ENGLISH OPERATION MANUAL
BRITEQ® 8/23 BT-GLOWPANEL
• Press [ENTER] to confirm the selected value.
• Press [MENU] to leave this mode.
• Press the [MENU] button for 2 seconds to leave the setup menu.
[SOUND MODE]
Used to set the projector to standalone sound mode with different chases playing in endless loops.
• Press the [MENU] or ▲/▼buttons until “SOUND MODE” is shown on the display.
• Press the [ENTER] button: [On] or [Off] will start blinking.
• Press the ▲/▼buttons to select the desired mode:
• [On] : fixture will operate sound activated.
• [Off] : fixture will operate at fixed speed.
• Press the [ENTER] button to select the desired mode.
• Press the [MENU] button for 2 seconds to leave the setup menu.
[SOUND SENS]
Used to set the sensitivity of the internal microphone.
• Press the [MENU] or ▲/▼buttons until [SOUND SENS] is showing on the display.
• Press the [ENTER] button: the value starts blinking and can be changed.
• Use ▲/▼ buttons to selected the desired value: 0-100
• Press the [ENTER] button to select the desired value. The selected value stops blinking.
• Press the [MENU] button for 2 seconds to leave the setup menu.
[BLACKOUT PIXELS]
Used to set the pixel mode (ON or OFF) when no DMX signal is present.
• Press the [MENU] or ▲/▼buttons until [BLACKOUT PIXELS] is showing on the display.
• Press the [ENTER] button: [Yes] or [No] will start blinking.
• Use ▲/▼ buttons to select the desired mode:
• [Yes] : white pixels will work if no DMX signal is present.
• [No] : white pixels will not work if no DMX signal is present.
• Press the [ENTER] button to select the desired value. The selected value stops blinking.
• Press the [MENU] button for 2 seconds to leave the setup menu.
[BLACKOUT RGB PAN]
Used to set the RGB panel mode (ON or OFF) when no DMX signal is present.
• Press the [MENU] or ▲/▼buttons until [BLACKOUT RGB PAN] is showing on the display.
• Press the [ENTER] button: [Yes] or [No] will start blinking.
• Use ▲/▼ buttons to select the desired mode:
• [Yes] : the RGB panels will work if no DMX signal is present.
• [No] : the RGB panels will not work if no DMX signal is present.
• Press the [ENTER] button to select the desired value. The selected value stops blinking.
• Press the [MENU] button for 2 seconds to leave the setup menu.
[BACK LIGHT]
Used to set the back light of the display.
• Press the [MENU] or ▲/▼buttons until [BACK LIGHT] is showing on the display.
• Press the ▲/▼buttons to select the desired mode:
• [On] : the display will stay on.
• [Off] : the display will turn off after some time. (+/- 1 min.)
• Press the [ENTER] button to select the desired mode.
• Press the [MENU] button for 2 seconds to leave the setup menu.
[AUTO TEST]
Used to run a selftest on the fixture.
• Press the [MENU] or ▲/▼buttons until [AUTO TEST] is showing on the display.
• Press the [ENTER] button: [Test…] starts blinking. The fixture runs a continuous test.
• Press the [ENTER] or [MENU] button to stop the test.
• Press the [MENU] button for 2 seconds to leave the setup menu.