Braun M-30, M-60 User Manual

99505147/III-10
GB/China

145

2

open

3

close

6

7

4

a

c

click!

close

open

click!

b

close

open

close

open

de

close

f

g

h

i

English

Please read the use instructions carefully
and thoroughly before using the appliance.

Warning

This appliance is not intended for use by
children or persons with reduced physical,
sensory or mental capabilities, unless
they are given supervision by a person
responsible for their safety. In general, we
recommend that you keep the appliance
out of reach of children. Children should be
supervised to ensure that they do not play
with the appliance.

Batteries may leak if empty or not used for
a longer time. In order to protect you and
the appliance, please remove batteries in a
timely manner and avoid skin contact
whilst handling leaking batteries.

Batteries

Two 1.5 volt batteries.
For best performance, use alkaline
manganese batteries (type LR 6, AM 3, MN
1500 or size AA alkaline, e. g. Duracell
These batteries provide a shaving capacity
of approx. 60 minutes.
To open the battery cover (6), turn it 90° as
shown in (c). Insert batteries with the poles
in the direction marked. Before closing the
battery compartment, make sure the cover
is dry and clean.

This appliance is suitable for use
in a bath or shower. When using it
in a shower, we recommend that

you apply shaving foam or gel.

Shaving

Turn the twisting protective cap (4) (a) until
it clicks in place as shown (b). To switch the
shaver on, push the on/off switch (3) up.

Long hair trimmer

(M-90 only)
Use the extendable long hair trimmer (5) for
exact trimming of side burns and mous­taches. To operate, slide the long hair
trimmer to the right (e) and turn on the
appliance. After use, slide it back until it
engages.

Cleaning and maintenance

For optimum shaving performance, clean
the shaver after each use:

g under running water

Cleanin
Turn on the shaver and hold the shaver
head under warm running water (f). You
may also use liquid soap. Rinse off all foam
and let the shaver run for a few more
seconds. Then turn it off and remove the
shaver foil (1) as shown (g) and let it dry.
If you often clean your shaver under
running water, put a drop of light machine
oil onto the shaver foil.

3

®

).