Braun P80, P40, P70, P60, P90 User Manual

P 90/P 80/P70
P60
P50
P40

English 3

5

Type 5609

Type 5608

Type 5607

Type 5604

98636088/IV-08
GB/China

145

2

open

3

close

6

7

4

a

c

click!

close

open

click!

b

close

open

close

open

de

close

f

g

h

i

English

Batteries

Two 1.5 volt batteries.
For best performance, use alkaline
manganese batteries (type LR 6, AM 3, MN
1500 or size AA alkaline, e. g. Duracell
These batteries provide a shaving capacity
of approx. 60 minutes.
To open the battery cover (6), turn it 90° as
shown in (c). Insert batteries with the poles
in the direction marked. Before closing the
battery compartment, make sure the cover
is dry and clean.

Note: Never leave batteries in the shaver
for long periods of time when the shaver is
not in use (danger of leakage). Take empty
batteries out of the shaver immediately.
To protect the environment, dispose
of empty batteries at your retail store
or at appropriate collection sites
according to national or local regulations.

This appliance is suitable for use
in a bath or shower. When using it
in a shower, we recommend that

you apply shaving foam or gel.

Shaving

Turn the twisting protective cap (4) (a) until
it clicks in place as shown (b). To switch the
shaver on, push the on/off switch (3) up.

Long hair trimmer

(P90, P80, P 70 and P60 models only)
Use the extendable long hair trimmer (5) for
exact trimming of side burns and mous­taches. To operate, slide the long hair
trimmer to the right (e) and turn on the
appliance. After use, slide it back until it
engages.

®

).

Cleaning and maintenance

For optimum shaving performance, clean
the shaver after each use:

g under running water

Cleanin
Turn on the shaver and hold the shaver
head under warm running water (f). You
may also use liquid soap. Rinse off all foam
and let the shaver run for a few more
seconds. Then turn it off and remove the
shaver foil (1) as shown (g) and let it dry.
If you often clean your shaver under
running water, put a drop of light machine
oil onto the shaver foil.

g with the brush

Cleanin
Remove the shaver foil (1) and tap it gently
against a flat surface. Then thoroughly
clean the cutter block (2) with the brush (7)
as shown in (i). Do not clean the shaver foil
with the brush as this may damage it.

3