Brickcom VD-H200Np-WDRpro, VD-502Ae V6, VD-500Ap-V6-Kit, VD-300Np-Star-Kit, VD-202Ne V6 Installation Manual

1

Easy Installation Guide

Megapixel Day & Night

Vandal Dome Network Camera

Vandal Dome Series

English

2

Step 1. Check Package Contents

a. Network Camera (Vandal Dome series)

b. Dry Bag, Strap Tie

c. Product CD

d. Location Sticker

e. Warranty Card

f. Screw Bag

g. Terminal Block

h. Allen Key

i. Easy Installation Guide

j. High Power PoE (Optional)

k. Wall-Mount Bracket: L-WM-01(Optional)

l. Waterproof Connector: WPC-EU (M20)/

WPC-US (3/4’’) (Optional)

3

Step 2. Hardware Installation

Do not mount the camera on any soft material. The camera may fall and be
damaged.

A compliant waterproof connector shall be attached tightly to the conduit hole
of the Vandal Dome Network Camera, and all the cables shall run through the
connector for the camera to be IP67-compliant.

This document is for the easy installation purpose only; please refer to the user
manual for more details.

I. Open The Vandal Dome Camera:

Use the Allen Key to unscrew the four screws and remove the dome cover from the camera device.

4

II. Open/Close The Conduit Hole:

Waterproof Connector

The conduit hole allows the air to circulate through the camera device. By default, a lid is attached to
the conduit hole on the side of the camera device, and the conduit hole on the bottom of camera
device is open. Please use the screw driver to screw/ unscrew the lid. Please note that the lid and
the waterproof connector must be tightly screwed to the conduit hole to achieve IP67.

III. PoE, Power, DIDO, Audio Connection

Put all the cables, such as PoE , 12VDC power , DI / DO / Audio cable , together as one
single cable and run it through the waterproof connector. Then attach the waterproof connector to

the conduit hole or , and attach the lid tightly to the other hole. All cables are user-supplied.