cruZer
Stapled booklet, 105x148 mm, 20 p (incl. 8 p cover), 2/2c = cyan + black
cruZer
beard&head
6
cruZer
5
beard
6
12
English 16
Braun GmbH
Frankfurter Straße 145
61476 Kronberg/Germany
www.braun.com
www.service.braun.com
92010245/IX-11
China/Korea/GB
1a
1c
8
1b
STOP
1c
2
3*
9
6
4*
7
1h
1
8h
5
a
click!
4
b
c
e
f
h
5
d
click!
g
i
oil
l
oi
678
1
2
4
6
3
5
7
Ni-MH
9
10111213141516
English
Our products are designed to meet the highest standards of quality,
functionality and design. We hope you entirely enjoy your new Braun
product.
Warning
• The appliance is provided with a special cord set with an integrated Safety
Extra Low Voltage power supply. Do not exchange or manipulate any part
of it. Otherwise there is risk of electric shock.
• Never use the appliance with damaged trimmers or special cord set.
• This appliance is not intended for use by children or persons with reduced
physical, sensory or mental capabilities, unless they are given supervision by a person responsible for their safety. In general, we recommend
that you keep the appliance out of reach of children. Children should be
supervised to ensure that they do not play with the appliance.
Oil bottle
Keep out of reach of children. Do not swallow. Do not apply to eyes.
Dispose of properly when empty.
Description
1a Beard comb for trimming beard and short hair
1b Hair comb for cutting hair (model cruZer6 beard&head only)
1c Release buttons for comb
2 Wide trimmer (32 mm)
3 Precision trimmer (16 mm) (model cruZer6 beard&head only)
4 Release button precision trimmer
5 Charge Indicator
6 Length selector
7 On/off switch
8 Special cord set
9 Pouch (model cruZer6 beard&head only)
Charging
The best environmental temperature for charging is between 15 °C and
35 °C. Do not expose the appliance to temperatures higher than 50 °C for
extended periods of time.
• Using the special cord set (8), connect the appliance to an electrical
outlet with the motor switched off.
• When charging for the first time or when the appliance is not used for
a few months, leave the appliance to charge continuously for 4 hours
(model cruZer5 beard: about 8 hours).
• Once the appliance is completely charged, discharge it through normal
use. Then recharge to full capacity. Subsequent charges will take about
1 hour (model cruZer5 beard: about 8 hours).
• A full charge provides up to 40 minutes of cordless operating time.
This may vary according to your beard growth.
• Maximum battery capacity will only be reached after several charging/
discharging cycles.
Charge Indicator (5)
Model cruZer6 beard&head:
• The charge indicator shows the status of the batteries.
• The charge indicator blinks green when the appliance is being charged.
When the battery is fully charged, the charge indicator shines permanently
green provided the appliance is connected to an electrical outlet.
• During cordless use the charge indicator blinks green.
• The charge indicator flashes red when the battery is running low. You
should be able to finish your current trimming sequence.
Model cruZer5 beard:
• The charge indicator shines permanently green provided the appliance is
connected to an electrical outlet.
Comb attachments (1a, 1b)
• The combs can be taken off by pressing the release buttons (1c) with
your thumb and forefinger.
Beard trimming
• Place the beard comb (1a) on the appliance with the appliance turned off
(a).
• Press length selector (6) and slide the beard comb up to your desired
beard length (possible length settings: 1, 3, 5, 7, 9, 11 mm).
• It is advisable to begin with the highest setting and then reduce the
setting until you reach the desired beard length.
• Press the on/off switch (7). Hold the beard comb with the angled edge
against your beard and guide the trimmer against the direction of the hair
growth (a).
• To avoid clogging the beard comb with hair, clean it from time to time with
the brush.
17
Contour Trimming / Styling
• The wide trimmer (2) evenly cuts and trims large areas. It is ideal for
shaping sideburns, moustaches and partial short beards. Take off the
comb. While stretching the skin, guide the wide trimmer against the
direction of hair growth (b).
• The precision trimmer (3) (model cruZer6 beard&head only) precisely
defines lines and edges and is ideal for precise contouring. To use the
precision trimmer, press the release button (4) and slide it up (c).
Hair cutting (model cruZer6 beard&head only)
The hair should be clean, well combed, tangle-free and dry.
• Place the hair comb (1b) on the appliance with the appliance turned off (d).
• Press the length selector (6) and slide the hair comb up to your desired
hair length (possible length settings: 10, 12, 14, 16, 18, 20 mm). If you are
not used to clipping hair, begin with a highest setting and then reduce the
setting to avoid cutting more hair than desired. If you want to cut your hair
shorter than 10 mm, we advise to first cut it with the hair comb (1b) down
to 10 mm and then use the beard comb for the desired length.
• Use a slow and controlled movement. Do not force the appliance through
the hair faster than it can be cut.
• In between, shake or blow off the hair. If too much hair is caught in the
comb, remove and clean it.
Cleaning
The appliance is suitable for cleaning under running tap water.
Warning: Detach the appliance from the power supply before
cleaning it with water.
Regular cleaning ensures better trimming performance.
Cleaning with the brush
• Switch off the appliance. Open the wide trimmer by pressing with the
thumb against the trimmer from the front side. It opens by ca. 45° and can
also be taken off (h).
• Using the brush clean the trimmers and the space behind the wide
trimmer (inside the housing).
Cleaning with water
• Switch off the appliance and rinse the head and trimmers under warm
running water. You can also rinse the opened wide trimmer.
• Leave the appliance with opened wide trimmer to dry.
18
Keeping your appliance in top shape
To keep the cutting system working properly, oil it with light machine oil
after each use (i).
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the
appliance has to be fully discharged (by trimming/cutting) every 6 months
approximately. Then recharge the appliance to full capacity.
Environmental notice
This product contains rechargeable batteries. In the interest of
protecting the environment, please do not dispose of the product in
the household waste at the end of its useful life. Disposal can take
place at a Braun Service Centre or at appropriate collection points
provided in your country.
Subject to change without notice.
For electric specifications, see printing on the special cord set.
19
Loading...