Breville BES875, SES875 Instruction Manual

the Barista Express

BES875/SES875

™

QUICK GUIDE

Contents

2 Sage 6 Components 8 Functions 14 Care & Cleaning 18 Troubleshooting 21 Guarantee

Recommends Safety First

SAGE® RECOMMENDS SAFETY FIRST

At Sage® we are very safety conscious. We design and manufacture appliances with your safety foremost in mind. We also ask that you exercise a degree of care when using any electrical appliance and adhere to

the following precautions.

READ ALL INSTRUCTIONS BEFORE USE AND SAVE FOR FUTURE REFERENCE

• A downloadable version of this document is also available at sageappliances.com

• Before using for the rst time, please ensure that your electricity supply is the same as shown on the rating label on the underside of the appliance. If you have any concerns please contact your local electricity company.

• The installation of a residual current safety switch is recommended to provide additional safety when using all electrical appliances. Safety switches with a rated operating current not more than 30mA are recommended. Consult an electrician for professional advice.

• Remove and discard any packaging materials safely,

before rst use.

• To eliminate a choking hazard for young children, discard the

protective cover tted to the

power plug safely.

• Ensure the product is properly

assembled before rst use.

• This appliance is for household use only. Do not use the appliance for anything other than its intended purpose. Do not use in moving vehicles or boats. Do not use outdoors. Misuse may cause injury.

• Position the appliance on a stable, heat resistant, level, dry surface away from the counter edge, and do not operate on or near a heat source such as a hot plate, oven or gas hob.

• Fully unwind the power cord before operating.

• Do not let the power cord hang over the edge of a counter or table. Do not let the power cord touch hot surfaces or become knotted.

• Do not leave the appliance unattended when in use.

• If the appliance is to be:

- left unattended

- cleaned

- moved

- assembled; or

- stored

Always switch o the espresso

machine by pressing the POWER button to OFF. Switch o and unplug from the power outlet.

• Regularly inspect the power cord, plug and actual appliance for any damage. If found to be damaged in any way, immediately cease use of the appliance and return the entire appliance to the nearest authorised Sage Service Centre for examination, replacement or repair.

• Keep the appliance and accessories clean. Follow the cleaning instructions provided in this book. Any procedure not listed in this instruction booklet should be performed at an authorised Sage Service Centre.

• The appliance can be used by children aged 8 or older and persons with reduced physical, sensory or mental capabilities or a lack of experience and knowledge, only if they have been given supervision or instruction concerning use

of the appliance in a safe way and understand the hazards involved.

• Children should not play with the appliance.

• Cleaning of the appliance should not be carried out by children unless they are 8 years or older and under adult supervision.

• The appliance and its cord should be kept out of reach of children aged 8 years and younger.

• Do not use attachments other than those provided with the appliances.

• Do not attempt to operate the appliance by any method other than those described in this booklet.

• Do not move the appliance whilst in operation.

• Do not use any other liquid apart from cold mains/town water. We do not recommend the use of highly ltered, de-mineralised or distilled water

as this may aect the taste of the coee and how the espresso

machine is designed to function.

• Never use the appliance without water in the water tank.

• Ensure the portalter is rmly inserted and secured into the brewing head before using the machine.

• Never remove the portalter during the brewing operation as the machine is under pressure.

• Do not place anything, other than cups for warming, on top of the appliance.

• Use caution when operating machine as metal surfaces are liable to get hot during use.

• Do not touch hot surfaces. Allow the product to cool down before moving or cleaning any parts.

• Heating element surface is subject to residual heat after use.

• Always ensure the appliance is turned OFF, unplugged at the power outlet and has been allowed to cool before cleaning, attempting to move or storing.

• The appliance is not intended to be operated by means of an external timer or separate remote-control system.

• The use of attachments not sold or recommended by

Sage may cause re, electric

shock or injury.

• Always turn the appliance to

the o position, switch o at

the power outlet and unplug at the power outlet when the appliance is not in use.

• Any maintenance other than cleaning should be performed by an authorised

Sage

service centre.

