Thank you for purchasing a Braun product.
We hope you are completely satisfied with
your new Braun shaver.
If you have any questions, please call:
US residents 1-800-BRAUN-11
1-800-272-8611
Canadian residents 1-800-387-6657
Merci d’avoir fait l’achat d’un produit Braun.
Nous espérons que vous serez pleinement
satisfait de votre nouveau rasoir Braun.
Si vous avez des questions, veuillez appeler
Braun Canada : 1-800-387-6657
Gracias por haber comprado un producto
Braun.
Esperamos que Ud. quede completamente
satisfecho con su nueva afeitadora Braun.
Si Ud. tiene alguna duda, por favor, en México,
llame al: 01(800) 508-5800
5-100-212/02/III-03/G2
USA/CND/MEX
Printed in Germany
Imprimé en Allemagne
Impreso en Alemania
3
1
2
2
585
585
585
3
off
10
4
e
l
b
a
h
s
a
w
5
6
5
11
8 h
7
e
l
b
a
h
s
a
w
9
8
on
trim
clean
w
a
s
h
a
b
l
w
a
s
h
a
b
l
e
e
English
IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliance, basic precautions should
always be followed, including the following:
Read all instructions before using this appliance.
DANGER
To reduce the risk of electric shock:
1. Do not reach for an appliance that has fallen into water.
Unplug immediately.
2. Do not use while bathing or in a shower.
3. Do not place, store or charge the appliance where it can
fall or be pulled into a tub or sink. Do not place in or drop into water
or other liquid.
4. Except when charging, always unplug this appliance from
the electrical outlet immediately after using.
5. Unplug this appliance before cleaning.
6. Your shaver is provided with a low voltage adapter. Do not
exchange or manipulate any part of it.
FOR HOUSEHOLD USE
SAVE THESE INSTRUCTIONS
6
WARNING
To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Close supervision is necessary when this appliance is used by, on, or near
children.
2. Use this appliance only for its intended use as described in this manual.
Do not use attachments not recommended by the manufacturer.
3. The shaver should never be exposed to temperatures of less than 32°F /
0°C and more than 105°F / + 40°C for longer than a few hours. Except
when cleaning, keep shaver and cord dry at all times. Do not handle with
wet hands. Do not store in a damp environment. To avoid damage do not
wind the cord around the appliance.
It is important to check the cord for damage periodically particularly at each
end where the cord enters the plug.
4. Never operate this appliance if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into
water. Return the appliance to a service center for examination and repair.
5. Keep the cord away from heated surfaces.
6. Never drop or insert any object into any opening.
7. Never operate the appliance with the air openings blocked or while on a
soft surface, such as a bed or couch where the air openings may be
blocked. Keep the air openings free of hair, lint and the like.
8. Do not use outdoors or operate where aerosol (spray) products are being
used or where oxygen is being administered.
9. Do not clean the unit with volatile chemicals such as benzine or thinner
because they can damage the finish. To clean the unit, wipe with a cloth
dampened with a mild detergent or water, then wipe clean with a dry cloth.
10. Do not use this appliance with a damaged or broken foil, as serious facial
injuries may occur.
11. Always attach plug to appliance first, then to outlet.
To disconnect, turn all controls to «off», then remove plug from outlet.
12. This product is for household use.
7
Technical specifications
Wattage via low voltage adapter:
4 W, input voltage 120 V ac / 50-60 Hz
dropped below 20%, provided the
shaver is switched on. The remaining
capacity will then be sufficient for 1 to
2 shaves.
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Foil frame
5 Release buttons
6 Long hair trimmer
7 Central switch
8 Low charge light
9 Charging light
10 Shaver socket
11 Low voltage adapter
Charging the shaver
• Via the low voltage adapter, connect
the shaver to an electrical outlet with
the motor switched off. Charge for at
least 8 hours (adapter and shaver
might get warm). Once the shaver is
completely charged, shave until fully
discharged. Then recharge to full
capacity again.
•A full charge will give up to 25
minutes of cordless shaving time
depending on your beard growth.
However, the maximum battery
capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature
range for charging is
15°C to 35°C.
60 °F to 90 °F/
Indicator lights
• The green charging light shows that
the shaver is being charged.
