INSTALLATION INSTRUCTIONS
360NDK DUCTLESS CONVERSION KIT FOR THRU SOFFIT VENTING
FOR USE WITH PM390SSP POWER MODULE
1.Install PM390SSP per installation instructions shipped with power module.
2.Remove aluminum filter and attach the CHARCOAL FILTER (included) to the backside of the aluminum filter with the 4 supplied metal clips.
3.Remove backdraft damper. (Damper supplied with power module.)
4.Cut hole in bottom of SOFFIT to allow clearance for the 90° ANGLE BOOT.
5.Locate top of 4¼” X 10¼” OPENING on soffit - centered on POWER MODULE CENTERLINE and 26.625” above bottom of POWER MODULE.
6.Layout 4¼” x 10¼” pattern and cut opening in soffit.
7.Connect 90° ANGLE BOOT to 6-IN. TO 7-IN. ROUND TRANSITION.
8.Insert boot end into soffit and connect 6-in. round end to the exhaust of the unit.
9.Install GRILLE (included - not shown) into soffit opening.
10.Use metal foil tape to make all connections secure and air tight.
4¼” x 10¼” SOFFIT OPENING
90° ANGLE BOOT (included)
6-IN. TO 7-IN. ROUND TRANSITION (included)
PM390SSP
POWER MODULE
CHARCOAL FILTER (included) (99010464)
OPTIONAL METAL LINER (LB30SS or LB36SS) (purchase separately)
SOFFIT
CABINET
26.625”
C
L
POWER MODULE
CENTER LINE
DIRECTIVES D’INSTALLATION
ENSEMBLE DE CONVERSION SANS CONDUIT 360NDK POUR VENTILATION PAR LA SOFFITE À UTILISER AVEC LE MODULE MOTORISÉ PM390SSP
1.Installer le module motorisé PM390SSP conformément aux directives d’installation qui l’accompagnent.
2.Retirer le filtre en aluminium et fixer le FILTRE AU CHARBON (fourni) à l’arrière du filtre en aluminium à l’aide des 4 attaches métalliques fournies.
3.Retirer le clapet antirefoulement (clapet fourni avec le module motorisé.)
4.Découper l’ouverture dans le bas de la SOFFITE pour permettre le dégagement requis pour le RACCORD COUDÉ DE 90°.
5.Repérer l’OUVERTURE DE 10,8 cm X 26 cm (4¼ po X 10¼ po) de la soffite - alignée sur la LIGNE DE
CENTRE DU MODULE MOTORISÉ et 67,6 cm (26,625 po) au-dessus du bas du MODULE MOTORISÉ.
6.Placer le gabarit de 10,8 cm X 26 cm (4¼ po X 10¼ po) et découper l’ouverture dans la soffite.
7.Connecter le RACCORD COUDÉ DE 90° à la TRANSITION RONDE DE 15,2 cm (6 po) à 17,8 cm (7 po).
8.Insérer l’extrémité du raccord dans la soffite et raccorder l’extrémité de 15,2 cm (6 po) à la sortie de l’unité.
9.Installer la GRILLE (fournie - non illustrée) dans l’ouverture de la soffite.
10.Utiliser du ruban métallique à conduit pour fixer tous les raccords et assurer leur étanchéité.
OUVERTURE DE LA SOFFITE DE 10,8 cm x 26 cm (4¼ po x 10¼ po)
RACCORD COUDÉ
DE 90° (fourni)
TRANSITION RONDE DE 15,2 cm (6 po) à 17,8 cm (7 po)
MODULE MOTORISÉ PM390SSP
FILTRE AU CHARBON (fourni) (99010464)
ENVELOPPE MÉTALLIQUE EN OPTION (LB30SS ou LB36SS) (vendue séparément)
SOFFITE
ARMOIRE
26,625 po
(67,6 cm)
C
L
LIGNE DE CENTRE DU
MODULE MOTORISÉ