Braun 5790, Flex XPII 5790, 5722, 5325 User Manual
5790
start • stop
5790
clean
www.braun.com
min
min
Type
Modéle
Modelo
5 722 + 5325
English 6
Français 12
Español 18
Thank you for purchasing a Braun product.
We hope you are completely satisfied with
your new Braun shaver.
If you have any questions, please call:
US residents 1-800-BRAUN-11
1-800-272-8611
Canadian residents 1-800-387-6657
Merci d’avoir fait l’achat d’un produit Braun.
Nous espérons que vous serez pleinement
satisfait de votre nouveau rasoir Braun.
Si vous avez des questions, veuillez appeler
Braun Canada : 1-800-387-6657
Gracias por haber comprado un producto
Braun.
Esperamos que Ud. quede completamente
satisfecho con su nueva afeitadora Braun.
Si Ud. tiene alguna duda, por favor llame al:
01(800) 508-5800
Internet
www.braun.com
5-722-300/00/VI-05/G2
USA / CDN / MEX
Printed in Germany
Imprimé en Allemagne
Impreso en Alemania
A 5790
1
2
5000
6000
Series
100%
100%
stop
•
start
2
3
Flex Integral / Flex XP
1
5000
4
start • stop
5
5790
6
clean
7
6000
Series
8
• stop
rt
oil
B Clean & Renew™
1
3
2
2
new
1
4
5
old
new
English
IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliance, basic precautions should always be
followed, including the following:
Read all instructions before using this appliance.
DANGER
To reduce the risk of electric shock:
1. Do not reach for an appliance that has fallen into water.
Unplug immediately.
2. Do not use while bathing or in a shower when the appliance is connected to
an electrical outlet.
3. Do not place, store or charge the appliance where it can fall or be pulled
into a tub or sink. Do not place in or drop into water or other liquid.
4. When not using for a longer period of time, unplug this appliance from the
electrical outlet.
5. Unplug this appliance before cleaning.
6. This appliance is provided with a special cord set with integrated Safety Extra
Low Voltage power supply. Therefore, you must not exchange or manipulate
any part of it.
FOR HOUSEHOLD USE
SAVE THESE INSTRUCTIONS
6
WARNING
To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Close supervision is necessary when this appliance is used by, on, or near
children or invalids.
2. Use this appliance only for its intended use as described in this manual.
Do not use attachments not recommended by the manufacturer.
3. The appliance should never be exposed to temperatures of less than
32 ºF / 0 ºC and more than 105 ºF/+ 40 ºC for longer than a few hours.
Be sure to completely dry appliance after use. Keep cord and adapter dry at
all times. Do not store in a damp environment. To avoid damage do not wind
the cord around the appliance. It is important to check the cord for damage
periodically particularly at each end where the cord enters the plug.
4. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water.
Return the appliance to a service center for examination and repair.
5. Keep the cord away from heated surfaces.
6. Never drop or insert any object into any opening.
7. Do not use outdoors or operate where aerosol (spray) products are being
used or where oxygen is being administered.
8. Do not use this appliance with a damaged or broken foil, as serious facial
injuries may occur.
9. Always attach plug to appliance first, then to outlet.
To disconnect, turn all controls to «off», then remove plug from outlet.
7
A The Shaver
Description
1 Shaver foil
2 Cutter block
3 Release button
4 On/off switch
5 Long hair trimmer
6 Charging light (green)
7 Cleaning light (yellow)
8 Special cord set
Charging the shaver
• Using the special cord set, connect the
shaver to an electrical outlet. Allow it to
charge for at least 8 hours. During charging
shaver and special cord set might get
warm.
• With normal use the shaver will be charged
automatically after every cleaning in the
Clean&Renew™ (see section B).
• The green charging light indicates that the
shaver is being charged.
• A full charge will give up to 40 minutes of
cordless shaving time depending on your
beard growth. However, the maximum
battery capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for
charging is 60 °F to 95 °F / 15 °C to 35 °C.
• When fully discharged, you may also shave
with the shaver connected to an electrical
outlet via the special cord set.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically
adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it
allows the controlled trimming of moustache
or sideburns.
Tips for the perfect shave
• It can take up to 14-21 days for your beard
o adjust to the new shaving system.
t
• Shave before washing your face or taking a
shower, as skin tends swell after washing.
• The dryer the skin, the closer the shaving
results will be.
• Hold the shaver at right angles (90°) to the
skin. Stretch your skin and shave against
the direction of beard growth.
• To maintain 100% shaving performance,
replace your foil and cutterblock every
18 months or when worn.
Keeping your shaver in top
shape
Cleaning indicator
Your shaver should be cleaned daily in the
Clean&Renew™, and certainly when the yellow
cleaning light shines constantly after shaving. If
this is not done, the yellow light will go out after
some time. The shaver‘s electronics will then
assume it has been cleaned manually and a
new calculation of the time when the next
cleaning is required will be started.
During the cleaning process in the
Clean&Renew™ the yellow light will flash and
go off after approx. 4 hours when cleaning is
finished.
Automatic cleaning
Once the shaver is put into in the
Clean&Renew™, it is cleaned automatically
(see section B). Manual cleaning is
recommended only when the Clean&Renew™
is not available, e.g. when traveling.
Manual cleaning
Remove the shaver foil (shaver head must be
in central position) and, using the brush, clean
the cutter block and the inner area of the
shaver head. Do not clean the shaver foil with
the brush.
When cleaning the shaver under running
water, make sure it is completely dry before
putting it into the Clean&Renew™.
8
Loading...