Page 1
Series3
Stapled booklet, 120 x 170 mm, 32 pages, 2/2c = cyan + black
Type 5411, 5412
www.braun.com/jp
3090cc
3070cc
3050cc-R
3050cc-G
Page 2
23456
Page 3
Page 4
Page 5
Page 6
Page 7
3
0
9
0
c
c
S
3
S
3
S3
3
090cc
S
3
7
Page 8
8
Page 9
90°
S3
9
Page 10
10
S
3
S3
Page 11
111213
Page 12
Page 13
Page 14
1
2
14
Page 15
15
Page 16
•••
•••
3060
s
S3
306
0s
S3
30
60
s
S3
306
0
s
S3
3060s
S
3
a
•••
b
•••
c
16
Page 17
17
Page 18
18
3
S
Page 19
192021
Page 20
Page 21
1
3090cc
S3
2
3090cc
3070cc
3050cc
3
4
3090cc
S3
S3
3070cc
3050cc
S3
5
6
7
3090cc
8
3090cc
9
3070cc
11
10
3050cc
12
Page 22
A
S3
90°
22
B
S3
S3
Page 23
3
060s
S3
•••
•••
1
2
C
3060s
S3
3
0
6
0
s
S
3
30
60
s
S
3
1
2
3
4
5
3
0
6
0
s
S
3
a
•••
b
•••
c
23
Page 24
English
Our products are designed to meet the highest standards of quality, functionality and
design. We hope you enjoy your new Braun Shaver.
Read these instructions completely, they contain safety information. Keep them
for future reference.
Warnings
This appliance is suitable for cleaning under running tap water.
Detach the appliance from the power supply before cleaning it
with water.
This appliance is provided with a special cord set, which has an
integrated Safety Extra Low Voltage power supply. Do not exchange or
tamper with any part of it, otherwise there is risk of an electric shock.
Only use the special cord set provided with your appliance.
If the appliance is marked
492, you can use it with any
Braun power supply coded 492-XXXX.
Do not shave with a damaged foil or cord.
This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they have been given supervision or instruction concerning the safe use of the appliance and
understand the hazards involved. Children should not play with the
appliance. Cleaning and user maintenance should not be made by
children unless they are older than 8 years and supervised.
Clean&Charge Station
In order to avoid any leakage of the cleaning fluid, place the appliance
on a flat, stable surface. Do not tip, move suddenly or transport in any
way if a cleaning cartridge is installed.
Do not place the appliance in a mirror cabinet, nor store it over radiators,
nor place it on polished or lacquered surfaces. Do not expose to direct
sunlight.
The appliance contains highly flammable liquid. Keep it away from
sources of ignition. No smoking.
Keep out of reach of children. Do not refill cartridge. Use only original
Braun refill cartridge.
24
Page 25
Description
1 Foil & Cutter cassette
2 Long hair trimmer
3 Precision mode switch*
4 On/off switch
5 Charging lights (green)
6 Low-charge light (red)
7 Cleaning light (yellow)
8 Replacement light for shaving parts
9 Shaver power socket
10 Special cord set (design may differ)
11 Travel pouch*
12 Protection cap*
* not with all models
Charging
Recommended ambient temperature for charging is 5 °C to 35 °C. The battery may
not charge properly or at all under extreme low or high temperatures. Recommended
ambient temperature for shaving is 15 °C to 35 °C. Do not expose the shaver to
temperatures higher than 50 °C for extended periods of time.
• Using the special cord set (10), connect the shaver to an electrical outlet with the
motor switched off.
• When charging for the first time or when the shaver is not used for a few months,
leave the shaver to charge continuously for 4 hours.
• A full charge provides up to 45 minutes of cordless shaving time depending on your
beard growth.
• Shave without the cord. With normal use the shaver will be charged automatically
after every cleaning in the Clean&Charge Station (see «Clean&Charge Station (C)»).
• Maximum battery capacity will only be reached after several charging/discharging
cycles.
• 5-minute quick charge is sufficient for a shave.
• If the rechargeable batteries are discharged, you may also shave by connecting the
shaver to an electrical outlet via the special cord set.
Charging lights (5)
The green charging lights show the charge status of the batteries. The green charging
light blinks when the shaver is being charged or switched on.
When the battery is fully charged, all green charging lights shine permanently,
the shaver is connected to an electrical outlet.
Low-charge light (6)
The red low-charge light flashes when the battery is running low.
You should be able to finish your shave.
provided
25
Page 26
Shaving (A)
Press the on/off switch (4) to operate the shaver.
The flexible shaving foils automatically adjust to every contour of your face.
Long hair trimmer (2)
To trim sideburns, moustache or beard, slide the long hair trimmer upwards.
Precision mode switch
For precise handling in hard to shave areas (e.g. under the nose) slide the switch (3) to
the right to position . One foil will be lowered.
Tips for a perfect dry shave
For best results, Braun recommends you follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your skin.
3. Stretch your skin and shave against the direction of your beard growth.
(3)
Cleaning (B)
Regular cleaning ensures better shaving performance.