• The red low charge light will come on
when the battery capacity has
8
Shaving
Turn on the shaver («on»).
Trimmer («trim»): When the long hair
trimmer is activated, it allows the
controlled trimming of moustache or
sideburns.
Tips for the perfect shave
• We recommend that you shave
before washing, as the skin tends to
be slightly swollen after washing.
• Hold the shaver at right angles (90°)
to the skin. Stretch your skin and
shave against the direction of beard
growth.
• To ensure optimum shaving performance, we recommend to replace the shaver foil and cutter
block every 18 months, or when
the parts are worn.
Keeping your shaver in top
shape
Before cleaning, always unplug the
shaver.
Cleaning under running water
After each shave, turn on the shaver
and clean it under running hot water.
Occasionally use soap (natural based
liquid soap without particles and
abrasive substances). Then rinse off all
foam and let the shaver run for another
moment.
Brush cleaning
Instead of cleaning under running water,
you may clean your shaver with a dry
brush: turn the shaver off, remove the foil
frame and, using the brush provided,
clean the cutter block and the area
below the cutter block. To clean
underneath the long hair trimmer, push
the switch to «clean».
Do not clean the shaver foil with the
brush.
General cleaning
About every four weeks, clean the cutter
block with Braun cleaning agents.
Put a drop of light machine oil onto the
long hair trimmer and shaver foil.
Replacing the shaving parts
The shaver foil and cutter block are
precision parts that, in time, are subject
to wear. To exchange the shaver foil,
remove it from the foil frame as shown in
the illustrations. Lift the foil first on the
front side, then the back. Be careful that
you do not squeeze the foil too tightly
while removing or replacing.
Replace your shaver foil and cutter block
every 18 months and get a 25% better
shave.*
(Shaver foil and cutter block: part no.
585, availabe at your dealer or Braun
Service Centers)
*(Overall evaluation from Braun users
comparing their shave with new parts
and those used for 18 months.)
Preserving the batteries
• In order to maintain the optimum
capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months
approximately. Then recharge the
shaver to full capacity again.
• Do not expose the shaver to temperatures of more than 50°C or 122°F for
longer periods of time.
Environmental notice
This appliance is provided with nickelcadmium rechargeable batteries. To
protect the environment, do not dispose
of this appliance in the household waste
at the end of its useful life. Disposal can
take place at a Braun Service Center or
appropriate collection sites.
Subject to change without notice
Attention:
The EPA certified RBRC
Battery Recycling Seal on
the Nickel-Cadmium (NiCd ) battery indicates
Braun is voluntarily
participating in an industry program to
collect and recycle these batteries at the
end of their useful life, when taken out of
service in the United States or Canada.
The RBRC program provides a convenient alternative to placing used Ni-Cd
batteries into the trash or the municipal
waste stream, which may be illegal in
your area.
Please call 1-800-8-BATTERY for information on Ni-Cd battery recycling and
disposal bans/restrictions in your area.
Braun‘s involvement in this program is
part of our commitment to preserving
our environment and conserving our
natural resources.
9
FOR USA ONLY
2 year limited warranty
(foil and cutter block excluded)
Braun warrants this Braun shaver (except foil and cutter block) to be
free of defects in material and workmanship for a period of two years
from the date of original purchase.
If the shaver exhibits such a defect, Braun will, at its option, either
repair or replace it for the consumer without charge, provided the
consumer:
1. Returns the shaver, postage paid and insured, indicating
the reasons for returning it to: Shaver Service Department,
Braun U.S. Div., The Gillette Co., 400 Unicorn Park Drive, Woburn,
MA 01801-3376,
2. Submits proof of date of original purchase.
This warranty does not cover foils, cutter blocks or damage resulting
from accident, misuse, abuse, dirt, water, tampering, unreasonable
use, normal wear, servicing performed or attempted by unauthorized
service agencies or failure to provide reasonable and necessary
maintenance, including recharging.
ALL IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR
PURPOSE, ARE LIMITED IN DURATION TO 2 YEARS FROM DATE
OF ORIGINAL PURCHASE.
IN NO EVENT WILL BRAUN BE RESPONSIBLE FOR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS
PRODUCT. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or
exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have
other legal rights which vary from state to state.
or one of its authorized service centers.
10
Loading...
+ 18 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.