Braun 5763, 5765, 5761 User Manual

Page 1
5765
start • stop
washable
5765
5763 5761
5765/5763/5761
BS 5 765 BS 5 763
BS 5 761
Flex XPII
Page 2
23456
Page 3
Page 4
Page 5
Page 6
Page 7
1
2
5
5765/63/61
start • stop
5765
washable
3
4
6
7
7
Page 8
Wet
&
start • stop
5765
washable
8
Page 9
9
Page 10
rt • stop
10
Page 11
11
Page 12
start • stop
oil
12
Page 13
start • stop
13
Page 14
141516Cd171819
Page 15
Page 16
Page 17
Page 18
Page 19
Page 20
1
2
2
start • stop
1
3
F/C590S
4
start • stop
5765
5
Wet & Dry
6
8
7
stop
• rt
oil
20
Page 21
English
Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun shaver.
goes off. If later on, the charging light comes again, this indicates that the shaver is being recharged to maintain its full capacity.
Warning
Your shaver is provided with a low voltage adapter. Therefore you must not exchange or manipulate any part of it. Otherwise there is a risk of electric shock.
Description
1 Shaver foil 2 Cutter block 3 Release button 4 On/off switch 5 Long hair trimmer 6 Charging light (green) 7 Special power supply cord set
Charging the shaver
• When charging for the first time power supply cord set, connect the shaver to the mains with the motor switched off. Charge it for at least 4 hours (special cord adapter and shaver might get warm). Once the shaver is completely charged, shave until fully discharged. Then recharge to full capacity again.
• A full charge will give up to 40 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles.
• Best environmental temperature range for charging is 15 °C to 35 °C.
• When fully discharged, you may also shave with the shaver connected to the mains via the power supply cord set.
: Using the
Indicator lights
The green charging light shows that the shaver is being charged. When the recharge­able battery is fully charged, the charging light
Shaving
Turn on the shaver («start»): The pivoting cutting system automatically adjusts to every contour of your face.
Trimmer: When the long hair trimmer is activated, it allows the controlled trimming of moustache or sideburns.
Tips for the perfect shave
• We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.
• Hold the shaver at right angles (90°) to the skin. Stretch your skin and shave against the direction of beard growth.
• To maintain 100% shaving performance replace your foil and cutterblock every 18 month or when worn.
Cleaning
Always unplug the appliance before cleaning.
Regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under hot running water is an easy and fast way to keep it clean:
Switch the shaver on (cordless) and rinse
the shaving head under hot running water. A natural based soap may also be used provided it contains no particles or abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
Next switch the shaver off and press the
release button (shaver head must be in central position). Lift the shaver foil off and pull the cutter block out. Then leave the disassembled shaving parts to dry.
21
Page 22
Alternatively, you may clean the shaver using the brush provided.
Switch the shaver off. Press the release
button and lift shaver foil off.
Using the brush, clean the cutter block and
the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil.
Keeping your shaver in top shape
About every four weeks, clean the cutter block with Braun cleaning agents. Put a drop of light machine oil onto the long hair trimmer and the shaver foil.
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (through normal use) every 6 months approximately. Then recharge the shaver to full capacity. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time.
Replacing the shaving parts
To maintain 100% shaving performance, re­place your foil and cutter block every 18 months or when worn. Change both parts at the same time for a closer shave with less skin irritation. (Shaver foil and cutter block: part no. 590S black)
Subject to change without notice.
This product conforms to the European Directives EMC 2004/108/EC and Low Voltage 2006/95/EC.
For electric specifications, see printing on the special cord set.
Environmental notice
This product contains rechargeable batteries. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country.
22
Page 23
23
Page 24
5-725-452/00/X-07 Japan/GB
Loading...