Braun WaterFlex WF2s User Manual

WaterFlex
Type 5760
5760
www.braun.com
WF2s
6
11
English 14
Braun GmbH Frankfurter Straße 145 61476 Kronberg/Germany www.braun.com www.service.braun.com
96641300/I-14 China/Korea/GB
1
2
3 4
5
6
7
8
9
10
4
90°
c
l
e
a
n
l
o
w
clea
n
l
ow
cle
an
lo
w
ff
f
u
l
l
cle
a
n
l
o
w
c
lea
n
lo
w
c
l
e
a
n
low
f
ull
s
e
n
s
i
t
i
v
e
o
n
o
5
1 2 3 4 5 / 6 7 8
8
8
9
10
5°C 35°C
15°C 35°C
50°C
9
6
40
7
6
1
/ 5
4
1.
2. 90°
3.
3
5-10
1
18
51B
7
5760
www.braun.com/register
510730
Braun
Braun GmbH
8
9
10
11
12
13
English
Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun Shaver.
Read these instructions completely, they contain safety information. Keep them for future reference.
Cleaning and user maintenance should not be made by children unless they are older than 8 years and supervised.
Description
Warning
Your shaver is provided with a special cord set, which has an integrated Safety Extra Low Voltage power supply. Do not exchange or tamper with any part of it, otherwise there is risk
1 Shaver foil 2 Cutter block 3 Foil release buttons 4 Long hair trimmer 5 On/off switch 6 Charging light 7 Low-charge light 8 Shaver power socket 9 Special cord set 10 Protection cap
of electric shock. Only use the special cord set provided with the appliance.
Do not shave with a damaged foil or cord.
This appliance is suitable
for cleaning under running
water and use in a bath or shower. For safety reasons it can only be operated cordlessly.
This appliance can be used by children aged from 8 years and above and persons with reduced
Charging
Recommended ambient temperature for charging is 5 °C to 35 °C. The battery may not charge properly or at all under extreme low or high temperatures. Recommended ambient temperature for shaving is 15 °C to 35 °C. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time.
• Using the special cord set (9), connect
the shaver to an electrical outlet with the motor switched off and charge it for at least one hour.
• A full charge provides up to 45 minutes
of cordless shaving time. This may vary according to your beard growth.
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the safe use of the appliance and understand the hazards involved. Children should not play with the appliance.
14
Charging lights
During charging or when using the shaver, the charging light (6) will blink green. When fully charged, it will light up continuously, provided the shaver is switched on or connected to an electrical outlet.
The red low-charge light (7) flashes when the battery is running low. You should be able to finish your shave.
Shaving
Press the on/off switch (5) to operate the shaver.
Long hair trimmer
To trim sideburns, moustache or beard, slide the long hair trimmer (4) upwards.
Tips for the perfect dry shave
For best shaving results, Braun recom­mends you to follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your skin.
3. Stretch your skin and shave against the direction of your beard growth.
The following quick cleaning is another alternative cleaning method:
• Press the foil release buttons (3) to lift
the shaver foil (do not remove the foil completely). Switch on the shaver for approx. 5–10 seconds so that the shaved stubbles can fall out.
• Switch off the shaver. Remove the
shaver foil and tap it out on a flat surface. Using a brush, clean the inner area of the shaver head. However, do not clean the shaver foil nor the cutter block with the brush as this will damage them.
Keeping your shaver in top shape
Replacing the shaver foil and cutter block
To maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn.
Cleaning
Regular cleaning ensures better shaving performance. Rinsing the shaver head under running water after each shave is an easy and fast way to keep it clean:
• Press the foil release buttons (3) to lift the
shaver foil. Do not remove the shaver foil completely.
• Switch the shaver on (cordless) and
rinse the shaver head under hot running water until all residues have been removed. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
• Next, switch off the shaver and remove
the shaver foil (1). Then leave the disassembled shaving parts to dry.
• If you regularly clean the shaver under
water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil.
Accessories
Available at your dealer or Braun Service Centres:
Shaver foil and cutter block: 51B
Environmental notice
This product contains rechargeable batteries. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country.
Subject to change without notice.
For electric specifications, see printing on the special cord set.
15
Loading...