration equipment - 5 years parts and 1 year labor. c) Grinding burrs on coffee grinding equipment to grind coffee to meet original factory screen sieve analysis - parts
and labor for 4 years or 40,000 pounds of coffee, whichever comes first.
These warranty periods run from the date of installation BUNN warrants that the equipment manufactured by it will be commercially free of defects in material and workmanship existing at the time of manufacture and appearing within the applicable warranty period. This warranty does not apply to any equipment, component or part that was not manufactured by BUNN or that, in BUNN’s judgment, has been affected by misuse, neglect, alteration, improper installation or operation, improper maintenance or repair, non periodic cleaning and descaling, equipment failures related to poor water quality, damage or casualty. In addition, the warranty does not apply to replacement of items subject to normal use including but not limited to user replaceable parts such as seals and gaskets. This warranty is conditioned on the Buyer 1) giving BUNN prompt notice of any claim to be made under this warranty by telephone at (217) 529-6601 or by writing to Post Office Box 3227, Springfield, Illinois 62708-3227; 2) if requested by BUNN, shipping the defective equipment prepaid to an authorized BUNN service location; and 3) receiving prior authorization from BUNN that the defective equipment is under warranty.
THE FOREGOING WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ANY OTHER WARRANTY, WRITTEN OR ORAL, EX­PRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF EITHER MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. The agents, dealers or employees of BUNN are not authorized to make
modifications to this warranty or to make additional warranties that are binding on BUNN. Accordingly, statements by such individuals, whether oral or written, do not constitute warranties and should not be relied upon. If BUNN determines in its sole discretion that the equipment does not conform to the warranty, BUNN, at its exclusive op­tion while the equipment is under warranty, shall either 1) provide at no charge replacement parts and/or labor (during the applicable parts and labor warranty periods specified above) to repair the defective components, provided that this repair is done by a BUNN Authorized Service Representative; or 2) shall replace the equipment or refund the purchase price for the equipment.
THE BUYER’S REMEDY AGAINST BUNN FOR THE BREACH OF ANY OBLIGATION ARISING OUT OF THE SALE OF THIS EQUIPMENT, WHETHER DERIVED FROM WARRANTY OR OTHERWISE, SHALL BE LIMITED, AT BUNN’S SOLE OPTION AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND.
In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment, facilities or services, or any other special, incidental or consequential damages.
392, A Partner You Can Count On, Air Infusion, AutoPOD, AXIOM, BrewLOGIC, BrewMETER, Brew Better Not Bitter, Brew­WISE, BrewWIZARD, BUNN Espress, BUNN Family Gourmet, BUNN Gourmet, BUNN Pour-O-Matic, BUNN, BUNN with the stylized red line, BUNNlink, Bunn-OMatic, Bunn-O-Matic, BUNNserve, BUNNSERVE with the stylized wrench design, Cool Froth, DBC, Dr. Brew stylized Dr. design, Dual, Easy Pour, EasyClear, EasyGard, FlavorGard, Gourmet Ice, Gourmet Juice, High Intensity, iMIX, Infusion Series, Intellisteam, My Café, Phase Brew, PowerLogic, Quality Beverage Equipment Worldwide, Respect Earth, Respect Earth with the stylized leaf and coffee cherry design, Safety-Fresh, savemycoffee.com, Scale-Pro, Silver Series, Single, Smart Funnel, Smart Hopper, SmartWAVE, Soft Heat, SplashGard, The Mark of Quality in Beverage Equipment Worldwide, ThermoFresh, Titan, trifecta, Velocity Brew, Air Brew, Beverage Bar Creator, Beverage Profit Calculator, Brew better, not bitter., BUNNSource, Coffee At Its Best, Cyclonic Heating System, Daypart, Digital Brew­er Control, Element, Milk Texturing Fusion, Nothing Brews Like a BUNN, Pouring Profits, Signature Series, Sure Tamp, Tea At Its Best, The Horizontal Red Line, Ultra are either trademarks or registered trademarks of Bunn-O-Matic Corporation. The commercial trifecta® brewer housing configuration is a trademark of Bunn-O-Matic Corporation.
