Braun 3030s, 3020s, 3000s, 3000BT User Manual

Series33
Stapled booklet, 120 x 170 mm, 32 pages (incl. 8 pages cover), 2/2c = Cyan + black
91684241/IX-17
Type 5415, 5413 Modèle 5415, 5413 Modelo 5415, 5413
www.braun.com
3030s 3020s 3000s 3000BT
Braun Infolines Lignes d’assistance Braun Líneas de información de Braun
English 6
Français 16
Español 24
Thank you for purchasing a Braun product. We hope you are completely satisfied with your new Braun product. If you have any questions, please visit www.service.braun.com or call: US residents 1-800-BRAUN-11 1-800-272-8611 Canadian residents 1-800-387-6657
Merci d’avoir fait l’achat d’un produit Braun. Nous espérons que vous serez entièrement satisfait de votre nouveau produit Braun. Si vous avez des questions, veuillez visiter www.service.braun.com ou appeler Braun Canada : 1-800-387-6657
Gracias por haber comprado un producto Braun. Esperamos que quede completamente satisfecho con su nuevo producto Braun.
EN/FR/ES
3000BT + BT32
BT32
1
1
2
2
10
S3
3000
BT
3
3
5
1
7
7
3
3030s 3020s
1
2
3020s
3030s
3
S3
S3
3000s 3000BT
S3
4 5
6
3030
s
9
7
8
4
S3
90°
S
S
3
3
5
English
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the following:
Read all instructions before using this appliance.
When disconnected, the hand-held part of this shaving appliance may be cleaned under water.
DANGER
To reduce the risk of electric shock:
1. Use only in dry condition.
2. Do not submerge in water.
3. Do not reach for an appliance that has fallen into water. Unplug immediately.
4. Do not use while bathing or in a shower.
5. Do not place, store or charge the appliance where it can fall or be pulled into a tub or sink. Do not place in or drop into water or other liquid.
6. Except when charging, always unplug this appliance from the electrical outlet immediately after using.
7. Unplug this appliance before cleaning.
8. This appliance is provided with a special cord set with integrated Safety Extra Low Voltage power supply. Do not exchange or manipulate any part of it.
9. Do not use an extension cord with this appliance.
6
WARNING
To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Close supervision is necessary when this appliance is used by, on, or near children or persons with disabilities.
2. Use this appliance only for its intended use as described in this
manual. Do not use attachments not recommended by the manufacturer.
3. Never operate this appliance if it has a damaged cord or plug, if it is
not working properly, if it has been dropped or damaged, or if the power supply has been dropped into water. Return the appliance to a service center for examination and repair.
4. Keep the cord away from heated surfaces.
5. Never drop or insert any object into any opening of the appliance.
6. Do not use outdoors or operate where aerosol (spray) products are
being used or where oxygen is being administered.
7. Do not use this appliance with a damaged or broken foil / trimmer head /
attachment, as serious skin injuries may occur.
8. Always attach plug to appliance first, then to outlet. To disconnect,
turn all controls off, then remove plug from outlet.
9. When plugging to an electrical outlet outside North America, use a
plug adapter to match the outlet’s pin configuration.
10. Caution: The battery used in this device may present a fire or
chemical burn hazard if mistreated. Do not disassemble, heat above 100 °C (212 °F), or incinerate.
11. To recharge the battery, only use the detachable power supply
provided with this appliance. If the appliance is marked 492-XXXX, only use Braun power supplies coded 492-XXXX.
SAVE THESE INSTRUCTIONS
7
This product is for household use only.
Description
1 Foil & Cutter cassette 2 Long hair trimmer* 3 On/off switch 4 Charging lights (green) 5 Low-charge light (red) 6 Replacement light for shaving parts 7 Shaver power socket 8 Special cord set (design can differ) 9 Protection cap 10 Beard trimmer head with 5 combs (BT32)*
* not with all models
Charging
Recommended ambient temperature for charging is 41 °F to 95 °F / 5 °C to 35 °C. The battery may not charge properly or at all under extreme low or high temperatures. Recommended ambient temperature for shaving is 60 °F to 95 °F / 15 °C to 35 °C. Do not expose the shaver to temperatures higher than 122 °F / 50 °C for extended periods of time.
Using the special cord set (8), connect the shaver to an electrical outlet with the
motor switched off.
When charging for the first time or when the shaver is not used for a few months,
leave the shaver to charge continuously for 4 hours.
Once the shaver is completely charged, discharge the shaver through normal use.
Then recharge to full capacity. Subsequent charges will take about 1 hour.
A full charge provides up to 45 minutes of cordless shaving time depending on your
beard growth. Maximum battery capacity will only be reached after several charging/ discharging cycles.
5-minute quick charge is sufficient for a shave.
If the rechargeable batteries are discharged, you may also shave by connecting the
shaver to an electrical outlet via the special cord set.
Charging lights (4) The green charging light shows the charge status of the batteries. The green charging light blinks when the shaver is being charged or switched on. When the battery is fully charged, the green charging light shines permanently, provided the shaver is connected to an electrical outlet.
Low-charge light (5) The red low-charge light flashes when the battery is running low. You should be able to finish your shave.
Shaving
Press the on/off switch (3) to operate the shaver. The flexible shaving foils automatically adjust to every contour of your face.
8
Long hair trimmer (2) To trim sideburns, moustache or beard, slide the long hair trimmer upwards.
Tips for a perfect dry shave
For best results, Braun recommends that you follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your skin.
3. Stretch your skin and shave against the direction of your beard growth.
Cleaning
Regular cleaning ensures better shaving performance. Cleaning under running water:
Switch the shaver on (cordless). Rinse the shaver head under hot running water until
all residues have been removed. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
Next, switch off the shaver, remove the Foil & Cutter cassette (1) and let it dry.
If you regularly clean the shaver under water, then once a week apply a drop of light
machine oil (not included) onto the long hair trimmer (2) and Foil & Cutter cassette (1).
Cleaning with a brush:
Switch off the shaver. Remove the Foil & Cutter cassette and tap it out on a flat
surface.
Using a brush, clean the inner area of the shaver head. However, do not clean the Foil
& Cutter cassette with a brush as this may damage it.
Keeping your shaver in top shape
Replacement light for shaving parts / Reset
To maintain 100% shaving performance, replace the Foil & Cutter cassette (1), when the replacement light for shaving parts (6) comes on after about 18 months or when worn. The replacement light will remind you during the next 7 shaves to replace the Foil & Cutter cassette. Then the shaver will automatically reset. After you have replaced the Foil & Cutter cassette (1), press the on/off switch (3) for at least 5 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. The manual reset can be done at any time.
Accessories
Foil & Cutter cassette: 32S/32B Styling attachment for Series 3 shavers*: BT32
* Fits all Series 3 shavers with Foil & Cutter cassette 32S/32B
(Types 5416/5415/5414/5413/5412/5411)
9
Loading...
+ 20 hidden pages