• Do not use the appliance on a sink drain board.

• Do not operate the appliance if it is in an enclosed space, or within a cupboard.

• Use caution when descaling as hot steam may be released. Before descaling, ensure drip tray is empty and inserted. Refer to ‘Care & Cleaning’ for further instructions.

• Do not operate the grinder without the hopper lid in position. Keep ngers, hands, hair, clothing and utensils away from the hopper during operation.

SPECIFIC INSTRUCTIONS FOR WATER FILTER

• Filter cartridge should be kept out of reach of children.

• Store lter cartridges in a dry place in the original packaging.

• Protect cartridges from heat and direct sunlight.

• Do not use damaged

lter cartridges.

• Do not open lter cartridges.

• If you are absent for a prolonged period of time, empty the water tank and replace the cartridge.

The symbol shown

indicates that this appliance should not be disposed of

in normal household waste. It should be taken to a local authority waste collection centre designated for this purpose or to a dealer providing this service. For more information, please

contact your local council oce.

To protect against electric

shock, do not immerse the power cord, power plug or appliance in water or any other liquid.

FOR HOUSEHOLD USE ONLY SAVE THESE INSTRUCTIONS

Components

```

A. 250g bean hopper

B. Integrated conical burr grinder

C. Grind outlet

D. Grinding activation switch

E. Hands free grinding cradle

F. GRIND SIZE selector

G. GRIND AMOUNT dial

H. FILTER SIZE button

I. POWER button

J. Integrated removable 54mm tamper

K. Group head

L. 54mm stainless steel portalter

M. Extra-tall cup clearance for tall mugs

N. Removable wet & dry coee separator

drip tray

O. Storage tray (located behind drip tray)

P. 360˚ swivel-action steam wand

Q. Dedicated hot water outlet

R. Steam/Hot Water dial

S. Steam/Hot Water light

T. 1 CUP and 2 CUP buttons

U. CLEAN ME light

V. Espresso pressure gauge

W. Programme button

Re-programs the preset 1 CUP and 2 CUP shot volumes.

X. Cup warming tray

Y. 2L removable water tank

ACCESSORIES

1. Temp Control

2. Cleaning disc

3. Cleaning tablets

4. Dual Wall lter baskets (1 cup & 2 cup) Use with pre-ground coee.

5. Single Wall lter baskets

(1 cup & 2 cup) Use when grinding fresh

whole coee beans

™

Milk Jug

6. Water lter holder and lter

7. Cleaning brush

8. The Razor

9. Cleaning tool

10. Allen key

™

precision dose trimming tool

Rating Information

220–240V~ 50Hz 1560–1850W

Functions

INSTALLING THE WATER FILTER

• Remove the water lter and water lter holder

from the plastic bag.

• Soak the lter in cold water for 5 minutes.

• Wash the lter holder with cold water.

• Set the reminder for next month of replacement.

We recommend to replace the lter after 3 months.

• Fill the water tank with cold water before sliding back into position at the back of the machine and locking into place.

FIRST USE

• Ensure the water lter is securely tted inside the water tank.

• Fill the water tank with cold, preferably ltered

water up to the MAX mark.

• Ensure the hopper is locked into position.

• Plug the power cord into a 230V power outlet. Press the POWER button to switch the machine

on. The POWER button light will ash while the

machine is heating.

NOTE

If the hopper is not correctly locked into position,

the FILTER SIZE LED’s will ash.

1. Press 2 CUP button to run hot water through the group head.

2. Position the steam wand tip over the drip tray. Rotate the STEAM / HOT WATER dial to the STEAM position and run steam through the steam wand for 10 seconds.

• Insert the lter into the two parts of the lter holder.

• To install the assembled lter holder into the water tank, align the base of the lter holder

with the adapter inside the water tank. Push down to lock into place.

3. Rotate the STEAM/HOT WATER dial to the HOT WATER position and run water through the hot water outlet for 10 seconds.

4. Repeat steps 1-3 until the water tank is empty.

+ 16 hidden pages