Package Contents:
Main Unit (TeraStation)
Ethernet Cable
Power Cable
TeraNavigator Installation CD
Quick Setup Guide (this manual)
Warranty Card
www.buffalotech.com
Quick Setup Guide
TeraStation
Home Server
HS-DTGL/R5
v1.1
2
Step 1: Connect your Cables
Plug TeraStation’s power cord and Ethernet cable into the back of
the TeraStation. Then, connect the power plug to a power outlet.
Make sure that the power switch on the rear of the TeraStation is
in the
ON position, with the “I” symbol pressed down.
Plug the other end of the Ethernet cable into a hub, switch, or
router on the network.
Press the power button on the front of TeraStation to turn
TeraStation on.
3
Check the LINK/ACT LED on the front of the TeraStation. If it’s
lit, then your TeraStation is connected to your network. Please
turn to page 4 to continue setup.
If the LINK/ACT LED on the front of TeraStation is
not lit, your
TeraStation is not properly connected to your network. Make sure
that:
If problems persist, contact our 24/7 technical support at
(866) 752-6210
.
• Both TeraStation and the hub, switch, or PC are powered on,
• The Ethernet cable is securely fastened to both devices, and
• The Ethernet cable is not damaged. To verify, try using another
Ethernet cable.
Step 2: Check your Connection
Loading...