Braun 3-370CC User Manual

Series3
Stapled booklet, 105x148 mm, 32 p (incl. 8 p cover), 2/2c = HKS43N + black
S
S
e
e
390cc-4
r
e
s
r
i
e
s
3
3
+
Type 5411, 5412
www.braun.com
370cc-4 350cc-4
390cc-4
Braun Infolines
English 6
Русский 13
Українська 22
Braun GmbH Frankfurter Straße 145 61476 Kronberg/Germany www.braun.com
UK 0800 783 7010
IE 1 800 509 448
RU 8 800 200 20 20
UA 0 800 505 000
www.service.braun.com
92331049/VII-12 UK/RU/UA
1
+
3 9 0
c c
­4
S
e
r
i
e
s
3
S
e
r
i
e
s
3
2
3
r
i
e
e
s
r
i
e
e
S
s
S
3
3
4
+
5 6
+
11
390 370
7
8
3
9
0
cc-4
390
9
10
STOP
3
370 350
12
350
+
oil
A
+
90°
B
f ul
l
l
o c k
f u
ll
click!
4
•••
•••
1
2
l oc
k
l ock
C
l o c
k
1
2
new
3
4
•••
a
5
b
•••
c
-
+
new old
-
+
-
-
+
+
5
-
+
English
Our products are designed to meet the highest standards of quality, functio­nality and design. We hope you enjoy your new Braun Shaver.
Warning
Your shaving system is provided with a special cord set, which has an inte­grated Safety Extra Low Voltage power supply. Do not exchange or tamper with any part of it, otherwise there is risk of an electric shock.
Do not shave with a damaged foil or cord.
This appliance is not intended for use by children or persons with reduced physical or mental capabilities, unless they are given supervision by a person responsible for their safety. In general, we recommend that you keep the appliance out of reach of children. Children should be supervised to ensure that they do not play with the appliance.
Description
1 Foil & Cutter cassette 2 Long hair trimmer 3 Precision setting switch (« ») (390cc/370cc only) 4 On/off switch 5 Charging lights (green) 6 Low-charge light (red) 7 Cleaning light (yellow) 8 Replacement light for shaving parts 9 Shaver power socket 10 Special cord set 11 Travel pouch (390cc/370cc only) 12 Protective cap (350cc only)
Charging
The best environmental temperature for charging is between 15 °C to 35 °C. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time.
• Using the special cord set (10), connect the shaver to an electrical outlet with the motor switched off.
• When charging for the first time or when the shaver is not used for a few months, leave the shaver to charge continuously for 4 hours. Subsequent charges will take about 1 hour.
6
• A full charge provides up to 45 minutes of cordless shaving time depend­ing on your beard growth.
• Maximum battery capacity will only be reached after several charging/ discharging cycles.
• 5-minute quick charge (with the special cord set (10)) is sufficient for a shave.
• If the rechargeable batteries are discharged, necting the shaver to an electrical outlet via the special cord set.
Charging lights (5) The green charging lights show the charge status of the batteries. The green charging light blinks when the shaver is being charged or switched on. When the battery is fully charged, all green charging lights shine permanently, provided the shaver is connected to an electrical outlet.
Low-charge light (6) The red low-charge light flashes when the battery is running low. You should be able to finish your shave.
you may also shave by con-
A Shaving
Press the on/off switch (4) to operate the shaver (picture A). The flexible shaving foils automatically adjust to every contour of your face.
Long hair trimmer (2) To trim sideburns, moustache or beard, slide the long hair trimmer upwards.
Precision setting switch (« » ) (3) (390cc/370cc only) For precise handling in hard to shave areas (e.g. under the nose) slide the switch (3) to the right to position « ». The centre trimmer and one foil will be lowered.
Tips for the perfect shave
For best results, Braun recommends you follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your skin.
3. Stretch your skin and shave against the direction of your beard growth.
7
B Keeping your shaver in top shape
Cleaning indicator
Your shaver should be cleaned daily in the Clean&Renew, and certainly when the yellow cleaning light (7) shines constantly after shaving. If this is not done, the yellow light will go out after some time. The shaver’s electronics will then assume it has been cleaned manually and a new calculation of the time when the next cleaning is required will be started.
Automatic cleaning
Once the shaver is put into the Clean&Renew, it is cleaned automatically (see «C Clean&Renew»). Manual cleaning is recommended only when the Clean&Renew is not available, e. g. when travelling.
Manual cleaning
The shaver head is suitable for cleaning under running tap water. Warning: Detach the shaver from the power supply before cleaning the shaver head in water.
Regular cleaning ensures better shaving performance. Rinsing the shaver head under running water after each shave is an easy and fast way to keep it clean:
• Switch the shaver on (cordless) and rinse the shaver head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
• Next, switch off the shaver, remove the shaver Foil & Cutter cassette (1) and let it dry.
• If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer (2) and shaver Foil & Cutter cassette (1).
Alternatively, you may clean the shaver using a brush:
• Switch off the shaver. Remove the shaver Foil & Cutter cassette and tap it out on a flat surface.
• Using a brush, clean the inner area of the shaver head. However, do not clean the shaver Foil & Cutter cassette with a brush as this may damage it.
8
Replacement light for shaving parts/Reset
To maintain 100% shaving performance, replace the shaver Foil & Cutter cassette (1), when the replacement light for shaving parts (8) comes on (after about 18 months) or when worn. The replacement light will remind you during the next 7 shaves to replace the foil and cutter cassette. Then the shaver will automatically reset. After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for at least 5 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. The manual reset can be done at any time.
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. Then recharge the shaver to full capacity.
Environmental notice
This product contains rechargeable batteries. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection sites provided in your country.
C Clean&Renew
Braun Clean&Renew has been developed for cleaning, charging and storing your shaver. During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfils the lubrication needs of the shaver.
Clean your shaver daily in the Clean&Renew.
Important
• Only use the power supply cord set supplied with the shaver.
• In order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface. Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed.
9
Loading...
+ 19 hidden pages