Brother WL-660 User Manual
English
Laser Printer WL-660 Series for Windows
®
Quick Setup Guide
First read this Quick Setup Guide to set up your printer and prepare your computer for the
printer.
CAUTION
This printer has been designed specially for Windows 3.1. It cannot work in a DOS
environment such as MS-DOS.
Action 1: Check the Supplied Items
After taking the printer out of the carton and removing the packing materials, make sure that
the following items are not damaged and none are missing:
• Printer • Multi-purpose sheet feeder
• Drum unit • Starter Toner cartridge
NOTE: This is a starter toner cartridge
—expected yield 1,000 pages.
TN-100 Replacement toner cartridge
—expected yield 3,000 pages
• 3.5” floppy disks for Windows
®
• User’s guide
• Quick setup guide (this guidebook)
NOTE
You will need to purchase an interface cable that matches the interface of your computer. If
you do not know what cable you need, consult your dealer or reseller.
The product names in this guidebook are trademarks or registered trade marks of each manufacturer. The specifications are subject to change without notice.
©1995 Brother Industries, Ltd.
UL7394001 A Printed in Japan
1
English
Action 2: Install the Toner Cartridge/Drum Unit
1
Unpack the drum unit and gently shake it
from side to side five or six times.
2
Remove the protective parts, in order, as
shown in the illustration.
CAUTION
Do not expose the drum unit to light for
longer than a few minutes, as this will
damage the drum.
3
Open the top cover. Open the drum cover
by pushing the two blue tabs in toward the
center of the unit and lifting the cover
toward you.
4
Install the drum unit into the printer.
Make sure that you grasp the ▲ marks.
2
English
5
Unpack the toner cartridge and gently rock
it from side to side well before installing.
( ① )
Then, remove the protective parts. ( ② )
CAUTION
DO NOT MOVE THE SHUTTER LEVER
UNTIL THE CARTRIDGE IS
INSTALLED.
6
Install the toner cartridge into the drum
unit. Make sure that the ▲ marks are
aligned.
7
Gently pull the blue shutter lever on the
toner cartridge forward until the red arrows
are aligned.
8
Close the drum cover ( ① ) and push gently
until it clicks into place.
Close the top cover. ( ② )
See “CHAPTER 5 MAINTENANCE” in
the User’s Guide for more information
about replacement of the toner cartridge.
3
English
Action 3: Load Paper into Your Printer
1
Install the paper support into the multipurpose sheet feeder. ( ① )
Install the sheet feeder into the printer.
( ② )
2
Open the multi-purpose sheet feeder cover.
3
Load paper into the multi-purpose sheet
feeder.
NOTE
The feeder can hold up to 200 sheets of
plain paper or up to 10 envelopes.
Excessive sheets may cause paper jams.
Make sure that the paper is stacked below
the ▲ mark.
4
Move the paper guide to fit the paper width.
4
Loading...