2
29792.1 071713
TABLE OF CONTENTS
AUGER DRIVE and HOPPER ASSEMBLY ......................................................................................................8
DOOR ASSEMBLY .........................................................................................................................................6
ELECTRICAL CONTROLS ............................................................................................................................14
HOUSING and PANELS .................................................................................................................................4
NUMERICAL INDEX ....................................................................................................................................18
SOLENOID, REGULATOR and LINES ...........................................................................................................12
WHIPPER CHAMBER and DRIVE MOTOR ...................................................................................................10
3
29792.1 060112
Push b
ack un
til fu
lly latched
b
efo
re removing o
r manually
filling c
hilled prod
uct ho
pper.
24
4
7
6
HOUSING AND PANELS
PA F
1
2
5
23
8
9
10
12
13
3
11
14
15
16
19
20
21
17
18
22
P1892
4
29792.1 060112
HOUSING AND PANELS
ITEM PART NO. QTY. DESCRIPTION
1 29595.1000 1 Cover-SST, Top (Includes item 2 & 3)
29595.1001 1 Cover-BLK, Top (Includes item 2 & 3)
01311.0000 5 Screw, Truss Head-SST #8-32 x .25"
01311.0003 5 Screw, Truss Head-BLK #8-32 x .25"
01318.0000 6 Screw, Round Head #8-32 x .50"
2 21434.0000 1 Handle, Snap-in
3 29808.0000 2 Decal, LIFT TO CLOSE (Black Letters)
29808.0001 2 Decal, LIFT TO CLOSE (White Letters)
4 29592.1002 1 Panel-SST w/Decals (Includes items 5-7 & 24)
29592.1003 1 Panel-BLK w/Decals (Includes items 5-7 & 24)
01311.0000 6 Screw, Truss Head-SST #8-32 x .25"
01311.0003 6 Screw, Truss Head-BLK #8-32 x .25"
5 00656.0001 1 Decal, COMPLIANCE TO PLUMBING
6 00986.0000 1 Decal, WARNING-ELECTRICAL
7 29780.0002 1 Schematic, Electrical
8 29604.0000 1 Panel, Hopper Motor Mounting
01311.0001 4 Screw, Truss Head, Locking #8-32 x .25"
9 29608.0000 1 Panel, Right Side
29608.0001 1 Panel, Left Side
00910.0000 6 Nut, Hex #10-32
01532.0002 6 Lockwasher, Int.-tooth
10 02536.0000 2 Grommet
11 29721.0000 2 Guide, Hopper
01393.0000 4 Screw, Truss Head #6 x .25"
12 25899.0000 2 Catch, Magnet
13 23954.0000 1 Handle
02308.0000 2 Screw, Pan Head #8-32 x .38"
14 29765.1000 1 Panel Assy.
01311.0000 4 Screw, Truss Head #8-32 x .25"
15 29606.0000 1 Panel (Includes item 22)(Also order items 16-18)
01311.0001 6 Screw, Truss Head, Locking #8-32 x .25"
16 29788.0000* 1 Decal, Main Power ON/OFF
29788.0001* 1 Decal, Main Power ON/OFF (Models w/Water Bypass)
17 29787.0000* 1 Decal, TEST/SERVICE
18 00619.0007 1 Plug, Hole
19 29610.0000 1 Panel, Bottom-SST (120V)
29610.0001 1 Panel, Bottom-BLK (120V)
29610.0002* 1 Panel, Bottom-SST (230V)
29610.0003 1 Panel, Bottom-BLK (230V)
20 29617.0002 1 Plate, Base-WHT
29617.0003 1 Plate, Base-BLK
21 29618.0002 2 Rail, Support - WHT
29618.0003 2 Rail, Support - BLK
44646.0001 4 Screw, Pan Head, Plascrew #6 x .60"
44646.0002 4 Screw, Pan Head #6 x .38"
22 34561.0000* 2 Decal, Warning PAF Lock
23 01533.0006 1 Spacer
01320.0000 1 Screw #8-32 x 1.0"
00991.0000 1 Nut
24 37881.0000 1 Decal, No Moving Parts
5
Late Models
29792.1 060112
DOOR ASSEMBLY
25 22 14 13 12 11 10
PA F
26
27
23
16
9
8
7
5
6
4
3
2
15
1
Early Models
21 22
17 18 20
19
24
STANDARD
LITED DOORS
P1893
6
29792.1 060112
Loading...
+ 12 hidden pages