Brother 115VS-FOTA-KS User Manual

ML115VS-47-1A

CLINTON SERVICE GUIDE

MODEL 115VS-FOTA-KS

FOR

BROTHER B925

CUTTER ASSEMBLY

33-3712-08
DOWEL PIN

33-3108-08 (4)
SCREW

33-3108-04
SCREW

02-2645-01
FACE PLATE

30-1509-01
PLUG

33-3712-16
DOWEL PIN

NOTES:

1. REMOVE EXISTING FACE PLATE
AND RETAP (3) HOLES MARKED
"A" WITH DRILL NO.29 (30-2130-29)
AND TAP 8-32 (30-1266-01)
SUPPLIED.

2. MOUNT VERTICAL SHEAR
CUTTER WITH (3) SCREWS
33-3108-08.

3. DRILL HOLE, MARKED "B" WITH
DRILL NO.29 AND TAP 8-32,
5/16 DEEP.

4. USING HOLES MARKED "C" AS
A GUIDE, DRILL (2) HOLES 3/16"
DIAMETER BY 3/16" DEEP. 3/16"
DRILL (30-2376-12) SUPPLIED.

5. INSERT DOWEL PINS (1)
33-3712-08 UPPER SIDE, AND
(1) 33-3712-16 LOWER SIDE.

INSTALLATION & ADJUSTMENTS INSTRUCTIONS

ML115VS-47-2A

MOVABLE BLADE

NOTES:

1. ASSEMBLE MOVABLE BLADE
01-9448-01 WITH SCREWS
(2) 33-3106-04 AND LOCK
WASHERS (2) 33-1806-01.

2. DO NOT TIGHTEN MOVABLE
BLADE SCREWS AT THIS
TIME.
REFER TO ALIGNMENT
ADJUSTMENT.

33-3106-04
SCREW

33-1806-01
LOCK WASHER

01-9448-01
MOVABLE BLADE

STATIONARY BLADE

02-0501-01
GUARD

01-9447-01
STATIONARY
BLADE

33-1808-01
LOCK WASHER

33-3108-04
SCREW

NOTE:

ASSEMBLE STATIONARY
BLADE AS SHOWN.

02-2646-01
BLADE SUPPORT

33-0810-06
SCREW

RADIAL

33-3108-08
SCREW

01-3051-01
SCREW

33-3106-08
ADJUSTING SCREWS

NOTES:

1. LOOSEN SCREW 01-3051-01
AND 33-3108-08 AND ROTATE
ASSEMBLY FOR PROPER
ENGAGEMENT.

2. LOOSEN SCREWS 33-3106-08
AND ADJUST MOVABLE BLADE
AGAINST STATIONARY BLADE
AND LOCK IN PLACE.

INS-2298

ALIGNMENT

30-2489-01
SET SCREW

CHECK ALIGNMENT
BETWEEN BLADES
AND ADJUST FOR
1/32" OVERLAP

NOTE:

LOOSEN SET SCREW 30-2489-01
AND ADJUST SCREW 02-0034-01
COUNTER-CLOCKWISE FOR
MORE CUTTING EDGE
ENGAGEMENT.

INS-2299

02-0034-01
ADJUSTING
SCREW

33-3106-04
SCREW