BriskHeat SRP18181P, SRP18181PADJB, SRP18182P, SRP12362PADJB, SRP12361P Instruction Manual

Silicone Rubber Heating

Blankets

Specially designed for Cole-Parmer and Davis Instruments

Cole-Parmer

625 E. Bunker Court

Vernon Hills, IL 60061

Phone: [phone]

Fax: [phone]

PN: 11661-02 Rev B

Instruction Manual

Read and understand this material before operating or servicing these heaters. Failure to understand how to safely operate these heaters could result in an accident causing serious injury or death. These heaters should only be operated by qualified personnel.

Silicone Rubber Heating Blankets
TABLE OF CONTENTS
Introduction...................................................................	2
Safety Alert Symbol.......................................................	2
Important Safety Instructions……………...................... 3
Prior to Installation........................................................	4
Mounting Your Heating Blanket…………...................... 5
Connecting Your Heating Blanket to a Power Source...	6
Troubleshooting Guide…………………………….......... 7
Warranty........................................................................	BACK

INTRODUCTION

Thank you for purchasing a BriskHeat® Silicone Rubber Heating Blanket. Your heater is designed

to provide a long and efficient service life with function, reliability, and safety in mind. For additional information concerning this, or other Cole-Parmer products, please contact us toll free at 1-800-323-4340.

SAFETY ALERT SYMBOL

The symbol above is used to call your attention to instructions concerning your personal safety. It points out important safety precautions. It means

“ATTENTION! Become Alert! Your Personal Safety is involved!” Read the message that follows and be alert to the possibility of personal injury or death.

Immediate hazards which WILL result in severe personal injury or death

Hazards or unsafe practices which COULD result in severe personal injury or death

Hazards or unsafe practices which COULD result in minor personal injury or property damage.

SAVE THESE INSTRUCTIONS!

Additional copies of this manual are available upon request.

2

Silicone Rubber Heating Blankets

TROUBLESHOOTING GUIDE

Please read this guide prior to contacting Cole-Parmer. This guide is designed to answer the most commonly asked questions. If you are unable to identify the problem or need additional assistance, please contact Cole-Parmer at

1-800-323-4340.

PROBLEM	SOLUTION(S)
Does not heat	Verify heater is connected to proper voltage.
	Check to see if there is a resistance reading (not an
	open circuit) in heater using an ohm meter.
Pressure sensitive adhesive is not	Ensure there are no air gaps and heater is making
adhering	intimate contact with surface being heated. Use a
	medium to hard rubber roller.
Circuit breaker is tripping	Validate that the circuit breaker is capable of handling
	the amp requirement of heater. The identification
	label located on the power cord displays the heater’s
	amperage requirement.
	Examine heater and cord for any damage.
	Check to see if there is a resistance reading between
	power leads and the ground lead.

7