Cleaning indicator
Your shaver should be cleaned daily in the Clean&Charge Station, and certainly when the
yellow cleaning light (7) shines constantly after shaving. If this is not done, the yellow
light will go off after some time. The shaver’s electronics will then assume it has been
cleaned manually and a new calculation of the time when the next cleaning is required
will be started. During the cleaning process in the Clean&Charge Station the yellow light
will flash and will go off after approx. 4 hours when cleaning is finished.
Automatic cleaning
Once the shaver is put into the Clean&Charge Station, it is cleaned automatically (see
«Clean&Charge Station (C)»).
Manual cleaning
Cleaning under running water:
• Switch the shaver on (cordless). Rinse the shaver head and the precision mode
switch under hot running water until all residues have been removed. You may use
liquid soap without abrasive substances. Rinse off all foam and let the shaver run for
a few more seconds.
• Next, switch off the shaver, remove the Foil & Cutter cassette (1) and let it dry.
• If you regularly clean the shaver under water, then once a week apply
a drop of light machine oil (not included) onto the long hair trimmer (2) and
Foil & Cutter cassette (1).
Cleaning with a brush:
• Switch off the shaver. Remove the Foil & Cutter cassette and tap it out on a flat surface.
• Using a brush, clean the inner area of the shaver head. However, do not clean the
Foil & Cutter cassette with a brush as this may damage it.
26
Page 27
Keeping your shaver in top shape
Replacement light for shaving parts/Reset
• To maintain 100% shaving performance, replace the Foil & Cutter cassette (1), when
the replacement light for shaving parts (8) comes on after about 18 months or when
worn.
• The replacement light will remind you during the next 7 shaves to replace the
Foil & Cutter cassette. Then the shaver will automatically reset.
• After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for
at least 5 seconds to reset the counter.
• While doing so, the replacement light blinks and goes off when the reset is complete.
The manual reset can be done at any time.
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the shaver has
to be fully discharged by shaving every 6 months approximately. Then recharge the
shaver to full capacity.
Environmental notice
Product contains batteries and/or recyclable electric waste.
For environment protection do not dispose of in household waste, but for
recycling take to electric waste collection points provided in your country.
Clean&Charge Station (C)
The Braun Clean&Charge Station has been developed for cleaning, charging and storing
your shaver.
During the automated cleaning process, the shaver is switched on and off at intervals
to obtain best cleaning results. Since the specially formulated cleaning fluid contains a
small amount of oil, the cleaning procedure also fulfils the lubrication needs of the
shaver.
Description
1 Start/release button
2 Contact bow
3 Lift button for cartridge exchange
4 Level indicator
5 Cleaning cartridge
Before using the Clean&Charge Station
Installing the cartridge
• Press the lift button (3) to open the housing.
• Hold the cartridge down on a flat, stable surface (e.g. table). Carefully remove the lid
from the cartridge. Slide the cartridge into the base as far as it will go.
• Slowly close the housing by pushing it down until it locks.
27
Page 28
Replacing the cartridge
• After having pressed the lift button to open the housing, wait for a few seconds before
removing the used cartridge.
• Before discarding the used cartridge, make sure to close the openings using the lid of
the new cartridge, since the used cartridge will contain contaminated cleaning solution.
• The used cartridge can be disposed in the household waste.
Operating your Clean&Charge Station
• Connect your Clean&Charge Station with the cord set to the mains electricity supply.
The special socket at the back is adjustable to save space. After each shave, switch
the shaver off and put it into the Clean&Charge Station, upside down and with the
front showing. Important: The shaver needs to be dry and free from any foam or
soap residue!
• Push the start/release button (1) to lock and connect the shaver. The cleaning
process will start. The yellow light on the shaver will flash during the complete
process (approx. 2 minutes cleaning, min. 4 hours drying).
• Do not interrupt the cleaning process, as it leaves the shaver wet and not fit for use.
If interruption is needed nonetheless, press the start/release button (1).
• When cleaning is finished, the yellow light will go off. To release it, push the start/
release button.
• A cleaning cartridge should be sufficient for about 30 cleaning cycles. When the
level indicator (4) has reached the « » mark, the remaining fluid in the cartridge is
sufficient for about 5 more cleaning cycles. Then the cartridge should be replaced,
when used daily approx. every 4 weeks.
• The hygienic cleaning cartridge contains ethanol or isopropanol (specification see
cartridge), which once opened will naturally evaporate slowly. Each cartridge, if not
used daily, should be replaced after approximately 8 weeks to ensure optimal
desinfection.
• The cleaning cartridge also contains lubricates, which may leave residual marks on
the shaver head after cleaning. However, these marks can be removed easily by
wiping gently with a cloth or soft tissue paper.
• Clean the housing from time to time with a damp cloth, especially the opening where
the shaver rests.
Accessories
Available at your dealer or Braun Service Centres:
• Foil & Cutter cassette: 32S/32B
• Cleaning cartridge Clean&Charge Station: CCR
Environmental notice
Product contains batteries and/or recyclable electric waste.
For environment protection do not dispose of in household waste, but for
recycling take to electric waste collection points provided in your country.
Subject to change without notice.
For electric specifications, see printing on the special cord set.
28
Page 29
Japan/UK
97247721/I-15
Loading...